Daewoo DTQ-14Q1FS User Manual

MODEL NO.

DTQ - 14Q1 / 20Q1 / 14Q2 / 20Q2 / 14Q1FS / 20Q1FS

14Q3 / 20Q3 / 14T1 / 20T1 / 14T1AS

14T2 / 20T2 / 14T3 / 20T3 / 21T1PS

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk electric shock.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and servicing instructions in the literature accompanying the appliance.

WARNING

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

NOTE TO CATV SYSTEM INSTALLER

THIS REMINDER IS PROVIDED TO CALL THE CATV SYSTEM INSTALLER'S ATTENTION TO ARTICLE 820-40 OF THE NEC THAT PROVIDES GUIDELINES FOR PROPER GROUNDING AND, IN PARTICULAR, SPECIFIES THAT THE CABLE GROUND SHALL BE CONNECTED TO THE GROUNDING SYSTEM OF THE BUILDING, AS CLOSE TO THE POINT OF CABLE ENTRY AS PRACTICAL.

CAUTION

To provide power to the TV, insert the AC plug into a standard 110/220V, 50/60Hz polarized outlet.

NOTE

If you feel a static discharge when touching the unit, and the unit does not function, simply unplug the unit from the outlet. When you plug the unit back in, it should work normally.

Do not install power cords near any heating element or cooking appliances.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK)

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

Table of Contents

Important Safeguards 2 Chapter 1: Overview of Your Equipment 4

Your TV's Front Panel 4 Your TV's Back Panel 5 Your Remote Control 6

Installing your remote control batteries 7 Notes 7

Chapter 2: Connecting an Antenna or Cable to Your TV 8

Connecting an Antenna 8 Connecting a Cable System 9 Connecting Other Pieces of Equipment 10 Safety Note 10

Chapter 3: Operating Your TV 11

Turning your TV On 11 Programming Your TV's Channel Memory 11 Changing Channels 13 Changing the Volume 13 Changing The TV's Channel Memory 13

Adding a channel to memory 13 Erasing a channel from memory 14

Changing the TV's channel memory with the menus 14 Changing the TV’s Input 15 Displaying the Current Channel 15 Adjusting Video Settings 16

Returning to factory settings 17

Descriptions of video settings 18

Chapter 4: Using Timer Functions 19

Accessing the Timer Menu 19 Setting the Clock 20 Setting the On Timer 21 Setting the Off Timer 22 Canceling the On Timer or Off Timer 22 Setting the Sleep Timer 23

Chapter 5 : Additional Features 24

Changing the Language of the On-Screen Menus 24 Captioning 24

About captions 25 Power restore 25 Changing the TV’s favorite channel memory with the menus 26 Automatic power off 26

Chapter 6 : Troubleshooting 27 Warranty 28

Table of Contents

CONTENTS

important safeguards

SAFETY

IMPORTANT SAFEGUARDS

PLEASE READ ALL THESE INSTRUCTIONS REGARDING YOUR TELEVISION EQUIPMENT AND RETAIN FOR FUTURE REFERENCE. FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE TV RECEIVER.

1 Read all of these instructions. 2 Save these instructions for later use. 3 Unplug this television equipment from the

wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

4 Do not use attachments not recommend-

ed by the television equipment manufacturer as they may result in the risk of fire, electric shock or other personal injury.

5 Do not use this television equipment near

water, for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, or the like.

6 Do not place this television equipment on

an unstable cart, stand, or table, The television equipment may fall, causing serious injury to a child or adult, and serious damage to the equipment. Use only with a cart or stand recommended by the manufacturer, or sold with the television equipment. Wall or shelf mounting should follow the manufacturer's instructions, and should use a mounting kit approved by the manufacturer.

6A An appliance and cart combination should

be moved with care. Quick stops, excessive force, and uneven surface may cause the appliance and cart combination to overturn.

7 Slots and openings in the cabinet and the

back or bottom are provided for ventilation and to ensure reliable operation of the television equipment; and to protect it from overheating, these opening, must not be blocked or covered. The opening should never be blocked by placing the television equipment on a bed, sofa, rug, or other similar surface. (This equipment should never be placed near or over a radiator or heat register.) This television equipment should not be placed in a builtin installation such as a bookcase unless proper ventilation is provided.

8 This television equipment should be oper-

ated only from the type of power source indicated on the marking label. If you are not sure of the type of power supplied to your home, consult your television dealer or local power company.

9 This television equipment is equipped

with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

10 Do not allow anything to rest on the pow-

er cord. Do not locate this television equipment where the cord will be abused by persons walking on it.

11 Follow all warnings and instructions

marked on the television equipment.

12 For added protection for this television

equipment during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the equipment due to lightning and power-line surges.

13 An outside antenna system should not be

located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

14 Do not overload wall outlets and exten-

sion cords as this can result in fire or electric shock.

15 Never push objects of any kind into this

television equipment through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the television equipment.

16 Do not attempt to service this television

equipment yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

17 Unplug this television equipment from the

wall outlet and refer servicing to qualified service personnel under the following conditions:

(a) When the power-supply cord or plug is

damaged or frayed.

(b) If liquid has been spilled, or objects

have fallen into the television equipment.

exposed to rain or water.

(d) If the television equipment does not

operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the TV receiver to its normal operation.

(e) If the television equipment has been

dropped or the cabinet has been damaged.

(f) When the television equipment exhibits

a distinct change in performance - this indicates a need for service.

18 When replacement parts are required, be

sure the service technician has used replacement parts specified by the manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.

19 Upon completion of any service or repairs

to this television equipment, ask the service technician to perform safety checks to determine that the television is in a safe operating condition.

20 If an outside antenna or cable system is

connected to the television receiver, be sure the antenna or cable system is grounded so as to provided some protection against voltage surges and built-up static charges.

Section 810 of the National Electrical Code, ANSI/NFPA N0.70-1984, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

important safeguards

ANTENNA LEAD IN WIRE

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

GROUNDING CONDUCTORS (NEC SECTION 810-20)

GROUND CLAMPS POWER SERVICE GROUNDING

ELECTRODE SYSTEM (NEC ART 250, PART H)

ELECTRIC SERVICE EQUIPMENT

NEC-NATIONAL ELECTRICAL CODE

GROUND CLAMP

EXAMPLE OF ANTENNA GROUNDING

Your TV comes with a remote control. The section below summarizes the buttons, controls, and terminals that you will use with your TV.

Your TV's Front Panel

1 POWER

Use this button to turn your TV on or off.

2 VIDEO IN jack

Use this jack to receive a video signal from another A/V component.

3 AUDIO IN jack

Use this jack to receive an audio signal from another A/V component.

4 EARPHONE IN jack

Use this jack to receive an audio signal from your TV.

5 STAND-BY (red) indicator

This indicator lights up when the power is off.

6 Remote control receiver

This receiver receives a signal from your remote control. Don’t block it.

7 WCHV

Use these buttons to change channels on your TV, or to select items in the menu system.

8 CVOLB

Use these buttons to change your TV’s volume, to activate selections in the menu system, or to change audio and video settings.

9 MENU

Use this button to turn the TV’s menu system on and off.

CHAPTER

Chapter 1 : Overview of Your Equipment

Overview of Your Equipment

POWER VIDEO AUDIO

STAND-BY

VOL

EARPHONE

Chapter 1 : Overview of Your Equipment

Your TV’s Back Panel

1 Antenna terminal (ANT)

Use this terminal to attach an antenna or cable system to your TV.

2 VIDEO IN

This terminal allows the TV to receive a video signal from another component, such as a VCR.

3 AUDIO IN

This terminal allows the TV to receive an audio signal from another component, such as a VCR.

ANT

VIDEO AUDIO

Chapter 1 : Overview of Your Equipment

1 POWER

Use this button to turn your TV on or off.

2 WCHV

Use these buttons to change channels on your TV, or select items in the menu system.

3 CVOLB

Use these buttons to change your TV's volume, to activate selections in the menu system, or to change audio and video settings.

4 MENU

Use this button to turn the TV's menu system on and off.

5 RECALL

Press this button to display the channel number.

6 ADD/ERA.

Use this button to add a channel to the TV's memory or erase the channel from memory.

7 MUTE

Use to turn the TV's sound on and off.

8 0-9

Use these buttons to change channels.

9 SLEEP

Use this button to program the TV to turn off after a certain time.

10 PREV. CH

Press this button to return to the previous channel you were watching. If you have set Favorite Ch, this key operates to Favorite function.

11 TV/VIDEO

Use this button to select TV or VIDEO mode.

12 AUTO. PICT

Press this button to return the TV's video settings to their original level.

13 AIR/CABLE

Use the button to set up your TV to receive signals from an antenna (AIR) or a cable system (CABLE).

Your Remote Control

5 6

Chapter 1 : Overview of Your Equipment

Installing your remote control batteries

1 Open the battery compartment on the back of the remote control. 2 Install two AAA-size batteries (not included) as shown. Make sure the “+” and “-”

terminals are oriented correctly.

3 Replace the cover.

Notes

Do not mix different types of batteries, or mix an old and a new battery. Remove and replace weak batteries. Weak batteries can leak and damage your con-

troller. Dispose of batteries properly; never throw them into a fire. Point your remote at the receiver on the center of the front of the TV. Make sure the

receiver is not blocked. The remote control can operate up to 30 feet away from the TV, if you are directly fac-

ing the front of the TV. Operating distance diminishes as you move to the sides of the TV

Your TV will provide you with the best performance if you connect it to an external antenna or cable system. Follow the directions below make this connection. Please note that you will normally only have to make one of the connections shown below, not all of them.

All connections will be made to the antenna terminal on the back of your TV. For help in locating the antenna terminal, see “Your TV's Back Panel” on page 5.

Connecting an Antenna

If your antenna ends in a single coaxial lead, simply press or screw the cable onto

the antenna terminal on the back of your TV.

If your antenna ends in a pair of 300 ohm twin leads, you must use a 300-ohm/75ohm adaptor. Place the leads underneath the screws on the adaptor, tighten the screws, then press the adaptor onto the antenna terminal on the back of the TV.

Connecting an Antenna or Cable to Your TV

CHAPTER

Chapter 2 : Connecting an Antenna or Cable to Your TV

+ 21 hidden pages