dji Matrice 210 V2 User Manual

MATRICE 210 V2
Single Upward Gimbal Connector
User Guide
使用说明
2019.04v1.2
Disclaimer and Warning
Congratulations on purchasing your new DJITM product. The information in this document affects your safety and your legal rights and responsibilities. Read this entire document
carefully to ensure proper conguration before use. Failure to read and follow instructions
and warnings in this document may result in serious injury to yourself or others, damage to your DJI product, or damage to other objects in the vicinity. This document and all other collateral documents are subject to change at the sole discretion of DJI.
By using this product, you hereby signify that you have read this disclaimer and warning carefully and that you understand and agree to abide by the terms and conditions herein. You agree that you are solely responsible for your own conduct while using this product, and for any consequences thereof. You agree to use this product only for purposes that are proper and in accordance with all applicable laws, rules, and regulations, and all terms, precautions, practices, policies and guidelines DJI has made and may make available.
DJI accepts no liability for damage, injury or any legal responsibility incurred directly or indirectly from the use of this product. The user shall observe safe and lawful practices including, but not limited to, those set forth in this document.
Notwithstanding above, your statutory rights under applicable national legislation are not affected by this disclaimer.
DJI is a trademark of SZ DJI TECHNOLOGY CO., LTD. (abbreviated as “DJI”) and its afliated
companies. Names of products, brands, etc., appearing in this document are trademarks or registered trademarks of their respective owner companies. This product and document are copyrighted by DJI with all rights reserved. No part of this product or document shall be reproduced in any form without prior written consent of or authorization from DJI.
Introduction
The Single Upward Gimbal Connector is used to mount a compatible camera to the top of the MATRICETM 210 V2 / Matrice 210 RTK V2 aircraft. Its design gives it an IP43 Ingress Protection (only when equipped with a waterproof camera), in accordance with the global IEC 60529 standard. The ZENMUSETM X4S, X5S, X7, XT, XT2, Z30 and DJI Payload SDK products are supported.
In the Box
Single Upward Gimbal Connector × 1 M2.5×14.2 Screw × 8 H2.0 L-type Wrench × 1
Installation
1. Place the single upward gimbal connector on the top of the aircraft, make sure that the four screw holes align with the upward gimbal mounting position on the aircraft.
2. Use the wrench to tighten the screws to ensure that the single upward gimbal connector is securely mounted.
3. Connect the single upward gimbal connector to the aircraft’s DGC2.0 gimbal connector I.
Loading...
+ 4 hidden pages