Campbell Hausfeld AL2275, AL2270 User Manual

Assembly Instructions AL2270 and
and Parts List AL2275

Please read and save these instructions. Read carefully before attempt­ing to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure
to comply with instructions could result in personal injury and/or proper­ty damage! Retain instructions for future reference.

Paint
Rollers

Operation

Do not remove spray tip to attach roller
until all pressure is released and sprayer

switch is turned off.

ROLLER ATTACHMENT

1. Remove spray tip from the gun.

2. Place sealing washer in the roller attachment fitting.

For parts, product & service information

visit www.chpower.com

© 2002 Campbell Hausfeld/Scott Fetzer IN453401AV 11/02

Sealing Washer

Figure 1

BUILT TO LAST

!

CAUTION

Operation (Continued)

3. Connect roller to gun and position at desired angle. Tighten
with wrench.

PRESSURE ADJUSTMENT

1. For units with a single prime/pressure control, turn

the control knob approximately one turn from the prime
position.

IMPORTANT: Very little pressure is required for rolling.

2. Set sprayers with separate pressure control at lowest pressure
which provides a steady flow of paint.

PAINT APPLICATION

1. Trigger gun until paint appears on roller.

2. Roll roller on wall until roller is saturated.

3. Begin painting and trigger often enough to keep rolling
smooth and effortless.

Maintenance

1. Remove the slotted bolt and pull the cover off.

www.chpower.com

Figure 2

End Caps

Roller

Cover

2

453401 1102 11/12/02 3:02 PM Page 2

www.chpower.com

Maintenance (Continued)

2. Remove parts from frame and clean separately. Hot, soapy

water is best for cleaning if latex paint was used.

3. With frame still attached to spray gun, place the end of the

frame into an empty bucket to flush residual paint (See fig­ure 3).

4. Place suction assembly of sprayer into bucket of solvent.

5. Trigger gun until discharge from roller frame is clear.

6. Disconnect frame from gun and let drain.

Figure 3

Insert end
into bucket

3

5. Oprima el gatillo hasta que el rodillo expulse agua pura (sin
residuos de pintura).

6. Desconecte la armazón del rodillo de la pistola y déjela
drenar.

Figura 2

Figura 3

www.chpower.com

For Replacement Parts and Accessories,
Contact Your Local Service Center
or Call 1-800-626-4401

1 - Model AL227050SV

7

6

5

4

3

3

2 - Model

AL227550SV

4

453401 1102 11/12/02 3:02 PM Page 4

www.chpower.com

1 8” Roller frame assembly AL227050SV 1

2 20” Roller frame assembly AL227550SV 1

3 End cap assembly PP201900AJ 2

4 Spacer PP016200AV 1

5 3/8” Roller nap AL040401AV 1

6Washer AL009900AV 1

7 Slotted bolt ST071616AV 1

Ref.
No. Description Part No. Qty.

Please provide the following information:

- Model number

- Serial number

- Part description and number as
shown in parts list

Address parts correspondence:

The Campbell Group
Attn: Parts Department
100 Production Drive
Harrison, OH 45030

5