Installation Instructions for Merchandiser Graphic on Dispenser with Icemaker Adaptor
©2012, IMI Cornelius Inc. www.cornelius.com Publication Number: 620909201PNB
!
WARNING:
Disconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify all power is off to the unit before performing
any work.
Failure to comply could result in serious injury, death or damage to the equipment.
ED250 Model:
1. Remove ice maker lid from the top of the dispenser. 2. Lift up on the merchandiser and disengage the
hooks from the sheet metal cabinet.
3. Place the merchandiser face down on a counter.
Loosen the three screws holding the retainer tabs.
4. Bend the top lip of the merchandiser back slightly to
release the diffuser and graphic.
5. Replace the graphic in the diffuser. 6. Insert the diffuser with the graphic by bending the
top lip of the merchandiser to engage the retainer.
Position retainers and tighten the three screws.
Release Date: 10/15/2012 Revision: A
Installation Instructions for Merchandiser Graphic on Dispenser with Icemaker Adaptor
©2012, IMI Cornelius Inc. www.cornelius.com Publication Number: 620909201PNB
NOTE: The lid has to engage the adapter flange to be secured properly.
IDC255 Model:
NOTE: For IDC255 units, the merchandiser and lid do not need to be removed in order to replace the graphic.
7. Place merchandiser on the beverage panel and insert
the merchandiser brackets into the sheet metal cabinet slots. Push merchandiser down to engage hooks.
8. Return the lid to it's proper position on top of the dispenser, aligning the lid flange with the flange of the
adapter.
9. The lid flange must sit flush to the adapter between
the nylon acorn nuts and the adapter flange.
1. IDC graphic is changed from the front by pressing
the graphic down with both hands. Reverse the
process by inserting the graphic tabs into the merchandiser.
Loading...