Datamax ST-SV 3306, ST-SV 3210 User Manual
Connecting the
Printer
Turn off the printer before
connecting cables
!
Serial Port
USB Port
Parallel Port
AC Power Connector
Power On/Off Switch
ST/SV 3210 & ST/SV 3306
With USB
Quick Start
Guide
Serial Port
USB Port
Parallel Port
Controlling the
Printer
ONLINE Indicates the printer is ready to accept data.
FAULT Indicates no ticket stock is detected or that a
POWER Indicates that main power to the printer is ‘On.’
PAUSE / F1 Allows the operator to temporarily stop printing
FEED / F2 Allows the operator to advance the ticket stock to
TEST / F3 Allows the operator to print test tickets when the
mechanical malfunction has occurred.
(pause mode) or to enter off-line mode.
the next print position.
printer is in off-line mode.
Indicator Lights:
Buttons:
AC Power Connector
Power On/Off Switch
;
Note: More information
on the Front Panel can be
found in Section 3.4 of the
Operator’s Manual.
Asia-Pacific
19 Loyang Way
#01-01 CILC Building
Singapore 508724
Phone: +65 542-2611
Fax: +65 542-3611
For the latest products, news, and support visit
www.datamaxcorp.com
Corporate Headquarters
4501 Parkway Commerce Blvd.
Orlando, Fl 32808
Phone: 407-578-8007
Fax: 407-578-8377
Datamax International
12 Elizabeth Way, Pinnacles
Harlow, Essex CM19 5FE UK
Phone: +44 1279 772200
our web page at
Herbert House
Fax: +44 1279 424448
Loading
Ticket Stock
¾ ST Models only: Unlock the Access
Cover then lift to open (for
convenience, the cover may be
removed by sliding it forward and
then lifting up).
¾ Install Ticket Stock and insert it between the Media Guides.
¾ Adjust the Media Guides to fit the Ticket Stock, then tighten
the Thumbscrew to secure.
Printing a
Configuration
and Test
Pattern Ticket
¾ With the Power Switch turned ‘Off’ and ticket stock loaded, press and hold the FEED Button while turning
the Power Switch ‘On.’ Continue to depress the FEED Button until printing begins.
¾ After printing is complete, cycle the Power Switch ‘Off’ and ‘On’ to return the printer to the normal
operating mode.
;
Note: The printer maintains a selection of user-modifiable ticket setups, each with a specific print
width, start of print position, and cut/tear position. The default setting for these setups is Stock ID 5 (see
Section 4 of the Operator’s Manual for details).
¾ Turn ‘On’ the Power Switch.
¾ Slide the media through the Media Guides, continue until the
printer grabs the media and automatically completes the
loading process.
;
Note: When loading, ensure that the black marks on the
ticket stock face away from you. If the ticket stock does not
feed to the proper position, the Media Sensor may need
adjustment (see Section 4 of the Operator’s Manual for
instructions).
Be sure to follow and perform the
suggested cleaning schedule explained
in the Operator’s Manual.
Contacting Datamax…
Additional
Information
Corporate Headquarters (407) 578-8007
Technical Support (407) 523-5540
For the latest products, news, and
support visit our web page at
www.datamaxcorp.com
Loading...