Comnet CNFE5SMSPOE User Manual

INSTALLATION AND OPERATION MANUAL

CNFE5SMSPOE

FIVE PORT 10/100T(X) ETHERNET SELF-MANAGED SWITCH
WITH POWER OVER ETHERNET (POE+)

The ComNet™ CNFE5SMSPOE is a five-port self-managed Ethernet switch with uplink
management functionality. It provides 5 ports operating at 10/100Mbps and is
designed to combine Ethernet data from the four electrical ports into a fifth electrical
port and forward that data to the next network device. There is no programming
required to use this product. The ComNet CNFE5SMSPOE c comes pre-programmed,
preventing network video flooding with DIP switch selection of port five as uplink
or as an unmanaged switch. Ports 1–4 can supply up to thirty (30) watts of power
(“Power over Ethernet”) based on the IEEE 802.3at standard. It is “Plug-and-Play”
easy to use.

LED indicators confirm the operating status of this device. See Figure 4 on Page 3
for an explanation of the indicators.

The ComNet CNFE5SMSPOE may be either wall mounted, rack mounted (“ComFit”
packaging) or DIN-rail mounted with the use of the ComNet DINBKT1 adapter. See
Figure A on Page 4 for mounting instructions.

See Figures 1 – 5 for complete installation details.

INS_CNFE5SMSPOE_REVA 07/08/11 PAGE 1

INSTALLATION AND OPERATION MANUAL CNFE5SMSPOE

FIGURE 1 – CNFE5SMSPOE

NOTE:

For Power over Ethernet, use

a 48 VDC @ 2.6 Amps PSU

RJ-45

RJ-45

RJ-45

(ComNet Model PS48VDC-

5ADIN sold separately). The

units may be mounted inside

a ComNet rack, but they must

be powered by an external

48VDC PSU.

RJ-45

RJ-45

FIGURE 2 – CNFE5SMSPOE

REAR PANELFRONT PANEL

BLACK

BLACK WITH WHITE STRIPE

FIGURE 3 – UPLINK SWITCH SETTINGS

EFFECT UPLINK

Uplink Enabled ON

Uplink Disabled OFF

Tech SupporT: 1.888.678.9427

INS_CNFE5SMSPOE_REVA 07/08/11 PAGE 2