AM/FM and Single CD Micro Hi FI
System
Model CRN-299
guidelines for use
Micro System CRN 299 d5 7/22/04 2:11 PM Page 2
2
Micro System CRN 299 d5 7/22/04 2:11 PM Page 3
120 people every day lose their sight. Almost one person in sixty
in Britain is blind or partially sighted.
Coronation Street’s
‘Please help’
‘Please help’
Every year hundreds of babies are
found to have serious eye disease
Please help, by using the donation form at the back of this booklet.
Liz Dawn
Reg. Charity Nº: 294087
MBE
The battle against blindness
depends on scientific research
GETTING TO KNOW YOUR MICRO SYSTEM
3
FUNCTION SELECTOR
CD/ RADIO
CD LID
REMOTE CONTROL
PLAY / PAUSE
STOP
STANDBY
REPEAT
X-BASS ON/ OFF
VOLUME
DISPLAY
AM/FM/ FM STEREO
SELECTOR
SEARCH UP/ DOWN
PROGRAM
TUNING DIAL
HEADPHONES SOCKET
CD LID BUTTON
press to open CD lid
Micro System CRN 299 d5 7/22/04 2:11 PM Page 4
USING YOUR MICRO SYSTEM
Mains connection
1 Check that the speakers are correctly connected.
2 Check that the voltage indicated on the back of
your Micro System corresponds to the voltage of
your mains electricity supply (230Volts AC).
3 Plug the mains lead into a wall socket. The system
is now in
Standby
mode and
the Standby
button on
the front
panel will
glow red.
4 Press the
STANDBY
button on
the front of
the Micro System.
5 To switch off your Micro System completely,
remove the mains plug from the wall.
Before Use
Speaker Connection
1 Connect one of your speakers to the terminal
marked L on the back of your Micro System,
this will become the left speaker. To connect the
wire into the
designated outlet
simply push down the
gripper clip until an
opening is exposed.
Push the end of the
speaker wire (the bare
wire and not the
plastic covering) into
the opening and
release the gripper clip
to secure the wire firmly in its place.
2 Insert the end of the black and grey speaker
wire into the red outlet marked ‘+’ and the end
of the black speaker wire into the black outlet
marked ‘-’. That speaker is now the left hand
speaker.
3 Connect the other speaker in the same way to
the terminal marked R. This will now be your
right hand speaker.
4
Fit the batteries into the
Remote Control
1 Remove the battery cover by sliding it away
from the body of the remote control.
2 Insert two size AA batteries so that the ‘+’ and
‘-’ marks on the batteries match the ‘+’ and ‘-’
marks inside the unit.
3 Replace the battery cover.
Note: Batteries are not included.
Micro System CRN 299 d5 7/22/04 2:11 PM Page 5