Dacor DO130 User Manual
DO
21 1/8”
(53.7 cm)
C
J
B
H
G
F
A
Chassis Notch
Side View
Control panel
front
Top of
chassis
Top of
chassis
Utility
cutout
¾” Conduit:
60” (152 cm)
long
K
L
M
E
D
Document # PG01 - 007 Revised 12/15/09 Page 1/2
Single, Distinctive
Product tolerances: ±1/16” (±1.6 mm) unless otherwise stated
Wall Oven
PLANNING
GUIDE
WARNING
Observe all governing codes and ordinances during planning •
and installation. Contact your local building department for
further information.
This appliance must be installed in accordance with the •
accompanying installation instructions.
Specications subject to change without notice.
Install all appliances according to accompanying installation instructions.
MODEL DO130
Cutout Width
(F) Utility
5”
(12.7 cm)
(A) Overall
Width
29 3/4”
(75.6 cm)
* To top of chassis notch behind control panel
(G) Utility
Cutout Height
5 ¼”
(13.3 cm)
** Two 120 Vac hot (L1 and L2), one neutral, one ground
The above specifications are for reference only. See the
appliance data plate for exact specifications.
(H) Utility
Cutout Depth
(15.2 cm)
Model
Number
DO130
(B) Chassis
Width
28 3/8”
(72.1 cm)
6”
Dedicated
Requirements
240 Vac 60 Hz.,
(C) Overall
(72.4 cm)
(J) Control
Panel Depth
Circuit
4-wire,**
30 Amp.
Height
28 7/16”
1”
(2.5 cm)
(D)* Chassis
Height
27 1/2”
(69.9 cm)
(K) Notch
Depth
1 5/8”
(4.1 cm)
Total Connected
Load
5.3 kW (23 Amp.)
www.Dacor.com Phone: (800) 793-0093
(E) Control
Panel
Overlay
15/16”
(2.4 cm)
(L) Chassis
Depth
24”
(61.0 cm)
(M) Notch
Height
1”
(2.5 cm)
1.9
DO
1 1/2”
(3.8 cm)
typical counter
1“ (2.5 cm) Min.
to combustible floor
3/4” (1.9 cm)
support platform
1“ (2.5 cm) Min. to combustibles
Recommended
electrical
location
4” typical toe kick
36”
(91.4 cm)
P
R
Recommended
electrical
location
Alternate
electrical
location
4” typical toe kick
N
P
R
3/4” (1.9 cm)
support platform
31 1/4” (79.4 cm)
recommended
1” (2.5 cm) Min.
to bottom of
cabinet door
1” (2.5 cm) Min.
to top of
cabinet door
Document # PG01 - 007 Revised 12/15/09 Page 2/2
Single, Distinctive
Wall Oven
Cabinet/countertop tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated
SINGLE WALL OVEN - INSTALLED UNDER COUNTER
PLANNING
GUIDE
SINGLE WALL OVEN - CUTOUT DIMENSIONS
Minimum Interior Cabinet Depth: 24” (61.0 cm)
Model Number
DO130
(N) Minimum
Cabinet
Width
30”
(76.2 cm)
(P) Minimum
Cut Out Width
28 ½”
(72.4 cm)
(R) Minimum
Cutout Height
27 5/8”
(70.2 cm)
Specications subject to change without notice.
Install all appliances according to accompanying installation instructions.
www.Dacor.com Phone: (800) 793-0093
1.10
Loading...