Digital Watchdog DWC-P20CM2 User Manual
Quick Start Guide
Ceiling Mount Bracket for Dome Cameras
DWC-P20CM2
WHAT’S IN THE BOX
Ceiling Mount
Bracket
NOTE Download All Your Support Materials and Tools in One Place
1. Go to: http://www.digital-watchdog.com/support-download/
2. Search your product by entering the part number in the ‘Search by Product’ search bar. Results for applicable part numbers will
populate automatically based on the part number you enter.
3. Click ‘Search’. All supported materials, including manuals, Quick Start Guides (QSG), software and rmware will appear in the results.
Attention: This document is intended to serve as a quick reference for initial set-up.
It is recommended that the user read the entire instruction manual for complete and proper installation and usage.
Tel: +1 (866) 446-3595 / (813) 888-9555
Technical Support Hours: 9:00AM – 8:00PM EST, Monday thru Friday
1 Set QSG Manual 1 Set
digital-watchdog.com
INSTALLING THE MOUNTING ACCESSORY
Quick Start Guide
A. Attach the mount base ( ) and plate ( ) to the ceiling or wall using the supplied M6 tapping
screws ( ) and plastic bushings ( ).
3
1
2
4
B. Wind Teon tape around both threaded ends of the pipe (about 20 times) for sealing. If necessary,
use a silicone rubber sealant to seal the area where the mount base and the pipe meet.
C. Fit the pipe (of which threads are covered by Teon tape) into the mount base ( ) and turn until it
1
is securely fastened.
D. Pull all the required cables through the mount base ( ) and pipe ( ).
E. Align the dome adaptor ( ) with the pipe and turn until it is securely fastened.
F. Fasten the mount base ( ), dome adaptor ( ) using the set screw.
6
1
6
1
G. Fasten the vandal proof dome housing to the dome adaptor ( ) using M6 x 12 machine screw.
5
6
How to install the plate
Without Junction Box
2
1
4
1
With Junction Box
2
1
5
6
Junction Box
3
Cable
Cable
Specications Dimensions (mm)
1. Cable passing through the wall 2. Cable on the wall (Remove the conduit
Plate
Mount
Base
Cable
3. Cable passing through the
wall with the junction box
(Attention to the plate side)
knockout for cable passing through)
Plate
Mount
Base
Cable
Knockout
Plate
Mount
Base
Cable
Junction
Box
Mount Base
Seal ar ound the mou nt base
tightly using silicon rubber
Rev Date: 02/17
Specications and pricing are subject to change without notice.
Copyright © Dig ital Watc hdog. Al l rights reser ved.
Loading...