Canon iR5870C, iR5870Ci, iR6870C, iR6870Ci f-im-6583-000
SUPER G3 FAX Board-U1
Installation Procedure
スーパー G3FAX ボード・U1 設置手順書
Follow the instructions herein when installing the SUPER G3 FAX Boad-U1
its host machine.
本製品を本体に接続する際は、以下の手順に従ってください。
PUB No.F-IM-6583-000 PRINTED IN JAPAN or CHINA
E N G L I S H
日 本 語
1.1 Unpacking and Checking the Components
1.1.1 Unpacking and Checking components
[1]
[2]
[3]
[4]
[5] [6] [7] [8] [9]
F-1-1
[1] Fax unit 1 pc
[2] Speaker unit 1 pc
[3] Speaker relay cable 1 pc
[4] Telephone cord 1 pc
[5] Screw (RS tight; M4X10) 4 pc
[6] Screw (Bind; M4X8) 2 pc
[7] TP screw (M3X6) 2 pc
[8] Modular label 1 pc
[9] Fax Driver CD-ROM unit 1 pc
[10] Sending and Facsimile Guide 1 pc
[11] FCC lavel 1 pc
[10]
[11]
2
1.2 Installation Procedure
1.2.1 Turning Off the Host
1.2.2 Installation Procedure
1) Release a cable from four clamps [1] and discon-
nect the connector [2].
Machine
Turning Off the Main Power
When turning off the main power, be sure to go
through the following in strict sequence to protect the
machine's hard disk:
[1] Hold down on the power switch on the control
panel for 3 sec or more.
[2] Operate on the touch panel according to the shut-
down sequence indicated so that the main power
switch may be turned off.
[3] Turn off the main power switch.
[4] Disconnect the power cable (for the power outlet).
[2]
[1]
F-1-2
2) Detach the rear cover [1].
- 7 screws [2]
[2]
[1]
[2]
F-1-3
3
3) Detach the upper right cover [1].
- 2 screws [2]
[2]
F-1-4
4) Detach the upper right rear cover [1].
- A connector [2]
- 2 screws [3]
[1]
[3]
5) Affix a modular label to the upper right rear cover
[1].
[2] Only Japan
[3] Only Europe
[4] Others than those above
[1]
EXT.
[2]
HAND
SET
LINE 1
LINE 2
F-1-5
[2]
[1]
[3]
[3]
LINE 1
LINE 1
LINE 2
[4]
F-1-6
4
6) Cut out the blanking area [1] with nippers and the
like.
8) Detach the controller box cover [1].
- 16 screws [2]
F-1-7
[1]
[1]
[2]
[2]
[2]
F-1-9
9) Detach the Fax unit cover [1].
- 3 screws [2]
[2]
7) Detach the support plate [1] of rear cover.
- 2 screws [2]
[2]
[1]
F-1-8
Those screws and the support plate are not used fur-
ther.
[1]
[2]
F-1-10
5
Loading...