Cornelius DF150, DF200, DF250, ED2XX, DF175 User Manual

Ice Diverter ED/DF Dispensers Installation Instructions

INSTALLATION INSTRUCTIONS

ICE DIVERTER ED/DF DISPENSERS KIT P/N 02394

NOTE: For dispensing Scotsman NME654, NME954 and NME 1254 “Nugget” style ice and
Cornelius WCC500 and WCC700 “Chunklet” style ice cubes.

1. Disconnect power to dispenser.

2. Remove upper front panel/merchandiser from dispenser.

3. Remove ice chute portion and gate restrictor.

4. Install ice diverter as shown (see FIGURE 1) and reinstall the gate restrictor removed in previous
step. Gate restrictor should be installed in ‘front’ of ice diverter. It is critical the opening be set a
minimum of 1 ½” (see FIGURE 2).

STORAGE
HOPPER

GATE
MOUNTING
PLATE

ICE CHUTE

ICE DIVERTER
P/N 15484

APPLY RTV TO THIS
SURFACE TO SEAL TO
HOPPER GATE
MOUNTING PLATE

GASKET

FLAT WASHER

10-32 NUT

FIGURE 1. Exploded View of Ice Diverter Installation

FLANGE EXTENDS
INTO STORAGE
HOPPER THROUGH
GATE OPENING

FIGURE 2. Gate Restrictor with 1 ½” Opening FIGURE 3. Timer Board Settings Reset

5. Remove screws securing white reflector panel and gain access to electrical box. Locate timer board
and reset agitation timer to 2 seconds ‘ON’ and 3 hours ‘OFF’ (see FIGURE 3).

6. Re-install front panel and plug unit back into outlet.

Unit should now be ready to dispense ice for customer use.

Revision Date: June 2, 2005 www.cornelius.com Revision: C

© 2004-2005, IMI Cornelius Inc. - 1 - Publication Number: 92303INS