Cisco Systems C11111696 Regulatory Compliance Statement

DraftofFCCandCanadaStatements



FCC Supplier Declaration of Conformity

This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications.

 This device may not cause harmful interference
 This device must accept any interference received, including interference that may cause

undesired operation

Operation of this equipment in a residential area is likely to cause harmful interference in which
case, users will be required to correct the interference at their own expense.

Radio Compliance

This system uses both licensed and licensed exempt radio frequencies. The radios have been
evaluated to the following

The Wi-Fi Radio has been evaluated to 47 Code of Federal Regulations Part 15.247 and Part

15.407.

Part 15 Radio Systems operating outdoors in the 5150-5250 MHz band must comply with the
antenna installation requirements as set forth in the FCC Part 15.407 rules.

The LTE radio has been evaluated to 47 Code of Federal Regulation Part 24 and 27.

The LTE radio operates on licensed frequency bands and requires a radio license to operate. It
must be operated under the control of a Licensed Service Provider or Wireless Carrier.

Modifications by user or installer

Modifying the equipment without Cisco’s authorization may result in the equipment no longer
complying with FCC requirements for Class A digital devices. In that event, your right to use the
equipment may be limited by FCC regulations, and you may be required to correct any
interference to radio or television communications at your own expense.

Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.

RF Exposure Compliance

DraftofFCCandCanadaStatements


FCC RF Exposure Compliance

This product has been found to be compliant to the requirements set forth in CFR 47 Section

1.1307 addressing RF Exposure from radio frequency devices as defined in Evaluating
Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic
Fields.

To maintain compliance, the minimum separation distance from the antenna to general bystander
is 20 cm (7.87 inches) or more from the body of all persons.

.

Canada
EMC

This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada

Radio (Wi Fi)

This product complies with RSS-247 of the Industry Canada Rules. Operation is subject to the
following two conditions:

 This device may not cause harmful interference
 This device must accept any interference received, including interference that may cause

undesired operation

Ce dispositif est conforme à la norme RSS-247 d'Industrie Canada applicable aux appareils radio
exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes:

 le dispositif ne doit pas produire de brouillage préjudiciable
 ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de

provoquer un fonctionnement indésirable

The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential
for harmful interference to co-channel mobile satellite system;

For devices with detachable antenna(s), the maximum antenna gain permitted for devices in the
bands 5250-5350 MHz and 5470-5725 MHz shall be such that the equipment still complies with the
e.i.r.p. limit;