Datavideo TBC-100 User Manual

Single Channel Full Frame 4:2:2 Time Base
Corrector
TBC-100 is specially designed for video processing with a PC. Most video camcorders do not produce stable synchronized signals. This can cause poor video image quality when capturing video to your PC. The TBC-100 corrects this problem by replacing all sync signals from the video source with new signals. By using a digital full frame synchronizer, the TBC-100 insures that your video captures are clear and clean.
Frame synchronization with full frame memory
Re-generates all synchronization signals to stabilize
the video
Compatible with all formats (VHS, S-VHS, VHS-C, S- VHS-C, Video 8 & Hi8)
Auto-detects NTSC or PAL format
Wide bandwidth- 4.5 MHz in Y/C and 3.5 MHz in
composite
8-bit video resolution – 4:2:2 sampling rate
DP less than 1 degree – DG less than 2%
Low noise – S/N ratio >50dB
Typical Installation
Installation with a Capture Card
Connection
1. If you connect both S-video and composite video sources to the TBC-100, the card will automatically default to S-video. For compo site video, you can not plug in an S-video input.
2. DC power input connector J601, use the enclosed “Pigtail” connector to connect the power source from PC power supply to the TBC- 100.
Pigtail Extension Connector (included)
3. TBC-100 apply both S-video and Composite vid eo outputs for either S-video or Composite video input .
Installation:
1. Turn off PC.
2. Disconnect power cord from PC.
3. Insert the TBC-100 into any PCI slot in your PC.
4. Use a “pigtail” connector to hook up the power connector from your PC power
supply to TBC-100 dual powe r input socket J601 (Label on card diagram). If you do not have an extra power supply, see your dealer or a qualified technician for assistance.
5. Install the video equipment as shown in installation diagram.
6. Since the TBC-100 is a stand alone circuit board, software is not required.
NOTE: The installation of the TBC-100 requires you to make a connection
To your PC’s power supply. If you are not sure how to do this, contact your dealer or a qualified technician for installation.
Specifications:
INPUTS
S (Y/C) Video & Composite Y/C in: 4—pin 75 ohm DIN connector Video Source Composite Video Out: 75 ohm RCA Connector, Level: 1.0 Vp-p
OUTPUTS
S (Y/C) Video & Compos ite Y/C out: 4—pin 75 ohm DIN c onnector Composite Video Source Composite Video Out: 75 ohm R CA
Connector, Level: 1.0 Vp-p/ unity
GENERAL
Frequency Response S-Video 4.5 MHz +/- 3dB DG, DP +/- 2 %, 1 S/N Ratio >50dB Component YUV 4:2:2 8-bit, Y: 13.5 MHz Correction Range Single Channel full frame TBC Video System PAL/NTSC system auto detect Power Requirement DC +5V/700mA & +12V/150mA Ambient Temperature 32 - 131 F (0 - 55 C) Ambient Humidity Less than 90% Accessories RCA & S-Video Cables Power Extension
Connector (Pigtail)
Loading...