Denver TFD-1506DVBT User Manual

Table of Contents

Specifications Installation Important Safety Instruction

Warnings and Cautions Functional Parts(TV) Functional Parts(DVD)

Rear view of TV set

Setup

Remote Control Operation

MENU Screens

Inital Settings(DVD)

5-7

12-15

16-17 18-19

Getting started

Basic operation

DVD Setting menu

Media manage

DVB menu DVB Convenient functions

System setting Game

20-22 23-27

29 30-33 34-35

SPECIFICATIONS

Receiving System:

Colour System:

LCD Panel:

Ext.Antenna:

Ext. In/Out:

Speaker:

Audio Output:

Power Consumption:

B/G, D/K, I, L/L

PAL, SECAM

391mm(15.4inch) diagonal

75 Ohm Coaxial Cable

PC Input, SCART IN

8 Ohm x 2

AC 110-240V 50/60Hz,60W

Dimension:

Net Weight:

W385 xD180 xH371(mm)

4KG

Note:Design and specifications are subject to change without prior notice.

REMOTE CONTROL

Transmitting System :Infrared

Power Supply :DC 3V

OPEN/CLOSE POWER

-/---/--

VIEW

SCAN

TTX FAV

REPEAT

MUTE TV/AV/DVD

PROG+

VOL-

PROG-

STOP

REVEAL SIZE

TEXT

INDEX

ANGLE PBC

TITLE

MENU PROGRAMSUBTITLE

EPG

ENTER

A-B

SETUP

RADIO

EXIT

P.PP.P

SWAPSWAP

PG-TV

VOL+

DVB/DVD

MIX

SUB.PAGE

ZOOM

AUDIO

DISPLAY

INSTALLATION

Thank you very much for your purchase of this product, the most natural Colour Television Receiver. To enjoy your set to the full from the very beginning, read this manual carefully and keep it handy for ready reference.

INSTALLATION

Locate the receiver in the room where direct light does not strike the screen.

Total darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing.

Allow enough space between the receiver and the wall to permit ventilation. Avoid excessively warm locations to prevent possible damage to the cabinet or premature component failure.

This TV operates on a DC supply provided by the AC-DC adaptor. The voltage is as Indicated on the label on the back cover.Only use the AC-DC adaptor supplied with the TV and never apply an AC mains to the TV directly. The AC-DC adaptor operates on and AC mains supply, the voltage is as indicated on the label of the AC-DC adaptor. Connect the DC plug of the AC-DC adaptor to the DC 12V socket at the back of the TV. Connect the AC-DC adaptor and its mains cord. Insert the mains plug in the wall socket having a mains voltage of 110-240V. Do not install the receiver in a location near heat sources such as radiator, air ducts, direct sunlight ,or in a place somewhere like close compartment and close area.

Do not cover the ventilation openings when using the set.

CAUTION

Never tamper with any components inside your set, or any other adjustment controls not mentioned in this manual. The LCD panel used in this product is made of glass. Therefore,it can break When the product is dropped or applied with impact. Be careful not to be injured by broken glass pieces in case the LCD panel breaks.When you clean up dust or stick of a water drop on the LCD panel. The power cord should be pulled out from the plug receptacle, then wipe the receiver with dried soft cloth .During thunder and lighting , unplug the power cord and antenna cord to prevent your TV set from damage. All television receivers are high voltage instruments. All "inside work" on your receiver should be performed only by the TV service personnel.

If some abnormal phenomena happens , may be you have some mis-opertion,please take off power and restart your TV set .

IMPORTANT SAFETY INSTRUCTION

WARNING

RISK OF ELECTRIC SHOCK

DO NOT OPEN

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lighting flash with arrow head within a triangle is intended to tell the user that parts inside the product are a risk of electric shock to persons.

The exclamation point within a triangle is intended to tell the user that important operating and servicing instructions are in the papers with the appliance.

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT EXPOSE THIS

APPARATUS TO RAIN OR MOISTURE AND OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHOULD NOT BE PLACED ON THIS APPARATUS.

The power cable/disconnect device shall remain easy to operate/disconnect.

WARNINGS AND CAUTIONS

Do not drop or push objects into the television cabinet slots or openings. Never spill any kind of liquid on the television receiver.

Do not insert anything in the ventilation holes. If metal or something flammable enters, it may result in fire or electric shock.

Caution

Do not place objects on this unit, it may damage the screen surface.

Caution

Do not squash power supply cord under the television receiver.

Caution

Do not throw anything at the set. The screen glass may explode by impact and cause serious injury.

WARNINGS AND CAUTIONS

Never stand on, lean on, or suddenly push the television or its stand. You should pay special attention to children. Serious injury may result if it should fall.

Do not place your television on an unstable cart , stand , shelf or table. Serious injury to an individual, and damage to the television, may result if it should fall.

Caution

When the television receiver is not used for an extended period of time, it is advisable to disconnect the AC power cord from the AC outlet .

Caution

Do not block the ventilation holes in the back cover. Adequate ventilation is essential to prevent failure of electrical component.

Warning

Avoid exposing the television receiver to direct sunlight and other source of the heat. Do not stand the television receiver directly on other produces which give off heat .E.g.video cassette players. Audio amplifiers. Do not place naked flame sources, such as lighted candle on the television. Do not expose the LCD screen surface to the sun, it may damage the screen surface.

WARNINGS AND CAUTIONS

Take care not to connect many appliances to the same mains socket as this could result in fire or electric shock.

High voltages are used in the operation of this television receiver. Do not remove the cabinet back from your set. Refer servicing to qualified service personnel.

Warning

To prevent fire or electrical shock hazard, Do not expose the television receiver to rain or moisture.

Warning

For you own safety, Do not touch any part of the set, main lead or aerial lead during lighting storms.

Caution

If the television is to be built into a Compartment or similarly enclosed, the minimum distances must be maintained. Heat build-up can reduce the service life of your television, and can also be dangerous.

FUNCTIONAL PARTS(TV)

Front View of LCD Set

9 8 7 6 5 4 3

V- V+ P- P+ MENU TV/DVD

1 2

STANDBY

1. LED indicator lamp

2. Remote Sensor

3. Standby Button

4. TV/DVD Button

5. MENU Button

6. P+ Button

7. P- Button

8. V+Button

9. V- Button

To turn the TV power ON Put the TV set on the correct place, then connect the DC plug of the AC-DC adaptor to the DC 12V socket at the back of the TV set. Connect the adaptor main cord to the wall outlet ,then the LED indicator lamp turns red/blue and the TV set is at Standby/work Mode. At Standby Mode, if Standby Button is pressed the power indicator will change to blue. It takes a few seconds before the picture appears.

To turn the TV power OFF Press the Standby Button to make the TV set in Standby Mode, then disconnect the power plug from the wall outlet.

NOTE If TV is the selected input without signal received and NO operation is performed for about 5 minutes continuously, the TV set will enter standby mode. For any inputs other than TV, the TV set will not enter standby mode automatically without users instruction. If you are not going to use this TV set for a long time, switch off the set and disconnect the power plug from the wall outlet.

FUNCTIONAL PARTS(DVD)

2 7

3 4

5 6

1. DVD Slot

Repeat

Forward Skip

Reverse Skip

Play/Pause

Stop

Open/Close

Switch this LCD-TV Set to DVD status, insert the disk to DVD slot, and the player will suck it in.

Notes:

1.Do not attach any seal or label to either side (the labeled side or the recorded side) of a disc.

2.Do not use irregularly shaped CDs (e.g., Heartshaped or octagonal)since they may result in malfunctions.

3.Some playback operations of DVDs and Video CDs may be intentionally programmed by software manufacturers. This unit plays DVDS and Video CDs according to disc content designed by the software manufacturer, therefore some playback features may not be available or other functions may be added.

REAR VIEW OF TV SET

DC IN 12V HEADPHONE PC IN FULL-SCART RF INPUT(ANT.)

TO DC IN 12V

TO POWER SOURCE

DC IN 12V

VGA

PC IN

AUDIO

Full-SCART

ANT .

NOTE

Precautions when connecting to other equipment

When using external equipment with this TV set, please read the instruction manual of the external equipment.

Switch off all power supplies to the equipment and TV set before connection.

Always ensure that the input and output terminals are correctly connected.

Installation

Power Source

Remote Control Battery Installation

Requires two AAA batteries(supplied).

Procedure

1. Turn the remote control face down. Remove battery cover by pressing down on the marking on the cover and sliding it off in the direction indicated.

2. Install batteries matching(+) and(-) polarity signs.

3. Replace the battery cover by sliding in reverse until the lock snaps. Note: Incorrect installation can cause battery leakage and corrosion that will damage the Remote control. Precautions Replace batteries in pair. Do not mix battery types(zinc carbon with alkaline). Do not recharge, heat, short-circuit, disassemble, or burn batteries.

4.If you cause a static discharge when touching the unit, and the unit fails to function, simply unplug the unit from the AC outlet, wait a few minutes, and plug it back in. The unit should return to normal operation.

TO USE AC POWER SOURCE

Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug into a standard 110-240V 50/60HZ polarized AC outlet.

NOTE:

1.This TV can be connected to the specified voltage (AC 110-240V, 50/60HZ).

2.If the polarized AC cord does not fit into a nonpolarized AC outlet, do not attempt to file or cut the blade. It is the users responsibility to have an electrician replace the obsolete outlet.

+ 27 hidden pages

Denver TFD-1506DVBT User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual