CMA Dishmachines E3DEXT, E3D, ECEXT, EAHEXT, EC Installation Manual
...
Models EAH, EC, EAH-T, EC-T
Quick Setup
Instructions
800-854-6417
WARNING: Electrical and plumbing connections
need to be made by a licensed service person
and comply with all Federal, State and Local
Health, Electrical, Plumbing and Safety codes.
STEP
1
8"
WALL
DRAIN
Connect a 2" drain pipe (not supplied)
from scrap accumulator to floor or
wall drain.
STEP
FLOOR DRAIN
2
POWER SUPPLY
1/2" WATER
3
AUTO START
4
STIFFENER
CHEMICAL
4
HARD WIRE
INLET
SWITCH
TUBE
TUBING
2
Connect hard wire power supply from
dishmachine to power box.
STEP
3
Connect dishmachine to hot water source
(m i n imu m 1 20 ° - 1 40° te m p era t u r e
required).
2" DRAIN
1
OUTLET
STEP
4
Insert tube stiffener with chemical tubing
into each corresponding chemical
dispensers.
RED
WHITE
BLUE
RED
WHITE
BLUE
10-2007
Models EAH, EC, EAH-T, EC-T
800-854-6417
Quick Setup
Instructions
WARNING: Electrical and plumbing connections
need to be made by a licensed service person
and comply with all Federal, State and Local
Health, Electrical, Plumbing and Safety codes.
PERISTALTIC
PUMP
MODEL "E" FRONT VIEW
000000
FILL/START
SWITCH
DOOR HANDLE
6
7
LEVELING
5
STEP
LEGS
5
Level dishmachine by adjusting leveling
legs. Dishmachine must be level front and
back to ensure proper performance.
STEP
6
000000
LL
FI
Press the "FILL/START" switch. Hold in the
"FILL" position until the water overflows
into the scrap accumulator.
POLY PROTM SCRAP
ACCUMULATOR
000000
STEP
START
7
Open dishmachine doors completely.
Closing the doors will automatically activate
the machine.
10-2007
Loading...