instructions
Coffee Maker
ICM8/18
Coffee Maker EC190/200
escription of the appliance
Electrical requirements
Before using this appliance ensure that the voltage indicated on the product
corresponds with the main voltage in your home, if you are in any doubt
about your supply contact your local electricity company.
Coffee Maker EC190/200
The flexible mains lead is supplied
connected to a B.S. 1363 fused plug
having a fuse of 13 amp capacity.
Should this plug not fit the socket
outlets in your home, it should be
cut off and replaced with a suitable
plug, following the procedure outlined below.
Note: Such a plug cannot be used
for any other appliance and should
therefore be properly disposed of
and not left where children might
find it and plug it into a supply socket - with the obvious consequent
danger.
N.B. We r ecommend the use of
good quality plugs and wall sockets
that can be switched off when the
machine is not in use.
important: the wires in the mains
lead fitted to this appliance are
coloured in accordance with the following code:
As the colours of the wires in the
mains lead of this appliance may not
correspond with the coloured
markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured green
and yellow must be connected to
the terminal in the plug which is
marked with the letter E or by the
earth symbol or coloured green
or green and yellow.
The wire which is coloured blue
must be connected to the terminal
which is marked with the letter N
or coloured black.
The wire which is coloured brown
must be connected to the terminal
which is marked with the letter L or
coloured red.
When wiring the plug, ensure that
all strands of wire are securely
retained in each terminal. Do not
forget to tighten the mains lead
clamp on the plug. If your electricity
supply point has only two pin socket outlets, or if you are in doubt,
consult a qualified electrician.
Should the mains lead ever require
replacement, it is essential that this
operation be carried out by a qualified electrician and should only be
replaced with a flexible cord of the
same size.
After replacement of a fuse in the
plug, the fuse cover must be refitted.
If the fuse cover is lost, the plug
must not be used until a replacement cover is obtained.The colour
of the correct replacement fuse
cover is that of the coloured insert
in the base of the fuse recess or
elsewhere on the plug.Always state
this colour when ordering a
replacement fuse cover.
Only 13amp replacement fuses
which are asta approved to B.S.
1362 should be fitted.
This appliance conforms to the
Norms EN 55014 regarding the
suppression of radio interference.
GREEN AND YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
WARNING - THIS APPLIANCE MUST BE EARTHED
Green and Yellow to
Earth
Blue to
Neutral
13 amp
Fuse
Brown
to Live
Cord Clamp
SAFETY WARNINGS
• This machine is designed to “make coffee” and to “heat drinks”:
be careful to avoid scalding from the water and steam jets or by
using the machine incorrectly.
•Do not touch hot parts (steam and hot water tube, boiler outlet,
areas in contact with the filter holder and the warming plate).
• After having removed the packaging, make sure that the product
is complete. If in doubt, do not use the appliance and contact
qualified personnel only.
• This appliance is for home use only. All other uses are considered improper and thus dangerous.
•The manufacturer cannot be held responsible for any damage
caused by improper, erroneous and unreasonable use.
• Do not touch the appliance with wet or damp hands or feet.
•Never allow the appliance to be used without supervision by
children or unfit persons.
• Children must be supervised at all times to ensure that they do
not play with the appliance.
•In the event of failures or malfunction, switch off the appliance
and do not tamper with it in any way. For repairs, contact an
authorized Service Centre only and request original spare parts.
Failure to observe the above points may affect the safety of the
appliance.
• The power cable must not be replaced by the user as this
requires the use of special tools. If the power cable is damaged
or needs replacing, contact an authorized Service Centre.
• Remove the plug from the mains socket and turn off the main
switch when the appliance is not in use. Do not leave the appliance switched on unnecessarily.
• Do not immerse the appliance in water.
INSTALLATION
• Place the appliance on a working surface away from water taps
and sinks.
• Check that the mains supply corresponds to the voltage on the
appliance rating plate. Connect the appliance to a correctlyearthed power socket (minimum rating 10A) only. The manufacturer declines all liability for any accidents due to the incorrect
earthing of the appliance.
•Never install the machine in environments where the temperature may reach 0°C or lower (the appliance may be damaged if
the water freezes).
• If the power cable is longer than the distance required to reach
the power socket, the extra length may be stored inside the
machine by pushing the cable inside the corresponding opening.
Coffee Maker EC190/200
CHLORINE FILTER (if fitted)
The filter eliminates the taste of chlorine from the water. To install
the filter, proceed as follows :
• Remove the chlorine filter from the plastic bag and rinse it in
tap water.
• Lift the coffee lid, remove the filter holder from its housing by
lifting it upwards (Fig. 1).
• Open the filter holder by pressing the parts marked “PUSH”,
and carefully position the filter as shown in Fig. 2.
•Close the filter holder and replace it in its housing, pushing it
fully down.
• The chlorine filter must be replaced every 80 cycles, and always
after six months of operation.
HOW TO PREPARE THE DRIP COFFEE
• Lift the cap and remove the water tank (Fig. 3).
• Fill the tank with fresh, clean water up to the level corresponding to the number of cups of coffee required (Fig. 4).
• Place the tank back in the coffee maker, pressing it lightly.The
tank may also be filled without being removed, using the jug
marked with the level indicators (Fig. 5).
• Open the filter holder door by turning it to the left (Fig. 6).
•In versions with a permanent filter, place the filter in the filter
holder (Fig. 7). In other versions, use the #4 paper filter.
ig. 1
ig. 2
ig. 3
ig. 4
ig. 5 fig. 6 fig. 7
Coffee Maker EC190/200
• Place the ground coffee in the filter, using the measuring spoon
supplied, and level evenly (Fig. 8). As a general rule, use a level
measuring spoon of ground coffee (around 7 grams) for each
cup (for example, 12 spoons to make 12 cups).The quantity of
ground coffee used may, however, be varied according to personal taste. Use good quality, medium ground coffee, packaged
for drip coffee makers.
•Close the filter holder door and place the jug, with the lid on,
on the warming plate, make sure it is placed in the centre.
• Choose the desired flavour as indicated in the paragraph "How
to choose the flavour".
•Press the "ON/OFF" switch (Fig. 9).The ON pilot light above
the switch indicates that the coffee maker is in operation.
• In the models with the 6/12 cup switch “ “ for drip coffee, if
more than six cups are required, press the 6/12 cup switch “ “
(Fig. 10), and the corresponding pilot light will come on. If, on
the other hand, less than six cups are required, do not press the
switch. In this way, the hot water will flow more slowly through
the ground coffee, with better results.
• The coffee will start to come out after a few seconds. It is
completely normal for the appliance to release a little
steam while the coffee is percolating.
• If the “ON/OFF” switch is left in the ON position after percolation, the warming plate will keep the coffee at the ideal temperature.
NB. In models fitted with a rotating base, the coffee maker can be
turned to the right or the left for easier access to the water tank.
(Fig.11).
HOW TO CHOOSE THE FLAVOUR OF THE DRIP
COFFEE
With the Flavour System, the flavour of the drip coffee can be chosen according to personal taste.
By turning the flavour adjustment knob (Fig. 12), the coffee maker
can be set for coffee with a strong (STRONG position) or light
aftertaste (LIGHT position).
The Flavour System changes the strength of the aftertaste of the
coffee, while the actual taste remains the same.
WARNING: the first time coffee is prepared, all the accessories and internal circuits of the machine must be
washed as follows:
Make at least two jugs of coffee without using ground coffee (following the instructions in the paragraph How to prepare the drip
coffee).
ig. 8
ig. 9
ig. 10
ig. 11
Coffee Maker EC190/200
ig. 12
CLEANING AND MAINTENANCE
Before performing any cleaning or maintenance operations, turn
the machine off, unplug it from the power socket and allow it to
cool down.
1. When cleaning the coffee maker, do not use solvents or abrasive detergents.A soft, damp cloth is sufficient.
2. Never immerse the coffee maker in water: it is an electrical
appliance.
CLEANING THE FLAVOUR SAVER
To clean the Flavour Saver more efficiently, it can be removed from
the filter holder cone by pressing it lightly inwards (Fig. 13). To
replace it, simply slide it in from above (Fig. 14).
DESCALING
If the water in your local area is hard, lime scale will form over
time.These deposits may affect the correct operation of the appliance.
The coffee maker must be descaled every 40 cycles. The descaling
process may be performed using special commercially-available
scale removers for drip coffee makers.Alternatively, white wine
vinegar can be used as follows:
1. Remove the chlorine filter.
2. Pour 2 cups of white wine vinegar and 3 cups of water into the
tank. Place the tank in the coffee maker;
3. Place the jug on the warming plate, do not put any ground coffee in the filter holder;
4. Press the drip coffee ON/OFF switch, percolate the equivalent
of one cup and then switch off the appliance;
5. Leave the vinegar to act for one hour;
6. Switch the coffee maker back on and percolate the rest of the
solution;
7. To rinse the machine, operate it with water and without ground
coffee at least 3 times (3 complete tanks of water).
ig. 13
ig. 14
Coffee Maker EC190/200
TROUBLESHOOTING
Coffee Maker EC190/200
Problem
Probable cause
Solution
The drip coffee
takes longer to percolate
The drip coffee
maker needs to be
descaled
Perform the descaling
procedure as
described in the
paragraph
“Descaling”
The coffee has a
vinegary taste
The coffee maker
has not been rinsed
sufficiently
Rinse the appliance
as described in the
chapter “Descaling”
Loading...