Digital Watchdog Megapix DWC-MV421TIRB, Megapix DWC-MV421TIR, Megapix DWC-MV421DB, Megapix DWC-MV421D User Manual

Loading...

Quick Start Guide

--DWC MV421D

--DWC MV421TIR

 

 

DWC-MV421DB

DWC-MV421TIRB

 

 

Default Login Information

 

Username: admin

Password: admin

 

 

WHAT’S IN THE BOX

 

QSG Manual

1 Set

Star Driver

1 Set

Test Video

1 Set

Screw & Plastic

1 Set

Cable

Anchor – 4pcs

 

 

Template Sheet

1 Set

DC Plug Cable

1 Set

Hexagonal

1 Set

 

 

Wrench

 

 

 

 

 

Attention: This document is intended to serve as a quick reference page for initial set-up. It is recommended that the user read the entire instruction manual for complete and proper camera usage.

Tel: +1 (866) 446-3595 / 813-888-9555

digital-watchdog.com

Technical Support Hours:

9:00AM – 8:00PM EST, Monday thru Friday

Quick Start Guide

Step 1 – PREPARING TO MOUNT THE CAMERA

1.The mounting surface must bear five times the weight of your camera.

2.Do not let the cables get caught in improper places or the electric line cover to be damaged. This may cause a breakdown or fire.

3.For the installation process, remove the junction box and dome cover from the camera module. To remove the camera dome, loosen the three (3) screws on the dome using the wrench provided with the camera. To remove the junction box, loosen the three (3) screws on the camera module using the driver provided with the camera.

4.Using the mounting template sheet or the camera’s junction box, mark and drill the necessary holes in the wall or ceiling.

5.Secure the junction box to the mounting surface.

Step 2 – CABLING THE CAMERA TO EXTERNAL DEVICES

6.Pass the wires through the mount bracket and make all necessary connections.

a.NETWORK CONNECTIONS – If you are using a PoE Switch, connect the camera using an Ethernet cable for both data and power.

b.NETWORK CONNECTIONS – If you are using a non-PoE switch, connect the camera to the switch using an Ethernet cable for data transmission and use a power adapter to power the camera.

Power Requirements

Power Consumption

 

 

DC 12V

LED Off: 7.2W, 600mA

PoE IEEE 802.3af / PoE Class 3

LED On: 8.64W, 720mA (IR models)

 

 

Template

1

Sheet

4

5

2

NETWORK

CONNECTION

POWER

Step 3 – INSTALLING THE CAMERA

7.Secure the camera module to the junction box using three (3) screws.

8.Use the camera’s 3-Axis gimbal to adjust the camera’s tilt and angle. The camera’s maximum tilting angle is 75° (90° for non-IR models).

9.Assemble the dome cover over the camera body and detach the protecting film from the dome bubble.

3

Reset

Button

Resetting the camera: To reset the camera, use the tip of a paper clip or a pencil and press the reset button. Pressing the button for five (5) seconds

will initiate a camera-wide reset of all the settings, including network settings.

+ 1 hidden pages