Daikin UAT150CGXY1, UAT180CGXY1, UAT240CGXY1, UAT300CGXY1, UAT150CGXY19 Installation manuals

...
INSTALLATION MANUAL
Model UAT150CGXY1 UAT180CGXY1 UAT240CGXY1 UAT300CGXY1 UAT150CGXY19 UAT180CGXY19 UAT240CGXY19 UAT300CGXY19
Rooftop Package Air Conditioner
English
IM-RTC-0712(0)-DAIKIN
Part No.: R08019037940
Model: UAT150C
OUTLINE AND DIMENSIONS
1390.0
1965.0
CONTROL
BOX
1988.0
652.0
652.0 684.0
150.0
855.0 142.0
1630.0 48.0
1251.0 497.0
1748.0
165.0
994.0
700.0125.0 50.0350.0
94.0
82.5
1800.0 82.5
1800.0
94.0
English
Original Instruction
CENTER OF GRAVITY
Model: UAT180C
CONTROL
1390.0
1965.0
BOX
652.0
652.0 684.0
1710.0
830.0
48.01630.0
412.0
994.0
82.5 1800.0 82.5
350.0 50.0
165
1988.0
CENTER OF GRAVITY
150.0
1251.0
1748.0
497.0
94.0 1800.0 94.0
125.0 700.0
1
Model: UAT240C
OUTLINE AND DIMENSIONS
1690.0
1965.0
CONTROL
BOX
1988.0
1076.0
150.0
456.0
456.0
1251.0
1981.0
1905.0
2021.0
1045.0
770.0
158.0
48.0
994.0
61.0
484.0
170
768.0
200
147.0
158.0
1672.0
147.0
158.01672.0
CENTER OF GRAVITY
Model: UAT300C
1650.0
2410.0
CONTROL
BOX
677.0 1076.0 677.0
2104.0
2030.0
1000.0
48.0
160.0
138.0
1215.0
2110.0 149.0151.0
407.0 88.0
768.0
2430.0
CENTER OF GRAVITY
150.0
1371.0 770.0
2141.0
2
245.0
2110.0 158.0162.0
INSTALLATION MANUAL
This manual provides the procedures of installation to ensure a safe and good standard of operation for the air conditioner unit. Special adjustment may be necessary to suit local requirements. Before using your air conditioner, please read this instruction manual carefully and keep it for future reference. This appliance is intended to be used by expert or trained users in shops, in light industry and on farms, or for commercial use by lay persons. This appliance is not intended for use by persons, including children, with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
SAFETY PRECAUTIONS
! WARNING ! CAUTION
• Installation and maintenance should be performed by qualified persons who are familiar with local code and regulation, and experienced with this type of appliance.
• All field wiring must be installed in accordance with the national wiring regulation.
• Ensure that the rated voltage of the unit corresponds to that of the name plate before commencing wiring work according to the wiring diagram.
• The unit must be GROUNDED to prevent possible hazard due to insulation failure.
• All electrical wiring must not touch the refrigerant piping, or any moving parts of the fan motors.
• Confirm that the unit has been switched OFF before installing or servicing the unit.
• Disconnect from the main power supply before servicing the air conditioner unit.
• DO NOT pull out the power cord when the power is ON. This may cause serious electrical shocks which may result in fire hazards.
• Keep the indoor and outdoor units, power cable and transmission wiring, at least 1m from TVs and radios, to prevent distorted pictures and static. {Depending on the type and source of the electrical waves, static may be heard even when more than 1m away}.
Please take note of the following important points when installing.
Do not install the unit where leakage of flammable gas may occur.
If gas leaks and accumulates around the unit, it
may cause fire ignition.
Ensure that drainage piping is connected
properly.
If the drainage piping is not connected properly,
it may cause water leakage which will dampen the furniture.
Do not overcharge the unit.
This unit is factory pre-charged. Overcharge will cause over-current or damage
to the compressor.
Ensure that the unit’s panel is closed after service
or installation.
Unsecured panels will cause the unit to operate
noisily.
Sharp edges and coil surfaces are potential
locations which may cause injury hazards.
Avoid from being in contact with these places.
Before turning off the power supply, set the remote controller’s ON/OFF switch to the “OFF” position to prevent the nuisance tripping of the unit. If
this is not done, the unit’s fans will start turning automatically when power resumes, posing a hazard to service personnel or the user.
Do not operate any heating apparatus too close to the air conditioner unit.
Don’t use joined and twisted wires for incoming
power supply.
The equipment is not intended for use in a potentially explosive atmosphere.
English
NOTICE
Disposal Requirement
Dismantling of the unit, treatment of the refrigerant, oil and other parts must be done in accordance with the applicable legislation.
3
Loading...
+ 11 hidden pages