
WARM MIST HUMIDIFIER
HUMIDIFICATEUR À VAPEUR CHAUDE
WARMNEBEL-BEFEUCHTER
UMIDIFICATORE A VAPORE CALDO
WARME DAMP LUCHTBEVOCHTIGER
HUMIDIFICADOR EN CALIENTE
HUMIDIFICADOR EN CALIENTE
£∂ƒª√™ À°ƒ∞¡∆∏™
VANDFORDAMPER MED VARM DAMP
LUFTFUKTARE MED VARM ÅNGA
VANDFORDAMPER MED VARM DAMP
HÖYRYILMANKOSTUTIN
NAWIL˚ACZ Z GORÑCÑ PARÑ WODNÑ
1
Instructions for use
Mode d’emploi
Gebrauchsanweisung
Istruzioni per l’uso
Gebruiksaanwijzing
Instrucciones para el uso
Instruções para o uso
√‰ËÁ›Â˜ ¯Ú‹Û˘
Brugsanvisninger
Bruksanvisning
Brugsanvisninger
Käyttöohjeet
Instrukcja obs∏ugi

2
ELECTRICAL CONNECTION (UK ONLY)
A) If your appliance comes fitted with a plug, it will
incorporate a 13 Amp fuse. If it does not fit your
socket, the plug should be cut off from the mains
lead, and an appropriate plug fitted, as below.
WARNING: Very carefully dispose of the cut
off plug after removing the fuse: do not insert in
a 13 Amp socket elsewhere in the house as this
could cause a shock hazard.
With alternative plugs not incorporating a fuse,
the circuit must be protected by a 15 Amp fuse.
If the plug is a moulded-on type, the fuse cover
must be re-fitted when changing the fuse using a
13 Amp Asta approved fuse to BS 1362. In the
event of losing the fuse cover, the plug must NOT
be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that
as marked on the base of the plug.
B) If your appliance is not fitted with a plug, plea-
se follow the instructions provided below:
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Green and yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead may not
correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The green and yellow wire must be connected to the
terminal in the plug marked with the letter E or the earth
symbol or coloured green or green and yellow.
The blue wire must be connected to the terminal
marked with the letter N or coloured black.
The brown wire must be connected to the terminal
marked with the letter L or coloured red.