Z2 SMB 1 … Z2 SMB 200 (2 W)
Surface mount Silicon-Zener Diodes |
Flächendiffundierte Si-Zener-Dioden |
(non-planar technology) |
für die Oberflächenmontage |
|
|
Dimensions / Maße in mm
Maximum power dissipation |
2 W |
Maximale Verlustleistung |
|
Nominal Z-voltage – Nominale Z-Spannung |
1…200 V |
Plastic case |
~ SMB |
Kunststoffgehäuse |
~ DO-214AA |
Weight approx. – Gewicht ca. |
0.1 g |
Plastic material has UL classification 94V-0 |
|
Gehäusematerial UL94V-0 klassifiziert |
|
Standard packaging taped and reeled |
see page 18 |
Standard Lieferform gegurtet auf Rolle |
siehe Seite 18 |
Standard Zener voltage tolerance is graded to the international E 24 (~5%) standard. Other voltage tolerances and higher Zener voltages on request.
Die Toleranz der Zener-Spannung ist in der Standard-Ausführung gestuft nach der internationalen Reihe E 24 (~5%). Andere Toleranzen oder höhere Arbeitsspannungen auf Anfrage.
Maximum ratings and Characteristics |
|
|
Grenzund Kennwerte |
|
Power dissipation – Verlustleistung |
T |
= 25 C |
P |
2 W 1) |
|
A |
|
tot |
|
Non repetitive peak power dissipation, t < 10 ms |
TA = 25 C |
PZSM |
40 W |
|
Einmalige Impuls-Verlustleistung, t < 10 ms |
|
|
|
|
Operating junction temperature – Sperrschichttemperatur |
|
|
Tj |
– 50...+150 C |
Storage temperature – Lagerungstemperatur |
|
|
TS |
– 50...+175 C |
Thermal resistance junction to ambient air |
|
|
R |
< 60 K/W 1) |
Wärmewiderstand Sperrschicht – umgebende Luft |
|
|
thA |
|
|
|
|
|
|
Thermal resistance junction to terminal |
|
|
RthT |
< 15 K/W |
Wärmewiderstand Sperrschicht – Anschluß |
|
|
|
|
Zener voltages see table on next page – Zener-Spannungen siehe Tabelle auf der nächsten Seite
1) Mounted on P.C. board with 50 mm2 copper pads at each terminal
Montage auf Leiterplatte mit 50 mm2 Kupferbelag (Lötpad) an jedem Anschluß 2) Tested with pulses – Gemessen mit Impulsen
3) The Z2SMB 1 is a diode operated in forward. Hence, the index of all parameters should be “F” instead of “Z”. The cathode, indicated by a white band is to be connected to the negative pole.
Die Z2SMB 1 ist eine in Durchlaß betriebene Si-Diode. Daher ist bei allen Kennund Grenzwerten der Index “F” anstatt “Z” zu setzten. Die mit weißem Balken gekennzeichnete Kathode ist mit dem Minuspol zu verbinden.
202 |
28.02.2002 |