ZPY10
|
ZPY 1…ZPY 200 (1.3 W) |
Silicon-Power-Z-Diodes |
Silizium-Leistungs-Z-Dioden |
(non-planar technology) |
(flächendiffundierte Dioden) |
Dimensions / Maße in mm
Maximum power dissipation |
1.3 W |
Maximale Verlustleistung |
|
Nominal Z-voltage – Nominale Z-Spannung |
1…200 V |
Plastic case |
DO-41 |
Kunststoffgehäuse |
DO-204AL |
Weight approx. – Gewicht ca. |
0.4 g |
Plastic material has UL classification 94V-0 |
|
Gehäusematerial UL94V-0 klassifiziert |
|
Standard packaging taped in ammo pack |
see page 16 |
Standard Lieferform gegurtet in Ammo-Pack |
siehe Seite 16 |
Standard Zener voltage tolerance is graded to the international E 24 (~5%) standard. Other voltage tolerances and higher Zener voltages on request.
Die Toleranz der Zener-Spannung ist in der Standard-Ausführung gestuft nach der internationalen Reihe E 24 (~5%). Andere Toleranzen oder höhere Arbeitsspannungen auf Anfrage.
Maximum ratings and Characteristics |
|
|
Grenzund Kennwerte |
|
Power dissipation – Verlustleistung |
T |
= 50 C |
P |
1.3 W 1) |
|
A |
|
tot |
|
Non repetitive peak power dissipation, t < 10 ms |
TA = 25 C |
PZSM |
40 W |
|
Einmalige Impuls-Verlustleistung, t < 10 ms |
|
|
|
|
Operating junction temperature – Sperrschichttemperatur |
|
|
Tj |
– 50...+150 C |
Storage temperature – Lagerungstemperatur |
|
|
TS |
– 50...+175 C |
Thermal resistance junction to ambient air |
|
|
R |
< 45 K/W 1) |
Wärmewiderstand Sperrschicht – umgebende Luft |
|
|
thA |
|
|
|
|
|
|
Thermal resistance junction to lead |
|
|
RthL |
< 15 K/W |
Wärmewiderstand Sperrschicht – Anschlußdraht |
|
|
|
|
Zener voltages see table on next page – Zener-Spannungen siehe Tabelle auf der nächsten Seite
1) Valid, if leads are kept at ambient temperature at a distance of 10 mm from case
Gültig, wenn die Anschlußdrähte in 10 mm Abstand vom Gehäuse auf Umgebungstemperatur gehalten werden 2) Tested with pulses – Gemessen mit Impulsen
3) The ZPY 1 is a diode, operated in forward. The cathode, indicated by a ring, is to be connected to the negative pole. Die ZPY 1 ist eine in Durchlaß betriebene Einzelchip-Diode.
Die durch den Ring gekennzeichnete Kathode ist mit dem Minuspol zu verbinden.
212 |
28.02.2002 |