Comtech EF Data CiM-25 User Manual
CiM-25
Quick Start Guide
IP-Enabled M&C
Part Number CD/CIM25QSG.IOM
Rev. 0
CiM-25
Quick Start Guide
Comtech EF Data is an ISO 9001
Registered Company.
Part Number CD/CIM25QSG.IOM
Copyright © Comtech EF Data, 2001. All rights reserved. Printed in the USA.
Comtech EF Data, 2114 West 7th Street, Tempe, Arizona 85281 USA, (480) 333-2200, FAX: (480) 333-2161.
IP Enabled M&C
REV. 0
March 3, 2004
CiM-25 Quick Start Guide Rev. 0
Preface CD/CIM25QSG.IOM
CUSTOMER SUPPORT
Contact the Comtech EF Data Customer Support Department for:
Product support or training
Information on upgrading or returning a product
Reporting comments or suggestions concerning manuals
A Customer Support representative may be reached at:
Comtech EF Data
Attention: Customer Support Department
2114 West 7th Street
Tempe, Arizona 85281 USA
480.333.2200 (Main Comtech EF Data Number)
480.333.4357 (Customer Support Desk)
480.333.2161 FAX
or, E-Mail can be sent to the Customer Support Department at:
cimfss@comtechefdata.com
Contact us via the web at www.comtechefdata.com.
1. To return a Comtech EF Data product (in-warranty and out-of-warranty) for
repair or replacement:
2. Request a Return Material Authorization (RMA) number from the Comtech EF
Data Customer Support Department.
3. Be prepared to supply the Customer Support representative with the model
number, serial number, and a description of the problem.
4. To ensure that the product is not damaged during shipping, pack the product in its
original shipping carton/packaging.
5. Ship the product back to Comtech EF Data. (Shipping charges should be prepaid.)
For more information regarding the warranty policies, see Warranty Policy, p. vii.
ii
Table of Contents
Customer Support......................................................................................................................... ii
About this Manual ....................................................................................................................... iv
Conventions and References ....................................................................................................... iv
Metric Conversion ....................................................................................................................... iv
Trademarks .................................................................................................................................. iv
EMC Compliance.......................................................................................................................... v
Federal Communications Commission (FCC) ........................................................................... v
Safety Compliance ....................................................................................................................... vi
EN 60950 ....................................................................................................................................... vi
Warranty Policy.......................................................................................................................... vii
CHAPTER 1. QUICK START PROCEDURE............................................................... 1
1.1 Modem Setup........................................................................................................................... 1
1.2 Windows Setup........................................................................................................................ 2
1.2.1 HTTP 1.1............................................................................................................................ 2
1.2.2 Proxy Server....................................................................................................................... 3
1.3 Network Configuration .......................................................................................................... 5
1.3.1 Resetting to Factory Defaults.............................................................................................5
1.3.2 Changing Network IP Address .......................................................................................... 6
1.4 Flash Upgrading For CiM-25 ................................................................................................ 7
iii
CiM-25 Quick Start Guide Rev. 0
Preface CD/CIM25QSG.IOM
ABOUT THIS MANUAL
This manual provides installation and operation information for the Comtech EF Data
CiM-25 Quick Start Guide. This is a technical document intended for earth station
engineers, technicians, and operators responsible for the operation and maintenance of
the CiM-25 Quick Start Guide.
CONVENTIONS AND REFERENCES
CAUTIONS AND WARNINGS
Indicates information critical for proper equipment function.
IMPORTANT
CAUTION
Indicates a hazardous situation that, if not avoided, may result in minor or moderate
injury. CAUTION may also be used to indicate other unsafe practices or risks of
property damage.
Indicates a potentially hazardous situation that, if not avoided, could result in
WARN ING
death or serious injury.
METRIC CONVERSION
Metric conversion information is located on the inside back cover of this manual. This
information is provided to assist the operator in cross-referencing English to Metric
conversions.
TRADEMARKS
All product names mentioned in this manual may be trademarks or registered trademarks
of their respective companies and are hereby acknowledged.
REPORTING COMMENTS OR SUGGESTIONS CONCERNING THIS MANUAL
Comments and suggestions regarding the content and design of this manual will be
appreciated. To submit comments, please contact the Comtech EF Data Customer
Support Department.
iv
CiM-25 Quick Start Guide Rev. 0
Preface CD/CIM25QSG.IOM
EMC COMPLIANCE
This is a Class A product. In a domestic environment, it may cause radio interference that
requires the user to take adequate protection measures.
EN55022 COMPLIANCE
This equipment meets the radio disturbance characteristic specifications for information
technology equipment as defined in EN55022.
EN50082-1 COMPLIANCE
This equipment meets the electromagnetic compatibility/generic immunity standard as
defined in EN50082-1.
FEDERAL COMMUNICATIONS COMMISSION (FCC)
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment.
This equipment generates, uses, and can radiate radio frequency energy. If not installed
and used in accordance with the instruction manual, it may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference; in which case, users are required to correct the interference at their
own expense.
Note: To ensure compliance, properly shielded cables for DATA I/O shall be used. More
specifically, these cables shall be shielded from end to end, ensuring a continuous shield.
v
CiM-25 Quick Start Guide Rev. 0
Preface CD/CIM25QSG.IOM
SAFETY COMPLIANCE
EN 60950
Applicable testing is routinely performed as a condition of manufacturing on all units to
ensure compliance with safety requirements of EN60950.
This equipment meets the Safety of Information Technology Equipment specification as
defined in EN60950.
LOW VOLTAGE DIRECTIVE (LVD)
The following information is applicable for the European Low Voltage Directive
(EN60950):
<HAR> Type of power cord required for use in the European Community.
CAUTION: Double-pole/Neutral Fusing.
!
ACHTUNG: Zweipolige bzw. Neutralleiter-Sicherung.
International Symbols:
Symbol Definition Symbol Definition
Alternating Current.
Fuse.
Protective Earth.
Chassis Ground.
Note: For additional symbols, refer to “Cautions” listed earlier in this preface.
vi
Loading...