DeLonghi ICM8-18 User Manual
instructions
Coffee Maker
ICM8/18
Coffee Maker EC190/200
escription of the appliance
Electrical requirements
Before using this appliance ensure that the voltage indicated on the product
corresponds with the main voltage in your home, if you are in any doubt
about your supply contact your local electricity company.
Coffee Maker EC190/200
The flexible mains lead is supplied
connected to a B.S. 1363 fused plug
having a fuse of 13 amp capacity.
Should this plug not fit the socket
outlets in your home, it should be
cut off and replaced with a suitable
plug, following the procedure outlined below.
Note: Such a plug cannot be used
for any other appliance and should
therefore be properly disposed of
and not left where children might
find it and plug it into a supply socket - with the obvious consequent
danger.
N.B. We r ecommend the use of
good quality plugs and wall sockets
that can be switched off when the
machine is not in use.
important: the wires in the mains
lead fitted to this appliance are
coloured in accordance with the following code:
As the colours of the wires in the
mains lead of this appliance may not
correspond with the coloured
markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured green
and yellow must be connected to
the terminal in the plug which is
marked with the letter E or by the
earth symbol or coloured green
or green and yellow.
The wire which is coloured blue
must be connected to the terminal
which is marked with the letter N
or coloured black.
The wire which is coloured brown
must be connected to the terminal
which is marked with the letter L or
coloured red.
When wiring the plug, ensure that
all strands of wire are securely
retained in each terminal. Do not
forget to tighten the mains lead
clamp on the plug. If your electricity
supply point has only two pin socket outlets, or if you are in doubt,
consult a qualified electrician.
Should the mains lead ever require
replacement, it is essential that this
operation be carried out by a qualified electrician and should only be
replaced with a flexible cord of the
same size.
After replacement of a fuse in the
plug, the fuse cover must be refitted.
If the fuse cover is lost, the plug
must not be used until a replacement cover is obtained.The colour
of the correct replacement fuse
cover is that of the coloured insert
in the base of the fuse recess or
elsewhere on the plug.Always state
this colour when ordering a
replacement fuse cover.
Only 13amp replacement fuses
which are asta approved to B.S.
1362 should be fitted.
This appliance conforms to the
Norms EN 55014 regarding the
suppression of radio interference.
GREEN AND YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
WARNING - THIS APPLIANCE MUST BE EARTHED
Green and Yellow to
Earth
Blue to
Neutral
13 amp
Fuse
Brown
to Live
Cord Clamp
Loading...