Use EL Backlight
In the timekeeping mode
press "C" to illuminate
the display about 3
seconds.
Time Setting
6. Press "A" to exit the set state, after you set
(The day of week is auto displayed in
accordance with year,month and date
setting).
TIMEKEEPING
a
1. In the timekeeping mode
press and hold"A" until
the seconds to flash;
(flashing indicated in set
mode )
12/24H Format
BACKLIGHT
The backlight that uses an EL(electro-luminescent)
cause the display to glow for easy reading
in the dark.
5. Repeat step 3 and 4,the selection in the
following sequence:
Seconds Hour Minutes Year Month
Date;
In the timekeeping mode,
press "D" to switch
between 12/24 formats.
3. Press "B" to change the
next selection;
2. Press "D" to reset the
seconds;
4. Press "D" to increase the
number, press and hold
to increase at high speed;
f
PACER
e
DUAL TIME
d
ALARM
c
COUNTDOWN
100 years Calendar(2000~2099).
12/24H Format;
Hour, Minutes, Seconds,
Month,Date,Day of week;
The time for other
time zone.
MODE SELECTION
Press "B" to change mode to mode in the
following Sequence:
Timekeeping Mode Stopwatch Mode
Countdown Mode Alarm Mode
Dual Time Mode Pacer Mode.
The alarm sounds at the
preset time each day.
Hourly time signal;
Countdown range:
23:59'59" ~ 0'00"00.
Measuring range:
0'00"00 ~ 23:59'59".
1/100 second unit;
10 tempo.
5 Alarms;
a
TIMEKEEPING
b
STOPWATCH
USER'S GUIDE
YP13610C(SECONDS CARTOON,MULTI FUNCTION SPORT LCD WATCH)
EL Backlight
Chime
100M Water Resistant
100
Countdown Timer
Dual Time
Stopwatch
5 Alarms
5
100 Years Ca lendar
11
Pacer
60
Quartz Movement
Battery(CR2025
+SR626SW)
A -- Reset
B -- Mode
C -- EL Backlight
D -- Start/Stop
BUTTONS
Button operation are indicated using the
letters shown in the illustration.
ATTENTION
1.Never try to open the case or remove its
back cover.
2.Do not operate buttons underwater.
3.Should moisture appear inside the watch,
have it checked immediately by your
dealer. Otherwise it can cause erosion of
the metal parts of the watch .
4.Though the watch is designed to withstand
normal use, you should avoid rough use or
dropping the watch.
5.Avoid exposing the watch to temperature
extremes.
6.Wipe the watch with dry ,soft cloth only.
Avoid allowing it to come into direct
contact with chemical materials, which can
cause deterioration of the plastic parts of
the watch.
7.Avoid to wear the watch in electromagnetic,
static conditions.
The screen shown in below
DISPLAY
ADJUST HANDS
Pull out the crown, turn to adjust the hour and
minutes hands;
Push the crown go back the normal position
the after time set;
" D " " A "
" B "
" C "
Crown
Month Date
Day of week
Alarm
Chime
Minutes
Seconds
Hour
Countdown
(Cartoon)
CITIZEN WATCH CO.,LTD.
Q&Q SALES DEPARTMENT
A Lap Time
Split Time
b
STOPWATCH
1. In the stopwatch mode,
press "D" to start the
stopwatch;
2. To stop the stopwatch
by pressing "D" again;
3. Press "A" to reset the
stopwatch.
1. In the stopwatch mode
press "D" to start the
stopwatch;
2. Press "A" to display the
split time, stopwatch
timing continues internally;
3. Press "A" to clear the
split time and to continue
time measurement;
4. Repeat step 2 and 3,you can measure the
multi split time;
5. Press "D" to stop the stopwatch.
Countdown Timer Setting
1. In the countdown mode,
press "A" the hour to flash;
(flashing indicated in set
mode)
2. Press "D" to increase
the hour ,press and
hold to increase at high
speed;
3. Press "B" to select the
minutes;
4. Press "D" to increase
the minutes, press and
hold to increase at high
speed;
When the countdown reaches zero,the alarm
sounds for about 60 seconds and press any
button to break it.
6. Press "A" to exit the set
state , after you set.
1.Press "D" to start the
countdown;
2.To pause the countdown
by pressing "D again.
Use Countdown Timer
c
COUNTDOWN
5. Repeat step 3 and 4,the selection in the
following sequence:
Hour Minutes Seconds;
1. In the dual time mode,
press "A" the hour to
flash; (flashing indicated
in set mode)
2. Press "D" to increase
the hour, press and
hold to increase at high
speed;
3. Press "B" to select the
minutes;
4. Press "D" to change the
minutes ; (press once
change 30 minutes)
5. Press "A" to exit the set state, after you set.
f
PACER
Use The Pacer
1. In the pacer mode, the
tempo number flash;
3. Press "D" to start;
4. To stop it press "D" again.
2. Press "A" select the
tempo in the following
sequence:
10 20 30 40 60
80 120 160
240 320;
e
DUAL TIME
Dual Time Setting
d
ALARM
The alarm sounds at the preset time each day for
about 60 seconds,press any button to break it.
Setting and operation of the
Alarm1~Alarm5 are the same.
Alarm and Chime
Alarm1 Setting
2. Press "D" to increase the
hour, press and hold to
increase at high speed;
3. Press "B" to select the
minutes;
4. Press "D" to increase the
minutes, press and hold
to increase at high speed;
5. Press "A" to exit the set
state, after you set.
In the alarm mode, press
" C " to select chime,
Alarm1 ~ Alarm5.
In the Alarm1 ~ Alarm5 state,
press "D" to on/off the alarm.
In the chime state , press
"D" to on/off the chime .
1. In the alarm mode,
press " A " the hour
to flash(flashing
indicated in set mode);
Loading...