Cisco Systems 102042 Users Manual

Beta Draft 1 - Cisco Confidential
APPENDIX
B
Declarations of Conformity and Regulatory Information
This appendix cont ai ns the fo llowing sec tio ns:
Manufacturers Federal Commu nication Com mission Decl aration of Conf ormit y Statemen t
Department of Comm uni ca tions – Ca nada
European Community, Switzerland, Norway, Iceland, and Liechtenstein
Declaration of Conf orm ity f or RF Exp osur e
Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan
OL-2155-01
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
B-1
Appendix B Declarations of Conformity and Regulatory Information

Manufacturers Federa l Communication Commission Decl aration of Conformity Statement

Beta Draft 1 - Cisco Confidential
Manufacturers Federal Communica tion Commission Declaration of Conformity Statement
T ested To Comply With FCC Standards
FOR HOME OR OFFICE USE
Models: AIR-AP1200B w/AIR-M P20B- A-K 9, A IR-A P122 0B-A- K9 FCC Certification number: LDK 102042 (AIR -AP12x x) Manufacturer: Cisco Systems, Inc.
170 West Tasman Drive San Jose, CA 95134- 170 6 USA
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1. This device may not ca use h ar mf ul i nte rf er ence , an d
2. This device mu s t ac cep t any interference re ceived, inclu di n g inter f er en ce th at may cau se u ndesired
operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference whe n the equi pmen t is opera ted in a resi dential environment. This eq uipm ent gene rates, uses, and radiat es r a dio f req uency en ergy, and if not ins tall ed a nd used i n ac co rdanc e w ith the instructions, may cause harmful interference. However, there is no guarantee that interference will not occur. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures:
Reorient or re loca te the r ece iving an tenn a.
Increase separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from which the receiver is connected.
Consult the dea ler o r an experi enc ed radi o/T V t ech ni cia n.
Caution The Part 15 radio device opera te s on a n on- int erfere nce ba sis wi th othe r devices ope ratin g a t th is
frequency when using the antennas liste d in Table B-1. Any changes or modification to said product not expressly approved by Cisco could void the user’s authority to operate this device.
B-2
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-2155-01
Appendix B Declarations of Conformity and Regulatory Information
Beta Draft 1 - Cisco Confidential
Table B-1 Access Point Antennas
Cisco Part Numb er Model Gain
AIR-ANT1949 Yagi 13.5 AIR-ANT4121 Omni-directional 12.0 AIR-ANT3549 Patch 8.5 AIR-ANT2012 Spatial diversity 6.5 AIR-ANT1729 Patch 6.0 AIR-ANT2506 Omni-directiona l 5.1 AIR-ANT3213 Omni-directiona l 5.0 AIR-ANT1728 Omni-directiona l 5.0 AIR-ANT3195 Patch 3.0 AIR-ANT5959 Omni-directiona l 2.0 AIR-ANT4941 Dipole 2.2

Department of Communications – Canada

Department of Communications – Canada

Canadian Compliance Statement

This Class B Digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numerique de la classe B respecte les exigences du Reglement sur le material broilleur du Canada.
This device co mplie s with Class B Lim its o f Indust ry Can ada. Oper ati on is su b jec t to th e following two conditions:
1. This device may not ca use h ar mf ul i nte rf er ence , an d
2. This device mu s t ac cep t any interference re ceived, inclu di n g inter f er en ce th at may cau se u ndesired
operation.
The device is certified to the requirements of RSS-1 39-1 and RSS-210 for 2.4-GH z spread spec trum devices. The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regu lations. For further informat ion, contact your loc al In dustr y C anad a office.
OL-2155-01
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
B-3
Appendix B Declarations of Conformity and Regulatory Information

European Community, Swit zerland, Norway, Iceland, and Liechtenstein

Beta Draft 1 - Cisco Confidential
European Community, Switzerland, Norway, Iceland, and Liechtenstein

Declaration of Conformity with Regard to the R&TTE Directive 1999/5/EC

B-4
This equipment is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-2155-01
Appendix B Declarations of Conformity and Regulatory Information
Beta Draft 1 - Cisco Confidential
The Declarati on of C onform i ty r ela ted t o this pr oduct can be f ound a t t h e foll owing UR L: http://www.ciscofax.com
For the 1200 series, the following standards were appli ed:
Radio: EN 300.328-1, EN 300 .328-2
EMC: EN 301 489-1, EN 301 489-17
Safety: EN 60950
The following CE m ark is affixed to the 1200 ser ies e quipm en t:
The above CE mark is required as of A pril 8, 200 0 but might chan ge in the future
Note This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to
certain frequencies and/or may require a license for operation. For more details, contact Cisco Corporate Compliance.

Declaration of Conformity for RF Exposure

Note Combinations of power lev els and antennas resulting in a radiated po wer le v el of abo ve 1 00 mW eirp are
considered as not compliant with the above mentioned directive and are not allowed for use within the European community and countries that have adopted the European R&TTE directive 1999/5/EC and/or the CEPT recomm enda tio n R ec 7 0. 03. For mo re d eta ils on legal com bi nat ions of power levels and antennas, con tact Cisco Co rpor ate Comp lia nce .
Declaration of Conformity for RF Exposure
The radio module has been evaluated under FCC Bulletin OE T 65C and found co mplia nt to the requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and 15.247 (b) (4) addressing RF Exposure from radio freq uency devices. For ant enna s AI R-AN T412 1 a nd AIR -AN T19 49, th e eq uipme nt shou ld be positioned more than 2 m from your body or ne arby person s. For all other ap proved antenna s the equipment shoul d be i nsta lled mo re t han 20 cm f rom y our b ody or n ea rby perso ns.
OL-2155-01
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
B-5
Appendix B Declarations of Conformity and Regulatory Information

Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan

Beta Draft 1 - Cisco Confidential
Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan
This section provides guidelines for avoiding interference when operating Cisco Aironet access points and bridges in Japan. These guidelines are provided in both Japanese and English.

Japanese Translation

English Translation

This equipment op erates in the same freque ncy bandwidth as industrial, scientific, and medical devices such as microwave ovens and mobile object identification (RF-ID) systems (licensed premises radio stations and un licen sed sp eci fied low-power radio st atio ns ) use d in fac tory p rod uctio n l ine s.
Contact Number: 03-5549-6500
03-5549-6500
43768
1. Before using this equipment, make sure that no premises radio stations or specified low-power radio
stations of RF-ID are used in the vicinity.
2. If this equipment causes RF interference to a premises radio station of RF-ID, promptly change the
frequency or stop u s ing th e device; co nt ac t th e n umb er b elow an d as k fo r r e com mend at ion s on avoiding radio interference, such as setting partitions.
3. If this equipment causes RF interference to a specified low-power radio station of RF-ID, contact
the number below.
B-6
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-2155-01
Loading...