UHF Wireless Guitar Transmitter and Receiver
With 6.5mm Mono Plug
User Manual
Specifications:
Transmitter:
Frequencies: CH1: 520.5MHz
CH2: 532.9MHz
Freq stability: 0.002%
Range: 60m max
Receiver:
Sensitivity: 2µV (12dB)
Signal/noise: 90dB
Dimensions: 115(W) x 80(D) x 25(H) mm
Flyout:
1. Telescopic Antenna
2. 3 x LED Indicators
3. Channel Selector
4. Power Input
5. Audio Output
6. On/Off Switch
7. Transmit Volume
8. Battery Compartment
9. LED Indicator
Installation and Operation (Receiver)
For best results, the receiver should be placed at least 1m off the ground, and should
not be placed directly in front of the speaker system.
- Position the receiver on a stable platform and attach the AC adaptor.
- Plug one end of the provided lead into the AF output connector of the
receiver, and the other end to the input jack of your amplifier or PA system.
- Plug the power adaptor into a suitable electrical wall socket and turn the
power on.
- Select the channel you would like to use.
Installation and Operation (Transmitter)
- Open the battery compartment, insert 1 x AAA battery and close the battery
cover.
- Plug the transmitter plug into your instrument and turn the power switch
on.
- The signal level indicator on the receiver should now light up indicating that
the signal is being received. It will only light up for a few seconds.
- Adjust your instrument and amplifier controls to the desired volume and
tone.
- Please ensure you select the same channel (CH1 or CH2) as the receiver on
the transmitter.
- When finished, turn the power switch off before removing from the
instrument.
Loading...