dji Matrice600 Series User Manual
MATRICE 600 SERIES
Remote Controller Channel Expansion Kit
遥控器通道扩展组件
User Guide
使用说明
V1.0 2016.12
Disclaimer
Congratulations on purchasing your new DJITM product. The
information in this document affects your safety and your legal
rights and responsibilities. Read this entire document carefully to
ensure proper conguration before use. Failure to read and follow
instructions and warnings in this document may result in serious
injury to yourself or others, damage to your DJI product, or damage
to other objects in the vicinity. This document and all other collateral
documents are subject to change at the sole discretion of DJI.
By using this product, you hereby signify that you have read this
disclaimer and warning carefully and that you understand and
agree to abide by the terms and conditions herein. You agree that
you are solely responsible for your own conduct while using this
product, and for any consequences thereof. You agree to use
this product only for purposes that are proper and in accordance
with all applicable laws, rules, and regulations, and all terms,
precautions, practices, policies and guidelines DJI has made and
may make available.
DJI accepts no liability for damage, injury or any legal responsibility
incurred directly or indirectly from the use of this product. The user
shall observe safe and lawful practices including, but not limited to,
those set forth in this document.
Notwithstanding above, your statutory rights under applicable
national legislation are not affected by this disclaimer.
DJI is a trademark of SZ DJI TECHNOLOGY CO., LTD. (abbreviated
as “DJI”) and its afliated companies. Names of products, brands,
etc., appearing in this document are trademarks or registered
trademarks of their respective owner companies. This product and
document are copyrighted by DJI with all rights reserved. No part of
this product or document shall be reproduced in any form without
prior written consent of or authorization from DJI.
Warning
1. Ensure that each of the knobs / switches is in its safe position
before powering on the remote controller.
2. Ensure that all the at cables inside the module are connected
correctly and securely.
3. Ensure that the remote controller rmware is up to date.
4. Connect the CAN cable of the expansion module and make sure
5. None of the channels is mapped on delivery. Channel mapping
TM
your DJI GO
app is up to date so that the module rmware can
be updated when updating the remote controller rmware.
must be completed in the “Tools” page of DJI ASSISTANT
TM
2.
Introduction
The MATRICETM 600 Series Remote Controller Channel Expansion
Kit is compatible with the DJI Matrice 600 series remote controller
and includes eight knobs/switches. More control functions will be
available after channel mapping in DJI Assistant 2.
Overview
Channel Expansion Module
2
1
3
4 5
1. S1 - S8 Knob / Switch
S1, S2, S7, S8 are knobs, S3, S6 are 3-position switches, and
S4, S5 are spring-loaded switches.
2. Status LED
Solid Green: Functioning normally.
Solid Red: Check if the at cables inside the RC port module are
connected correctly and the RC rmware is up to date.
LED Off: RC is powered off; if RC is powered on, check if the
CAN cable is in good condition and securely connected.
3. CAN Cable
4. Horizontal Slots
5. Vertical Slots
Loading...