Volatile memory 64 x 16 Mbit
Part of Interface board
Part of Interface board
Non Volatile memory, 2Kbit, To
No Part of Interface board
Non Volatile memory, 2Kbit, To
Statement of Volatility – Dell U2713HM Monitor
CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the
problem.
The Dell U2713HM Flat Panel Monitor contains both volatile and non-volatile (NV) components. Volatile components lose
their data immediately after power is removed from the component. Non-volatile (NV) components continue to retain their
data even after power is removed from the component. The following NV components are present on the U2713HM system
board.
Table 1. List of Non-Volatile Components on System Board
Description
Serial flash
memory
25LD040
DP EDID
and HDCP
EEPROM
DDR 3
SDRAM
NT5CB64
M16DP
VGA
EDID
EEPROM
24C02
DVI EDID
EEPROM
24C02
Reference
Designator
Volatility Description
I308 Non Volatile memory, 4M
bites. To store firmware.
bites.
I309
in OFF state.
NOTE:
Buffer of video decoder
I316 Non Volatile memory, 2Kbit,
To store VGA EDID.
store DVI EDID.
Accessib le
for external
data
Remedial Action (Action
necessary to prevent loss of
data)
No Part of Interface board
assembly, software write
protected
assembly,
protected
assembly,
mechanism
hardware write
No write protect
No
assembly,
protected
assembly,
protected
hardware write
hardware write
EDID
EEPROM
24C02
CAUTION: All other components on the system board lose data if power is removed from the system. Primary power
loss (unplugging the power cord and removing the battery) destroys all user data on the memory (DDR3, 1067 MHz).
Secondary power loss (removing the on-board coin-cell battery) destroys system data on the system configuration
and time-of-day information.
August 2012
store HDMI EDID
assembly,
protected
hardware write