CMA Dishmachines EAH, EC, EAH-T, EC-T Quick Setup Instructions Manual
Models EAH, EC, EAH-T, EC-T
Quick Setup
Instructions
WARNING: Electrical and plumbing connections
need to be made by a licensed service person
and comply with all Federal, State and Local
Health, Electrical, Plumbing and Safety codes.
MODEL “E” REAR VIEW
POWER SWITCH
DELIMER SWITCH
HARD WIRE
POWER SUPPLY
1/2" WATER
2
3
3
INLET
AUTO START
SWITCH
TUBE
STIFFENER
CHEMICAL
TUBING
STEP
1
8"
WALL
DRAIN
Connect a 2" drain pipe (not supplied)
from scrap accumulator to floor or
wall drain.
STEP
2
FLOOR DRAIN
STEP
3
RED
WHITE
1
2" DRAIN
OUTLET
BLUE
RED
WHITE
BLUE
Connect dishmachine to hot water source
(minimum 120-140
required).
PN: 10130.23
temperature
Insert tube stiffener with chemical tubing
into each corresponding chemical
dispensers.
11-2016
Models EAH, EC,
EAH-T, EC-T
Quick Setup
Instructions
MODEL "E" FRONT VIEW
SANI/DETERGENT
SWITCH
000000
RINSE SWITCH
WARNING: Electrical and
plumbing connections need to
be made by a licensed service
person and comply with all
Federal, State and Local
Health, Electrical, Plumbing
and Safety codes.
THERMOMETER NEEDS TO
BE INSTALLED:
The Models E-AH and C are
Shipped from CMA without
thermometer being installed. To
prevent leaking, the installation
Team will need to install it on the
dishwasher using TEFLON TAPE.
So the thermometer for this unit is
not misplaced during shipment,
please find thermometer shipped
inside the dishwasher, zip-tied
to the dishrack.
PERISTALTIC
PUMP
CYCLE LIGHT
FILL/START
SWITCH
DOOR HANDLE
POLY PROTM SCRAP
ACCUMULATOR
5
6
LEVELING
4
STEP
4
Level dishmachine by adjusting leveling
legs. Dishmachine must be level front and
back to ensure proper performance.
LEGS
STEP
5
Press and hold the Fill/Start Switch until
the water level is approximately 1/2" to 3/4"
below the overflow hole in the PVC
standpipe.
000000
FILL
an Ali Group Company
000000
STEP
START
6
Open dishmachine doors completely.
Closing the doors will automatically activate
the machine.
11-2016
The Spirit of Excellence
Loading...