360 Herndon Parkway
Suite 1400
Herndon, VA 20170
http://www.rheintech.com
23 MANUAL
Certification Report For: Cisco System Page 40
Document Number: 2001041 Revision 3
APPENDIX
C
Declarations of Conformity and
Regulatory Information
This appendix provides declarations of conformity and regulatory information for
the Cisco Aironet AIR-MPI352.
The following topics are covered in this section:
• Manufact urer s F e deral Communi cat io n Co m mi s sio n D ecl ar at io n of
Conformity Statement, page C-2
• Industry of Canada Spectrum Management, page C-3
• Safety Information for the AIR-MPI352, page C-4
• European Co mmuni ty, Switzerland , Norway, Iceland, and Liec htens tein,
page C-6
• Declar a ti on of Conf or m i ty for RF Ex p os u r e , page C-8
OL-XXXX-0X
Cisco Aironet AIR-MPI352
C-1
AppendixC Declarations of Conformity and Regulatory Information
Manufacturers Feder al Communi cation Commission Declaration of Conf ormity St atement
Manufacturers Feder al Communication Commissi on
Declaration of Conformity Statement
T ested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
Models: AIR-MPI352
FCC Certificati on Number: LDK102042
Manufacturer: Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
C-2
This device complies with Part 15 rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful in ter f er en ce, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested an d f ou n d to co m pl y with the lim i ts of a Cl ass B
digit al device, purs uant to Part 15 of the FC C Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a residential environment. This equipment generates, uses, and
radiates r ad io freq ue ncy en ergy, and if not in stal led and used in acco rd an ce wi th
the instru cti o ns, m a y cause harmful in te rfer en ce. However, there is no guarantee
that interference will not occur. If this equipment does cause interference to radio
or television reception, which can be determined by turning the equipment off and
on, the u ser i s en co urag ed to correct the in te rf e re nc e by o ne o f th e f ol lowin g
measures:
• Reorient o r re lo cat e t he receiving anten n a.
• Increase separation bet we en th e equipment a nd r eceiver.
Cisco Aironet AIR-MPI 352
OL-XXXX-0X