Solar Battery Charger
Instruction Manual
PLEASE READ ALL THE INSTRUCTIONS COMPLETELY BEFORE USE
AND SAVE THIS MANUAL FOR FUTURE REFERENCE.
Quick Start Guide
1. Open the plastic cover.
2. Place two batteries of same type, size and brand into
the Solar Battery Charger according to the labeled
compartments. The compartment next to the meter is used
for the new “GUM” (Prismatic) sized batteries (see Fig. 1).
Upper Compartment Holds “C”,
“AA”, or “AAA” Batteries
Charge Rate Gauge
Fig. 1 Top View, Cover Open
Middle Compartment
Ring
Lower Compartment Holds the
New GUM/ Prismatic Batteries
Holds “D” Batteries
AA
AAA
Size
Size
D Size
(GUM) Size
C
Size
Prismatic
Note: To prevent “AAA” or “AA” batteries from slipping
out of their compartment, lift the small ring (“AAA”),
or the large ring (“AA”), and slide one battery under the
ring. Then pull the vertical metal connector to the left to
insert the second battery (see Fig. 2).
Quick Start Guide
Fig. 2 Battery Retaining Ring
3. Close the plastic cover.
4. Place the Solar Battery Charger in direct sunlight.
The needle on the Solar Battery Charger should
immediately jump up to indicate that the charging
process has begun. If the needle does not move from its
starting position, open the cover and check to make sure
the batteries have been installed correctly in their correct
compartment (see Fig. 1)
5. The angle of the Solar Battery Charger can be adjusted by
pulling out the foot on the bottom of the cha
panel mounted in the plastic cover should be pointing directly
toward the sun for maximum charge rate (see Fig. 3).
rger. The solar
Fig. 3 Bottom View of Solar Battery Charger
Pull Out Foot
to Adjust
Angle
1001 Main Street
Fortuna, California 95540-2008
800-522-8863 • ccrane.com
Copyright © C. Crane Company, Inc. 2009-2011. All rights reserved.
Manual.SolarBatteryCharger.qxd
Loading...