DIGI-STAR Cab Control 3400, Cab Control 3600 Operating Manual

D3820-US Rev B June 21, 2013

Cab Control

Operators Manual

Ft. Atkinson, Wisconsin USA

Pa s

www.digi-star.com

Cab Control 2400

Cab Control 3400

Cab Control 3600

nningen, The Netherland

Cab Control

2

Table Of Contents

BEFORE CHARGING BATTERY OR WELDING ...................................... 3

OPERATION .............................................................................................. 4

TURN ON INDICATOR .................................................................... 4

COMMUNICATE WITH DIFFERENT TRUCK ................................. 4

SETTING UP INDICATOR ......................................................................... 5

SETTING UP THE CAB CONTROL .......................................................... 6

INSTALLATION .......................................................................................... 7

CAB CONTROL MOUNTING ........................................................... 7

CAB CONTROL CONNECTION ...................................................... 7

FCC NOTIFICATIONS ............................................................................... 8

Operators Manual

D3820-US 3

BEFORE CHARGING BATTERY OR

WELDING

Important Precaution

Disconnect all indicator leads before charging battery or welding.
Damage may occur to indicator.

Note: All illustrations are the EZ3600 Cab Control. Keys used in this

document are in same general location on all models.

If power supply low, recharge
battery – turning off and lo pwr
will display.

Recharg

Note: If lo bat displayed,
indicator power (not Cab Control)
is low.