INSTRUCTION
HOME Radiator Thermostat Bi-Directional valve with flowselectable feature
Installation of valve
The valve is a bi-directional valve and can be installed horizontally or vertically in either the flow or return pipe.
A built in flow direction selection feature can be used to eliminate the risk of water hammer.
Troubleshooting
In the unlikely event of water hammer being encountered turn the setting ring (see diagram 4) to the other setting. Alternatively if commissioning the whole system, establish the flow direction through each valve using the diagrams below.
If the flow direction needs to be changed there is no need to remove the valve, simply turn the setting ring.
1, Close all radiator valves by |
2, Start boiler/heating. |
3, Open one valve and deter- |
||
turning the valve cover cap |
|
mine flow direction. Which pipe |
||
clockwise. Leave system to cool. |
|
heats first? |
||
|
|
|
|
5, Repeat step 3 and 4 until all |
|
|
|
|
|
|
4, Remove cap and turn |
|
|
valves have been set correctly. |
|
|
|
Sensor may now be fitted or the |
|
|
setting ring according to |
|
|
|
|
|
|
valve cap temporarily refitted. |
|
|
the drawings. The setting |
|
|
|
|
|
|
|
|
|
ring is turned by hand |
|
|
|
|
only. |
|
|
|
|
Note: Maximum pressure |
|
|
|
|
drop should not exceed |
|
|
|
|
0.45 bar |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
© Danfoss HS | 2019.07| VIMQC202 | 013R9672 |
1 |
Installation Guide
Fitting the Sensor
1. The Danfoss snap-on mounting is easy to install and requires no use of tools.
2. When the sensor is in place, the snapon mechanism is activated and the sensor is mounted correctly.Tighten the coupling by turning the snap-on ring clockwise.
3. Set desired room temperature.
RemovingtheSensor
1. The sensor is removed by turning the snap-on ring counter-clockwise.
2.Before remounting the snap-on mechanism must be activated manually by turning the snapon ring counterclockwise.
User Guide
Setting the desired room temperatures
The desired room temperature is set by turning the head. The temperatures obtained are approximately:
Do not cover the thermostat
The thermostat opens and closes as determined by the temperature around it. Therefore the sensor must never be hidden behind thick curtains, furniture, etc. Alternatively a thermostat with remote sensor should be used.
Lockshield valve (type RLV-D) is only included in codes: 013G6545 & 013G6546.
Removal of protective cap
Balancing
Danfoss Limited
Heating Segment • heating.danfoss.co.uk • +44 (0)330 808 6888 • E-mail: customerservice.uk@danfoss.com
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on order provided that such alterations can be made without subsequential changes being necessary in speci cations already agreed.
All trademarks in this material are property of the respective companies. Danfoss and all Danfoss logotypes are trademarks of Danfoss A/S. All rights reserved.
© Danfoss HS | 2019.07| VIMQC202 | 013R9672 |
2 |