VGA SPLITTER 1×2 with audio
USER MANUAL
Table of Contents
1.0 Introduction……………………………………………………..2
2.0 Specifications…………………………………….………..……2
3.0 Package Contents………………………………………….…..3
4.0 Panel Descriptions…………………………………….…….…3
5.0 Connection and Operation..................................................3
１
VGA SPLITTER 1×2 with audio
VGA SPLITTER 1×2 with audio
1.0 INTRODUCTION
This product is an VGA splitter 1x2 with audio. It distributes the input of the VGA
signal and stereo audio signal into the two identical outputs simultaneously. This
product has the ability of buffering and amplifying. Each amplifier splitter’s output
can achieve long distance transmission of VGA signal of up to 15 meters.
This VGA Splitter offers solutions for monitors or projectors retail and show site,
and Projector factory, noise, space and security concerns, data center control,
information distribution, conference room presentation, school and corporate
training environments.
1.1 FEATURES
This VGA Splitter has many features that enable it to perform in a superior
manner. Among those features you will find:
Easy to Use: Install in seconds, no need of setting.
Connects VGA source to two VGA displays at the time.
Connects stereo audio source to two audio receivers at the time.
Supports highest video resolution up to 1920 x 1200 and 1080p
Supports highest video Amplifier Bandwidth to 500MHz
2.0 SPECIFICATIONS
Signal Inputs/Output
Input video Signal 1.2 volts p-p
Maximum Single Link Range 1920X1200,1080p
Operating Frequency
Vertical Frequency Range 30-170 Hz
Video Amplifier Bandwidth 500MHz
Input/Output connector
Input VGA 15pin male
Output VGA 15pin female
Mechanical
Size(L-W-H) 120x71x24.5mm
Weight(Net) 250g
Environmental
Operating Temperature
Operating Humidity 10% to 85 % RH (no condensation)
Storage Temperature
Storage Humidity 5% to 90 % RH (no condensation)
Power Requirement
External Power Supply 5V DC@2A
0℃ to +70℃
-10℃ to +80℃
２
Power consumption (Max) 5W(max)
3.0 PACKAGE CONTENTS
1) Main unit
2) 1.8M VGA cable(M-F)
3) 5V/2A DC Power Supply.
4.0 PANEL DESCRIPTIONS
VGA SPLITTER 1×2 with audio
5.0 CONNECTION AND OPERATION
1) Connect the supplied VGA cable(M-F) from VGA device into VGA input of the
main unit.
2) Connect stereo audio cable(M-M) from audio device into the audio input of the
main unit.
3) Connect the VGA cable(M-M) from your displays into the VGA output of the
main unit
4) Connect stereo audio cable(M-M) from audio receiver into the audio output of
the main unit.
5) Insert the DC side of 5v power supply into the main unit and then connect the
AC side of the power supply into the wall outlet.
*please refer to the connection diagram section.
Attention: Insert / Extract cable gently.
３
5.1 CONNECTION DIAGRAM
VGA SPLITTER 1×2 with audio
P/N4005
４
Loading...