DATECS SUMUPAIRLITE User Manual

1 DATECS

SumUp Air Lite v2

User Manual

1 DATECS SUMUP AIR LITE V2 USER MANUAL

2

THE INFORMATION IN THIS DOCUMENT CANNOT BE REPRODUCED IN ANY MECHANICAL, ELECTRICAL

OR ELECTRONIC WAY AND UNDER ANY CIRCUMSTANCES WITHOUT THE WRITTEN CONSENT FROM DATECS LTD.

Address: 4 Datecs Street, Sofia 1592, Bulgaria

Phone: [phone]

Fax: [phone]

E-mail: [e-mail]

1 DATECS SUMUP AIR LITE V2 USER MANUAL

REVISION HISTORY

Version

Data

Change description

1.0.0

31.01.2018

First Release

2.0.0

02.01.2020

Added Section “REGULATORY”

3

1 DATECS SUMUP AIR LITE V2 USER MANUAL

REGULATORY

FCC ID: YRW-SUMUPAIRLITE

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

• Consult the dealer or an experienced radio/TV technician for help.Caution: Any changes or
modifications to this device not explicitly approved by manufacturer could void your authority to
operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.

4

1 DATECS SUMUP AIR LITE V2 USER MANUAL

5

CONTENTS

TECHNICAL SPECIFICATIONS ................................................................................................................................................... 6

GENERAL VIEW ........................................................................................................................................................................ 7

GETTING STARTED ................................................................................................................................................................... 9

PERIODIC INSPECTION AND MAINTENANCE ........................................................................................................................ 10

OPERATION MODES .............................................................................................................................................................. 11

APPLICATION DOWNLOAD MODE, SYSTEM MODE AND CLEARING BLUETOOTH PARING INFO .................................................................. 11

STATUS LEDS ........................................................................................................................................................................ 11

BLUETOOTH PAIRING .............................................................................................................................................................. 13

MAGNETIC CARDS READING ..................................................................................................................................................... 15

CONTACTLESS CARDS READING .................................................................................................................................................. 16

SMART CARDS READING ........................................................................................................................................................... 17

CARE, MAINTENANCE AND WARRANTY................................................................ ................................ ............................... 18

SERVICE AND SUPPORT ......................................................................................................................................................... 18

1 DATECS SUMUP AIR LITE V2 USER MANUAL

6

TECHNICAL SPECIFICATIONS

Processor

ARM Cortex® M3 Security Microcontroller

Memory

64KB Internal ROM
256KB Internal RAM
1MB Internal Flash

Application Memory

4MB Serial Flash

Keypad

• ON / OFF key

Smart Card Reader

ISO7816, EMV L1 certified

Contactless Card Reader
for payment applications
(option)

• AMEX ExpressPay

• Discover D-PAS

• MasterCard Contactless

• VISA PayWave

Contactless Card Reader
(option)

ISO/IEC 14443 Type-A/MIFARE:

- MIFARE MINI

- MIFARE CLASSIC-1K, MIFARE CLASSIC-4K

- MIFARE ULTRALIGHT, ULTRALIGHT-C

- MIFARE PLUS 2K/4K

- MIFARE DESFire

- and others

ISO/IEC 14443 Type-B

- supports most of the cards
ISO/IEC 15693

- supports most of the cards
JIS X 6319-4

- compatible with FeliCa
Battery

Rechargeable lithium-ion battery 3.7V, 1300 mAh

Connectivity

• USB

- Device

• Bluetooth Low Energy 4.2

Audio indication

Electro-Magnetic Buzzer

OS compatibility

iOS, Android, Windows

Reliability

• 500 000 chip card cycles

• 1 000 000 magnetic card swipes

Certifications

CE, PCI PTS 5.1

Dimensions (LxWxH), mm

84 x 84 x 23

Weight, g

147

Environmental
Operating: -10oC to +40oC / 5 to 90% RH

Storage: -15oC to +50oC / 5 to 90% RH

Drop Test

1.5 m, 6 faces + 4 edges on concrete

Power Supply

• 5V through micro USB

* Specification can be change without any notice.

Use only original equipped DATECS cable USB-A to USB-B micro

Use only UL approved USB adapters. The minimum requirements of USB
adapter is 5V/1A.

Waste Electrical & Electronic Equipment
The symbol means that according to local laws and regulations your product

shall be disposed of separately from household waste at the end of its working
life. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, please separate this from other types of wastes
and recycle it responsibly to promote the sustainable reuse of material
resources.