Danfoss RAW 5010, RAW 5012 Data sheet

Data Sheet

Thermostatic Radiator Sensor, Type RAW

Application

RAW 5010 RAW 5012 with remote sensor

The raw series is a programme of radiator ther­mostats which covers all central and district heat­ing systems.

RAW is a self-acting proportional controller with a
small P-band.

RAW radiator thermostats are designed for use in
2-pipe domestic heating systems. They are equip­ped with snap connection.

The RAW sensor incorporates a frost protection
setting for maximum user flexibility, and provides
also the option to limit the temperature range.

The RAW desig is particularly robust, with both
End-Stop strength limits and sensor bending
force limits being substantially above the require­ments of the European Standard EN215.

Approved to EN 215

Coefficient de Variation

Thermostatic sensors RAW are manufac­tured to the highest standards, and are ap­proved to the European standard EN 215.

RAW 5010: Vt = 0,29 K

Temporelle

Ordering and Specifica­tions

Danfoss Heating Solutions VDIDD102 © Danfoss 02/2013 1

Type Version Colour
RAW 5010 Built-in sensor RAL 9016 8-28 °C 013G5010
RAW 5012

1)

Xp= 2K (the valve closes at 2 °C higher room temperature)

2)

The remote sensor is equipped with 2 m of ultra-thin capillary tube, which is coiled up within the

remote sensor housing. After sensor mounting capillary tube is pulled out to the required length.

Remote sensor 0-2 m

2)

Setting range

1)

Code no.

013G5012

*

10 14 18 22 26 30 °C

*

8 12 16 20 24 28 °C

1

2

3

4

5

. . . . . .

Data Sheet Thermostatic Radiator Sensor, Type RAW

Setting the Temperature

Mounting

The required room temperature is set by turning
the setting dial. The temperature scales show the
correlation between scale values and the room
temperature. The temperature values stated are
for guidance only as the obtained room tempera­ture will often be influenced by installation con­ditions.

The temperature scales are stated according to
European standards at Xp = 2°C. This means that

the radiator thermostats close at a sensor tem­perature which is 2°C higher than stated on the
temperature scales.

= Frost protection setting

Setting the upper and lower limit

The thermostat features two tabs with which the
temperature setting area can be decreased. If 4
should be max. setting, turn the thermostat to
max. position (3) and press and hold right tab
while turning the thermostat to 4 (3), now release
tab. With the left tab the lower temperature must
be turned to min. position (4).

The mounting of the sensor onto the valve is sim­ply and is carried out without the use of tools.
Place the sensor onto the valve and push and it
snaps onto the valve.

Removing the sensor, the ring back is to be
turned to activate the mechanisme again. How
to mount the sensor is described on the pack­agage of the product..

The snapp ring fixes the sensor automatically
onto the valve. The snapp mechnisme is active
ex works and ready for mounting.

2 VDIDD102 © Danfoss 02/2013 Danfoss Heating Solutions