D-Link DIS-5024T User Guide

r

DIS-5024T

D-Link 24-Port

10/100/1000Mbps + 2 Combo

Mini GBIC Gigabit

Smart Switch

Before Your Begin

This Quick Installation Guide gives step-by-step instructions for setting up the D-Link
DIS5024T Gigabit Smart Switch. The model you have purchased may appear slightly
different from those shown in the illustrations. For more detailed information about the
switch, its components, making network connections and technical specifications,
please refer to the User’s Manual on master CD included with your switch.

Check Your Package Contents

These are the items included with your DIS-5024T purchase:

• DIS-5024T

D-Link 24-Port 10/100/1000Mbps + 2 Combo
Mini GBIC Gigabit Smart Switch

• CD-ROM (containing Manual and Utility
Installation)

• 100–240VAC 50/60Hz

Power Adapter

If any of the above items are missing, please contact your reseller.

Using a powe
supply with a
different voltage rating
will damage and void
the warranty for this
product.

©2006 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of their respective
holders. Software and specifications subject to change without notice.

Setup The DIS-5024T Gigabit Smart
Switch

The setup of the Switch can be performed using the following steps:
A. Install the DIS-50

Specification for the acceptable operation temperature and humidity
ranges.

B. Install the DIS-5024T in a site free from strong electromagnetic

field generators (such as motors), vibration, dust, and direct
exposure to sunlight.

C. Leave at least 10cm (about 4 inches) of space at the front and rear

of the hub for ventilation.

D. Visually inspect the DC power jack and make sure that it is fully

secured to the power adapter.

E. Install the DIS-5024T on a sturdy, level surface that can support

its weight, or in an EIA standard-size equipment rack.

F. When installing the Switch on a level surface, attach the rubber feet

to the bottom of each device. The rubber feet cushion the hub and
protect the hub case from scratching.

24T in a fairly cool and dry place. See Technical

Attach the adhesive rubber pads to the bottom

Rack Mounting

The DIS-5024T can be mounted in an EIA standard-size, 19-inch rack,
which can be placed in a wiring closet with other equipments. Attach the
mounting brackets to both sides of the Switch (one at each side), and
secure them with the provided screws.

Use the screws provided. Then, use screws provided with the

equipment rack to mount the Switch in the rack.

2

Mount the Switch in the rack

Connecting Network Cable

The DIS-5024T supports 10/100/1000Mbps Gigabit Ethernet. It runs
full/half duplex transfer mode for 10/100Mbps and full duplex transfer
mode for 1000Mbps. Each port on the DIS-5024T supports Auto­MDI/MDI-X. Auto-MDI/MDI-X is a feature that eliminates the need for
worrying about using either a standard or crossover cable—you can
use either one—and allows any port to be an uplink port.

AC Power

The DIS-5024T can be used with AC power supply 100~240V AC,
50~60Hz. The power switch is located at the rear of the unit adjacent to
the AC power connector and the system fan. The switch’s power supply
will adjust to the local power source automatically and may be turned on
without having any or all LAN segment cables connected.

Connect The DIS-5024T Gigabit
Smart Switch To Your Network

Front Panel

10/100/1000 Base-T Mini GBIC Ports

Twisted-Pair Ports

┌────────────────────────┐ ┌──┐

└────────┘

LED Indicators

3