Cisco Systems 8220 User Manual

CHAPTER

Introduction

This manual describes the features and functions of Release 3.0 of the Cisco MGX™ 8220 edge
concentrator. (See Figure 1-1.)

Figure 1-1 MGX 8220 Edge Concentrator

1

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

H8238

Introduction 1-1

MGX 8220 System Overview

MGX 8220 System Overview

The MGX 8220 shelf is designed on the philosophy that large scale deployment of narrowband and
medium-band services isbesthandledusinganATM infrastructure. Infact,supportoftheseservices
can, by themselves, justify an ATM infrastructure. The same infrastructure can then be used to
provide broadband services to customers when and where they are needed.

The MGX 8220 shelf is an adjunct shelf to the Cisco BPX® 8600 series wide-area switch.
Architecturally it provides:

• A means for flexibly providing many narrowband and/or medium-band ATM and non-ATM

service interfaces without consuming BPX switch slots.

• Conversionofnon-ATM traffic streams to and from ATM traffic streams using Adaptation Layer

standards.

• A means for concentrating the traffic from the narrowband and/or medium-band interfaces onto

the broadband ATM ports of the BPX switch.

Service Interfaces

The MGX8220shelfisaflexiblestandards-based service access platform. The MGX 8220 shelf can
support a wide range of services over narrowband and mid-band user interfaces, mapping all the
service traffic to and from ATM, based upon standardized interworking methods. The aggregated
trafficis sent/received overan ATMinterface to an ATM switch (BPX switch), using up a single port
on the ATM switch.

Release 3.0 of the MGX 8220 shelf supports up to 40 channelized or non-channelized T1 and E1
interfaces on a single shelf providing support for Frame Relay UNI and NNI; ATM UNI, NNI, and
FUNI; Frame Relay to ATM network interworking; Frame Relay to ATM service interworking and
circuit emulation services. The MGX 8220 shelf Release 3.0 also supports the use of Inverse
Multiplexing for ATM (IMA) to provide ATM trunking below T3/E3.

The system’s modular, software-based architecture enables it to support these and other additional
user services in the future, through downloadable software upgrades or new hardware modules.

Standards-Based Conversion to ATM

All user information received by MGX 8220 interfaces is converted into 53-byte ATM cells, using
standard ATM Adaptation Layers (AALs), for transport over the ATM backbone network. Cell
segmentation and reassembly (SAR) and other adaptation functions are distributed to each interface
module to eliminate system bottlenecks.

• For Circuit Emulation Services, AAL1 is used.

• For Frame Relay (FR to ATM network interworking), AAL5 and FR-SSCS (Frame Relay

Service Specific Convergence Sublayer) are used.

• For Frame Relay to ATM service interworking, both transparent and translation modes are

supported to map FR to native ATM AAL5.

• For Frame Forwarding, AAL5 is used.

1-2

Cisco MGX 8220 Reference