Canon FM48944 User Manual

Disclaimers

The information in this document is subject to change without
notice.
CANON INC. MAKES NO WARRANTY OF ANY KIND WITH
REGARD TO THIS MATERIAL, EITHER EXPRESS OR IMPLIED,
EXCEPT AS PROVIDED HEREIN, INCLUDING WITHOUT
LIMITATION, THEREOF, WARRANTIES AS TO MARKETABILITY,
MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE
OF USE OR NON-INFRINGEMENT. CANON INC. SHALL NOT BE
LIABLE FOR ANY DIRECT, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES OF ANY NATURE, OR LOSSES OR EXPENSES
RESULTING FROM THE USE OF THIS MATERIAL.

For CA, USA only

Included battery contains Perchlorate Material - special
handling may apply.
See http://www.dtsc.ca.gov/hazardouswaste/perchlorate/ for
details.

Legal Limitations on the Usage of Your Product and the Use of Images

Using your product to scan, print or otherwise reproduce
certain documents, and the use of such images as scanned,
printed or otherwise reproduced by your product, may be
prohibited by law and may result in criminal and/or civil
liability.
A non-exhaustive list of these documents is set forth below.
This list is intended to be a guide only. If you are uncertain
about the legality of using your product to scan, print or
otherwise reproduce any particular document, and/or of the
use of the images scanned, printed or otherwise reproduced,
you should consult in advance with your legal advisor for
guidance.

• Paper Money

• Money Orders

• Certificates of Deposit

• Postage Stamps (canceled or uncanceled)

• Identifying Badges or Insignias

• Selective Service or Draft Papers

• Checks or Drafts Issued by Governmental Agencies

• Motor Vehicle Licenses and Certificates of Title

• Travelers Checks

• Food Stamps

• Passports

• Immigration Papers

• Internal Revenue Stamps (canceled or uncanceled)

• Bonds or Other Certificates of Indebtedness

• Stock Certificates

• Copyrighted Works/Works of Art without Permission of
Copyright Owner

FCC (Federal Communications Commission)

imageCLASS MF5930dn: F161302
imageCLASS MF5950dw: F161302
imageCLASS MF5960dn: F161302
imageCLASS MF5980dw: F161302

This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received,

including interference that may cause undesired operation.

FCC WARNING

Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.

• Properly shielded and grounded cables and connectors

• AC adaptor with ferrite core must be used for RF

NOTE

This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

• Connect the equipment to an outlet on a circuit different

• Consult the dealer or an experienced radio/TV technician

This transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment and meets the FCC
radio frequency (RF) Exposure Guidelines in Supplement C
to OET65. This equipment should be installed and operated
keeping the radiator at least 20cm or more away from person’s
body (excluding extremities: hands, wrists, feet and ankles).
Use of shielded cable is required to comply with class B limits
in Subpart B of Part 15 of the FCC Rules. Do not make any
changes or modifications to the equipment unless otherwise
specified in this manual. If you make such changes or
modifications, you could be required to stop operation of the
equipment.

Canon U.S.A., Inc.

One Canon Plaza, Lake Success, NY 11042, U.S.A.

TEL No. 1-800-OK-CANON

Users in the U.S.A.

Pre-Installation Requirements for Canon Facsimile Equipment

A. Location

B. Order Information

must be used for connection to host computers and / or
peripherals in order to meet FCC emission limits.

interference suppression.

receiver.

from that to which the receiver is connected.

for help.

Supply a suitable table, cabinet, or desk for the machine.
See Chapter 11, “Appendix,” for specific dimensions and
weight.

1. A single telephone line (touch-tone or rotary) should be
used.

2. Order an RJ11-C telephone wall jack (USOC), which
should be installed by the telephone company. If the
RJ11-C wall jack is not present, telephone/facsimile
operation is not possible.

xiv