For your safety and continued enjoyment of this product, always read the instruction book carefully before using.
EM-300 SERIES
IMPORTANT
SAFEGUARDS
We at Cuisinart are very safety consciou s. We
design and manufacture consumer products
with the safety of you, our valued customer,
foremost in mind. In addition we ask that you
exercise a degree of care when using electrical
appliances and adhere to the following
precautions.
When using electrical appliances, basic safety
precautions should always be followed,
including the following:
1. CAREFULLY READ ALL INSTRUCTIONS
BEFORE OPERATING APPLIANCE, AND
SAVE THIS MANUAL FOR FUTURE
REFERENCE.
2. Unplug from outlet when not in use and
before cleaning. Allow to cool before
putting on or taking off parts, and before
cleaning the appliance.
3. To protect against fire, electrical shock and
injury to persons do not immerse the
appliance, cord or plug in water or any
other liquid.
4. This appliance is for household use only.
5. Do not operate the unit with the brewing
head open.
6. Do not use this appliance for anything other
than its intended use.
7. This appliance should not be used by or
near children or individuals with certain
disabilities.
8. Do not leave the appliance unattended
when in use.
9. Do not touch hot surfaces. Use handles
or knobs.
10. Always use the appliance on a dry,
level surface.
11. To disconnect, turn all controls off, then
remove plug from power outlet.
12. Do not place this appliance on or near a
hot gas or electric burner, or where it could
touch a heated oven.
13. Do not let the cord hang over the edge of a
table or counter or touch hot surfaces or
become knotted.
14. The use of accessory attachments not
recommended by Cuisinart may cause a
risk of injury to persons, fire or electrical
shock.
15. Strictly follow cleaning and care instructions.
16. Do not use this appliance for anything other
than its intended use. Do not use in moving
vehicles or boats.
17. Do not use outdoors.
18. Always switch the appliance off, and then
remove plug from the power outlet when
the appliance is not being used and before
cleaning.
19. An extension cord is not recommended.
However, if one is needed, the extension
cord should be a grounded type and its
electrical rating must be the same or higher
wattage as the appliance. Regularly inspect
the supply cord, plug and actual appliance
for any damage. If found damaged in any
way, immediately cease use of the
appliance and call Cuisinart Customer
Service at 1-800-726-0190.
20. For any maintenance other than cleaning,
call Cuisinart Customer Service at 1-800726-0190.
21. Refer servicing to qualified personnel.
22. Do not operate any appliance with a
damaged cord or plug or after the
appliance malfunctions, or has been
damaged in any manner. Return appliance
to the nearest authorized service facility for
examination, repair or adjustment.
23. Do not operate your appliance in an
appliance garage or under a wall cabinet.
When storing in an appliance garage
always unplug the unit from the
electrical outlet. Not doing so could
create a risk of fire, especially if the
appliance touches the walls of the garage
or the door touches the unit as it closes.
2
SAVE THESE
INSTRUCTIONS
NOTE: For safety reasons it is recommended
you plug your Cuisinart appliance directly into
the power outlet. Use in conjunction with a
power strip or extension cord is not
recommended.
FOR HOUSEHOLD USE
ONLY
WARNING: RISK OF FIRE OR
ELECTRIC SHOCK
The lightning flash with arrowhead
symbol within an equilateral
triangle is intended to alert the
user to the presence of
uninsulated dangerous voltage
within the product’s enclosure
that may be of sufficient
magnitude to constitute a risk of
fire or electric shock to persons.
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and
maintenance (servicing)
instructions in the literature
accompanying the appliance.
WARNING
RISK OF FIRE O R ELECT RIC SHOC K
DO NOT OPEN
WARNIN G: TO REDUC E THE RISK OF FIRE OR ELEC TRIC SHOCK ,
DO NOT REMOVE COV ER (OR BACK )
NO USE R-SERVICE ABLE PARTS INSIDE
REPAIR SHOULD BE DONE BY AUT HORIZED SE RVICE PERSO NNEL ONLY
SPECIAL SAFETY
INSTRUCTIONS
1. Use only cold water in the water reservoir.
Do not use any other liquid.
2. Never use the machine without water in it.
3. Scalding may occur if the brewing head is
opened during brewing cycle.
SPECIAL CORD SET
INSTRUCTIONS
A short power-supply cord is provided to
reduce the risks resulting from becoming
entangled in or tripping over a longer cord.
Longer extension cords are available and may
be used if care is exercised in their use.
If a long extension cord is used, the marked
electrical rating of the extension cord must be
at least as great as the electrical rating of the
appliance. The extension cord should be a
grounding-type 3-wire cord, and the longer
cord should be arranged so that it will not
drape over the countertop or tabletop where
it can be pulled on by children or tripped over.
NOTICE
If you have a
die-cast metal unit,
for your protection
it is equipped with
a 3-conductor cord
set that has
a molded 3-prong
grounding-type
plug, and should
be used in combination with a
properly connected
grounding-type
outlet as shown
in Figure A.
If a grounding-type outlet is not available, an
adapter, as shown in Figure B, may be
obtained so that a 2-slot wall outlet can be
used with a 3-prong plug. As shown in Figure
C, the adapter must be grounded by
attaching its grounding lug under the screw of
the outlet cover plate. NOTE: Do not remove
the grounding prong.
Circuit Grounding
Conductor
Connected
Properly
Grounding
Prong
Grounding Lug
Cover
Mounting
Screw
Cover of
Grounded
Outlet Box
A.
B.
Adapter
C.
3
CAUTION: Before using an adapter, it must
be determined that the outlet cover plate
screw is properly grounded. If in doubt,
consult a licensed electrician. Never use
an adapter unless you are sure it is
properly grounded.
Note: Use of an adapter is not permitted in
Canada.
1. Place the box on a large, sturdy, flat surface.
2. Remove the instruction book and any
other literature.
3. Remove the sample pack of illy’s
iperEspresso capsules.
4. Turn the box so that the backside of the
machine is down, and slide the espresso
maker from the box.
5. After the espresso maker has been removed,
place the box and the side pulp-molded
inserts out of the way.
6. Remove all packing materials, tape, etc.
We suggest you save all packing materials in
the event that future shipping of the machine
is needed. Keep all plastic bags away from
children.
INTRODUCTION
Cuisinart and illy are proud to introduce this
Buona Tazza™ Single Serve Espresso Machine
powered by Cuisinart and featuring illy’s
proprietary iperEspresso capsule system.
This combines Cuisinart’s excellence in
coffeemakers and illy’s legendary coffee
heritage to bring the pleasure of savoring the
rich, smooth taste of illy to the comfort of your
own home.
4
FEATURES AND BENEFITS
1. Water Reservoir Lid
2.
Removable 34-ounce Water Reservoir
3.
Cup-Warming Plate
Convenient place to warm cups.
4.
19 Bar Pump (not shown)
5.
Brew Head Lever
Use the die-cast metal lever to open and
close the brew head.
6. Brew Head
7.
Brewing Spout
Strategically positioned for optimal results.
8.
Used Capsule Container
(Also contains some residual liquid left after
brewing.)
Select for hotter coffee temperature, and wait
just a few seconds for heat-up.
19. Energy Saver Mode (not shown)
Saves 50% of power after 30 min. non-use.
20. Auto Off Mode (not shown)
Shuts off after 60 min. non-use.
21. Power Cord (not shown)
22. BPA Free (not shown)
All materials that come in contact with liquid
are BPA free.
23. 14-Capsule Pack (not shown)
Choose from 100% Arabica varieties!
3
5
1
2
6
7
8
9
10
11
12
13
5
PREPARING YOUR
ESPRESSO MACHINE
1.
Put the espresso machine on a dry, stable
countertop or other flat, sturdy surface
where you will be using the machine.
IMPORTANT: For first-time use or if the
machine has not been used for some time,
it is important that it is rinsed as follows:
2. Remove the lid of the water reservoir.
Using the handle, lift the water reservoir off
the base and fill with fresh, cold drinking
water. Replace the water reservoir on the
base, and cover with the lid. Using the
tracks as a guide, slide the water reservoir
back into position and push down firmly
to engage.
Important: The unit will not function unless
the water reservoir is properly in place.
3. Insert the plug into a power outlet. Press
the power button once to turn the espresso
machine on. All of the controls on the front
of the machine will flash while it’s preheating. Lights will turn steady when the
unit is in ready mode (approximately
1 minute).
4. Make sure the drip tray and grate are in
place.
5. Place a mug on the drip tray.
6. Press the Manual button and allow the
water to run through for approximately 5 to
10 seconds. Press once more to stop.
7.
Position espresso cups on the warming plate.
8. The machine is now in preheat/ready mode
and ready to use.
NOTE: If the water reservoir is empty, the unit will
not function. The Short , Long , and Manual
LEDs will flash. Turn off the machine, fill the
water reservoir, and turn the machine back on.
USING YOUR
ESPRESSO MACHINE
Always make sure you have water in the
reservoir, a capsule in the brew head, and
that the appropriate tray is being used.
NOTE: This machine is designed
exclusively for use with illy’s iperEspresso
capsules. Any other type of capsule, pod,
or coffee cannot be used.
Single or Double Pre-Programmed
Espresso
1. Using the lever, open the brew head, insert
a capsule, and close the brew head.
2. With an espresso cup on the espresso cup
tray, select either a SHORT (1.5 ounces)
or LONG (3 ounces) espresso. (The
selected function and Hot Temperature
setting LEDs remain on, while all the other
LEDs are off. Once all LEDs are on again,
the machine is ready for the next cycle.)
NOTE: As part of illy patented technology in the
iperEspresso capsule, the brewing process is
completely self-contained in the capsule and
does not get into the brew head. So there is no
need to rinse in between cycles as there will be
no transfer of flavor.
Manual/Adjustable Strength Control
Programmable
1. Using the lever, open the brew head, insert
a capsule, and close the brew head.
For adjustable strength control, use the
2.
MANUAL button to adjust the length of
time espresso is dispensing – the longer
you allow it to flow, the
lighter it will be.
Press to start
dispensing. When your
cup is filled to desired
level, press again to stop.
6
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.