Bush W60A2A411B, W60B3A411B0-E2 Instruction manual

Page 1
258/8324
Page 2
2-3
4
5-11
5-7 8 9 9 9 10
11
12-20
12-14 12-13 14 15
16-18 19
20
21
21
Specification
22
22
23
24
25
DWFS147SS
Page 3
Page 4
Page 5
W
9
10
9 Inlet pipe connector 10 Drain pipe connector
255/8324
Page 6
Page 7
Hop Ho ok
Page 8
Note:The consideration strip is not included.
7
Page 9
Adjusting the tension of the door spring
The doo r of the d ishw ashe r is att ache d to spr ings . The se are s et at th e fact ory to e nsur e that t hey ar e at the p rope r tension, so that t he doo r can op en and c lose s moot hly.
After t he fur nitu re doo r has be en fit ted, y ou wil l need t o adju st the t ensi on of th e door spring.
Fully o pen th e appl ianc e door t o allo w acce ss to th e adju stin g scre ws.
Top right ten sio n adjusti ng sc rew
Using a 4mm Allen key, rotat e the ad just ing sc rew wh ich ar e loca ted on t he fro nt top c orne rs of th e appl ianc e, to ei ther tight en or sl acke n the st eel ca ble.
The doo rs spr ing te nsio n is cor rect w hen a) The door re main s hori zont al whe n in the f ully o pene d posi tion . b) You are able to shut the door easily, by rai sing t he doo r usin g your f inge rs.
WAR NING : If you d o not ad just t he ten sion o f the do or spr ing, t hen it c ould c ause d amag e to the appliance.
8
Page 10
50
91011
Page 11
Page 12
Page 13
2kg
2
1
2
12
Page 14
The unit is equipped with a function that you can adjust the frequency to release the salt to the water softener. This is further to the selector on the salt container. The default setting is H4.
IMPORTANT :
YOU SHOULD SET THIS VALUE ACCORDING TO THE WATER HARDNESS OF YOUR AREA BEFORE THE 1 USE.
ST
INCORRECT SETTING WILL AFFECT THE RESULT OF THE WASHING. ONCE YOU HAVE SET THE SETTING, THE UNIT WILL REMEMBER THE LAST SETTING.
Adjustment for value
1. Find out the hardness value for your tap water or your area.
2. Compare with the table below to find out the required value for setting to this unit. Table
Value f or selec tin g in this un it
Frequ enc y to relea se sa lt
Never
Seldo m
Somet ime s
Somet ime s
Often Often
Usual ly
Alway s
3. Close the door
4. Press ON/OFF button to turn on the machine
5. Press Delay button and Program button at the same time and hold for 5 seconds. The machine will sound once. It displays H4.You can release both buttons.
6. Continue to press Delay button to select the desire value, i.e. H5, H6 or H7 is for serious water hardness area region like UK.
7. Once the desire value is selected, press Program button to confirm. Then the setting has been stored and it will get back to the normal standby status.
Hint : For easy setting on this value, it is suggested to select H7. Then you can control the salt consumption by turning the selector on the salt container.
13
Page 15
14
Page 16
15
Page 17
appliance
Page 18
appliance
Cutlery tray
Cutlery should be placed in the cutlery tray as shown in diagram. They should be placed in different area zone to ensure the water runs off freely.
17
!
WA RN ING !
Do not le t any ite m ext en d th ro ug h bo tt om
Page 19
appliance
18
Page 20
Standard daily c ycle for normally soi led loads, such as pots, plat es, glasses.
19
Page 21
button.
Continu e to press “ progra m” butto n until the desire washing program is selected. Once the desi red washing program is select ed, clos e the door a nd the machine will start to operate.
The unit wi ll produ ce a click s ound whe n the door is closed properly. When t he washi ng is finished, you can swi tch it off by pres sing the O N/OFF button once.
1.
Table
NOTE: Delay fun ction: Af ter sele cting the wash cycle program, you can set the desired delay time by pressing the dela y time but ton. You can s elect 1- 24h from t he progr am. Th e dishwa sher wil l start ope ration a fter the selected delay time is elapsed.
NOTE: Chi ld safet y lock function To lock, open the door, pr ess Chil d Lock but ton for 3 se conds. The "Ch ild lock " indica tor lights up a fter fla shing 6 ti mes. To unlock, open the doo r, press Ch ild Lock b utton fo r 3 second s. The u nit will g et back to n ormal status an d ''Chil d lock '' in dicato r will be go ne.
NOTE : "3 in1 " functi on "3 in 1" is a spe cial des igned pr ogram to u se the 3 in 1 di shwash er table t. You can buy t he table t in the high stre et. Add the t ablet in to the detergent box and do not need to fill the sa lt & rinse -aid. Pr ess once on the 3 in 1 but ton and th e indica tor will i llumin ate. Then sele ct the was hing pro gram as us ual.
If you open t he door wh en washi ng, the ma chine pa uses and sounds warning alarm, it displays E1.
Under different statu s, the pro gram ind icator w ill ligh t in different c ombina tion:
Program End
1.When th e washin g progra m is finis hed, it will sound 6 times and displays ''- - ''.
2. Open the d oor and re move all t he dishe s.
3.Tu rn off t he unit by p ressin g the ON/OFF sw itch. Then close the doo r.
4. Shut dow n the wate r supply after using.
Special attenti on : If all the in dicato r lights start to glimmer, the machine should be out of or der. Plea se turn off the power and shut do wn the wat er suppl y. Then call the custom er helpl ine.
Warn ing : It is dange rous and n ot recom mend to open the door during the washing operation. The hot water may come out an d scald yo u while th e door is op en durin g the oper ation.
20
Page 22
21
Page 23
Error
22
Page 24
Technical specifications (according to EU Directive 1059/2010)
Brand
Model
Capacity
Energy efficiency class
Annual energy consumption
Energy consumption of the standard cleaning cycle
Power consumption of off-mode/left-on mode
Annual water consumption
Drying efficiency class
Standard cleaning cycle
1
2
A++
0.93 kWh
0.1W/0.9W
3
4
5
Program time for the standard cleaning cycle
Noise level
Freestanding/Built-in
Dimension
Built-in
Power consumption
Rated voltage
BUSH
DWFS147SS
14 settings
266kWh
3080 litre
A
Eco
178 min
49 dB(A) re 1 pW
W596xD555xH820
1850W
220-240V~50Hz
Water pressure(flow pressure)
NOTE
1
A+++(most efficiency) to D(least efficiency)
2
Energy consumption “266"kWh per year, based on 280 standard cleaning cycle using cold water fill and the consumption of the low power nodes. Actual energy consumption will depend on how the appliance is used.
3
Water consumption “3080" litres per year, based on 280 standard cleaning cycle. Actual water consumption will depend on how the appliance is used.
4
A(most efficiency) to G(least efficiency)
5
This program is suitable for cleaning normally soiled tableware, and that it is the most efficient programme in terms of its combined energy and water consumption for that type of tableware.
The above values have been measured in accordance with standards under specified operating conditions amount of detegent,etc.
0.04-1 MPa
23
Page 25
24
Page 26
Argos Ltd
Loading...