Delonghi DCH6031.B Instruction manuals

IMPORTANT SAFEGUARDS

Danger!

Failure to observe the warning may result in life threatening
injury by electric shock.

- The appliance must not be placed im­mediately under a xed power socket.

- Do not use the appliance near show­ers, bathtubs, sinks, swimming pools,
etc.

- If the power cable is damaged, it must
be replaced by the manufacturer, an
authorised service centre or a qualied
electrician in order to eliminate all risk.

Important!

Failure to observe the warning could result in injury or
damage to the appliance.

- This appliance can be used by children
aged from 8 years and above and per­sons with reduced physical, sensory or
mental capabilities or lack of experien­ce and knowledge if they have been
given supervision or instruction con­cerning use of the appliance in a safe
way and understand the hazards in­volved. Children shall not play with the
appliance. Cleaning and user mainte­nance shall not be made by children
without supervision.

- Children of less than 3 years should be
kept away unless continuously super­vised.

- Children aged from 3 years and less
than 8 years shall only switch on/o
the appliance provided that it has been
placed or installed in its intended nor­mal operating position and they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understand the hazards
involved. Children aged from 3 years

and less than 8 years shall not plug
in, regulate and clean the appliance or
perform user maintenance.

CAUTION — Some parts of this

product can become very hot and
cause burns. Particular attention
has to be given where children
and vulnerable people are pre­sent.

- ATTENTION: To avoid the safety sy­stem resetting accidentally, this ap­pliance must not be powered through
an external on/o device such as a
timer, or connected to a circuit which
is turned o and on regularly by the
energy supplier.

- Do not use the appliance in small
rooms when they are occupied by
persons that are not capable of leaving
the room, unless constant supervision
is provided.

Danger of burns!!

Failure to observe the warning could result in burns or scalds.

- WARNING: To avoid overhe­ating, never under any cir­cumstances cover the appliance
during operation as this would lead to
a dangerous rise in temperature.

Please note:

This symbol indicates recommendations and important
information for the user.

- Always use the appliance in an upright position.

- The use of extension leads is not recommended.

However if they cannot be avoided, follow the instruc-

tions accompanying the extension lead and never
exceed the power limit marked on the extension.

- The heater must be positioned at least 50 cm from furni­ture or other objects.

- Do not use the appliance in rooms with a oor area of
less than 4m2.

- Before putting the appliance away, make sure it is com­pletely o and unplugged from the mains socket.

7

Do not store in dusty atmospheres.

- Do not rest anything on the appliance.

- Do not use the appliance to dry laundry. Do not obstruct
the air intake and outlet grilles (danger of overheating).

- Do not use the appliance near walls, furniture, curtains,
etc.

Safety functions

- Safety device: the appliance is tted with a safety
device which switches it o in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all). To reset,
unplug the appliance from the mains socket for a few
minutes, remove the cause of overheating then plug in
again. If the appliance doesn't work please contact the
De'Longhi Customer Service.

- Tip over safety device: a tip over safety device (D)
turns the appliance o if it falls over or is positioned
inappropriately in such a way as to jeopardise safety.

When the appliance is placed back in a vertical position

it starts again automatically.

Disposing of the appliance

The appliance must not be disposed of with hou­sehold waste, but taken to an authorised waste se­paration and recycling centre.

Operation and use

1. Make sure the selector (A) is in the “0” position before
plugging the appliance into the mains socket.

2. Plug into the mains socket.

3. Turn the appliance on by placing the thermostat (B) in
the Max position and the mode selector (A) in one of the
following positions: /1/2/3.

The following modes are available:

- Summer mode (fan only): turn the mode selec tor to the

position (the light comes on).

- Low power operation: turn the mode selector to posi­tion “1”.

- Medium power operation: turn the mode selector to
position “2”.

- High power operation: turn the mode selector to posi­tion “3”.

- To turn the appliance o: turn the mode selector to the
“0” position and the thermostat to the position, then
unplug from the mains.

Adjusting the thermostat

When the room has reached the required temperature, turn
the thermostat (B) slowly anticlockwise until you hear a
“click”. The thermostat will then keep room temperature at
the selected level automatically.

DESCRIPTION

(see g. 1)

A Mode selector
B Thermostat
C Indicator light
D Tip over switch
E Filter protection grille
F Filter

USE
Installation

The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same
socket for other appliances.

Electrical connection

- Before plugging into the mains, make sure the voltage
of your mains supply corresponds to the value V indica­ted on the appliance and that the socket and power line
are appropriate for the load required.

- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/
EC ON ELECTROMAGNETIC COMPATIBILITY.

Frost prevention mode

With the thermostat dial at minimum and the mode se­lector (A) on “3”, the appliance maintains room temperature
at about 5°C, preventing freezing with minimal energy con­sumption.

MAINTENANCE

- Always unplug from the mains socket before cleaning.

- During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacuum
cleaner.

- To clean the lter, remove the rear grille (E) by pulling
it outwards (g. 1). Remove the dust lter (F) which re­tains impurities in the air drawn in from the room, blow
on it lightly then replace in the appliance.

- Never use abrasive powders or solvents to clean the ap­pliance.

TECHNICAL CHARACTERISTICS

Supply voltage See rating plate
Absorbed power “

8