Code 3 MR6 User Manual
Surface Mount
To + VDC (fuse @ 3A):
To Chassis Ground:
For Synchronization:
Connect
(All heads must be set at the same pattern)
YELLOW
wires of all heads together for synchronization
RED
BLACK
YELLOW
For Simultaneous or Alternating Flash:
RED
1. Apply +VDC to
Grouping mode; lighthead will display short (single or double) flashes:
˙Single flash = Group1 ˙Double flash = Group2
2. Remove YELLOW wire from +VDC and momentarily apply to +VDC
to change Groups:
˙Heads in the same Group flash together.
˙Group1 Heads alternate with Group2 Heads.
For Flash Pattern, momentarily
apply +VDC to YELLOW wire:
˙once for next pattern
˙quickly three times for reset
(see flash pattern chart)
and
YELLOW
wires simultaneously to enter
1
2
3
4
5
6
7
8
9
10
11
12
Flash Patterns
(2Hz)
Single
(2Hz)
Double
(2Hz)
Triple
(2Hz)
Quad
Random
Single (split)
Double (split)
Quad (split)
Quint (split)
Mega (split)
Ultra (split)
Single-Quad (split)
13
14
15
16
17
18
19
20
21
22
23
Single H/L (split)
Single (all)
Double (all)
Quad (all)
Quint (all)
Mega (all)
Ultra (all)
Single-Quad (all)
Single H/L (all)
Steady 2 (california)
Steady 4 (all)
120523
Adhesive Mount
1. Clean mounting surface.
2. Use adhesive pads to secure lighthead.
NOTE: Optimum adhesive strength is
achieved after 24hrs.
Screw Mount
1. Mark and drill mounting holes.
2. Place rubber pad to bottom of
ligthhead base.
3. Secure lighthead to
mounting surface
with supplied screws.
mounting
screws
lighthead base
mounting surface
adhesive
pads
Bracket Mount
1. Select mounting location.
2. Place rubber pad to bottom of lighthead base.
3. Place lighthead to the mounting surface.
4. Align top holes of bracket onto the lighthead
base alignment points.
5. Secure lighthead with supplied screws from
the bottom of bracket.
mounting surface
mounting screw
lighthead base
lighthead base
rubber pad
mounting surface
rubber pad
mounting surface
mounting
bracket
120523
Loading...