Bush BAS950BT Instruction Manual

or on the remote

control to turn the BAS950BT on.

Thank you for buying this BUSH product, which is designed to give you many years of
trouble-free service.

You may already be familiar with using a similar unit, but please take time to read these
instructions. They are designed to familiarise you with t he unit's many features and to
ensure you get the very best from your purchase.

Safety is important

Your safety and the safety of others is important.
Please therefore, ensure you read the "Safety Instructions" before you operate this unit.

Warranty

In the unlikely event that your product fails to work normally, please call the below free
phone number to discuss the problem with o

.

ne of our qualified service engineers

Bush Warranty: 1300 055 518

INTRODUCTION

12

11

1. Outp ut Po wer : 80W + 40W x2

2. Spea ker S ize : - 6.5 inch

: Soundbar - 3 inch x 4

3. Freq uen cy Respons e : - 20 Hz~85Hz

Sound Bar - 85Hz~20KHz

4. S/N Ra tio : ≥ 7 3 db

5. Input Sensitivity : - 3 50 mV +/- 20 mV

Sound Bar - 55 0 mV+/- 50mV

6. Impedan ce : - 4

Soundbar - 8

7. TH D : <0.5% (1KH z, 1W)

8. Powe r Sup ply : AC 230V~50Hz

Subwoofer

Subwoofer

Subwoofer

Subwoofer Ω

Ω

Note: Specifications are subject to change for improvements.

SPECIFICATIONS

Warranty

Please keep your receipt as proof of purchase. This product is warranted for any defect

in materials or workmanship for one year afte r the original date of purchase. This product
is for normal domestic and office use only. This warranty does not cover damage from
misuse or neglect, accidental damage, vermin infestation, excessive voltages such us
lightning or power surges or any alternation that affects the performance or reliability of
the product.

In the unlikely event that your product fails to work normally, please contact the

Bush Warranty on

This warranty is subject to the following provisions:

It is only valid within boundaries of the country of purchase

The product must be correctly assembled and operated in accord ance wit h the
instructions contained in the manual

This product must be used solely for domestic purposes

The warranty does not cover accidental damage

The warranty will be rendered invalid if the product is resold or has been damaged by
inexpert repair

The manufacturer disclaims any liability for incidental or consequential damaged

This warranty is in addition to, and does not diminish, your statutory or legal rights .

PO BOX 6287
Silverwater NSW 1811

Bush Warranty:

www.bushaustralia.com.au

CAUTION

!

!

RISK OF ELECTRIC SHOCK

DO NOT OPEN

SAFETY INFORMATION

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL,
WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED
TO ALERT THE USER TO THE PRESENCE OF
UNINSULATED, "DANGEROUS VOLTAGE", WITH IN THE
PRODUCTS ENCLOSURE THAT MAY BE OF SUFFICIENT
MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC
SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL
TRIANGLE IS INTENDED TO ALERT THE USER TO THE
PRESENCE OF IMPORTANT OPERATING AND MAINTE­NANCE (SERVICING) INSTRUCTIONS IN THE LITERA­TURE ACCOMPANYING THE APPLIANCE.

Safety Precautions

WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK. DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

1

10

TROUBLE SHOOTING GUIDE

If the subwoofer is not linking properly with the soundbar or there i s no sound

coming from the subwoofer please follow the below steps:

1) Press the "

STANDBY" button on soundbar or on the remote control, and

switch off the subwoofer.

2)

After 15 seconds the coding

should be completed and the subwoofer will be connected to the soundbar

wirelessly. (You can confirm this by the blue light on the front of the

subwoofer. If the soundbar and subwoofer are connected the blue light wi ll

be solid but if it is flashing then the subwoofer and soundbar are n ot

connected.)

Press the "

STANDBY" butto n on soundbar or on t he remote control again,

the soundbar gets into play-mode.And then switch on the subwoofer wi thin

15 seconds after you pressed "STANDBY".

3) Please repeat the above steps if the soundbar is not connecting to t he

subwoofer wirelessly.

4) Once the above steps have been completed and the soundbar is

connected to the subwoofer the settings will automatically save and the re

should be no need to follow the above steps again unless the product is

disconnected from the mains power.

9

SYSTEM CONNECTION INSTRUCTIONS

TV

Video In

Video Out

Rear-R

Center

Woofer

Rear-L

Front-L

Front-R

DVD Player

Optical

Audio Out

Rear-R

Center

Woofer

Rear-L

Front-L

Coaxial

Front-R

Video Out

Scart out

Video

S-Video U

VY

Manufactured under license from Dolby Laboratories.

"Doldy","Dolby Digital", and the double-D symbol are

trademarks of Dolby Laboratories. Confidential

Unpublished Works.

@1992-1997 Dolby Laboratories, Inc.

All rights reserved.

Apparatus Claims of U.S. Patent Nos.
4,631,603;4,577,216;4,819,098 and 4,907,093
licensed for limited viewing uses only.

RISK OF ELECTRIC SHOCK

DO NOT OPEN

WARNING

!

AC 100V~240V
50/60Hz

Video

RCA Cable

To Stereo Output

Audio Out

Caution: Please read carefully all the following important safeguards to en­sure safe operation.

1. Read Instructions - All the safety and operating instructions should be
read before the appliance is operated.

2. Retain Instructions - The safety and operating instructions should be
retained for future reference.

3. Follow Instructions - All operating instructions should be followed.

4. Heed Warnings - All warnings on the appliance and in the operating
instructions should be adhered to.

5. Power Source - The appliance should be connected to a power supply
only of the type specified in the operating instructions or as marked on
the appliance.

6. Power-cord Protection - Power-supply cords should be routed so that
they are not likely to be walked on or pinched by items placed upon or
against them, pay particular attention to cords at plugs, convenience
receptacles, and the point where they exit from the appliance.

7. Water and Moisture - The appliance should not be used near water
(for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a
wet basement, or near a swimming pool, etc.)

8.Ventilation - The appliance should be situated so that its location or
position does not interfere with its proper ventilation. Do not use the
appliance on a bed, sofa, rug or similar surface that may block the
ventilation openings.

IMPORTANT SAFEGUARDS

2

registers, stoves, or other appliances (including amplifiers) that produce heat.

10. Nonuse Periods - The power cord of the appliance should be unplugged
from the outlet when left unused for a long period of time.

11. Damage requiring service - The appliance should be serviced by qualified
service personnel when:

a/ The power-supply cord or the plug has been damaged;
b/ Objects have fallen or liquid has been spilled into the appliance;
c/ The appliance has been exposed to rain;
d/ The appliance does not appear to operate normally or exhibits a marked
change in performance;
e/ The appliance has been dropped, or the enclosure damaged.

12. Servicing - The user should not attempt to service the appliance beyond
that specified in the operating instructions. All other servicing should be
referred to qualified service personnel.

13. Clean only with dry cloth.

14. Do not defeat the safety purpose of the polarized or grounding type
plug. A polarized plug has two blades with one wider than the other. A
grounding type plug has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. If the provided plug
does not fit into your outlet, consult and electrician for replacement of the
obsolete outlet.

15. Unplug this apparatus during lightning storms or when unused for
long periods of time.

9. Heat - Keep the appliance away from heat sources such as radiators, heat

IMPORTANT SAFEGUARDS

3

REMOTE CONTROL

8

1.Replace the remote control battery when it no longer operates the
unit, or the range is reduced considerably.

2.Use only Cr2025 3V lithium batteries

3.Bear in mind that lighting & other room conditions, in addition to
battery age, can affect the operating range of an infrared remote control.

REMOTE CONTROL BATTERY REPLACEMENT

1. : Power Standby.STANDBY

6.VOL-: Volume Downward Adjustment Button.

9.INPUT: Input Button .

Selection

4.PREV: Play previous song.

5.NEXT: Play next song.

2.MUSIC: Music Mode .

Selection

3.NORMAL: Normal Mode .

Selection

7.BASS-: Bass Downward Adjustment Button.

8.TREBLE-: Treble Downward Adjustment Button.

14.PLAY and PAUSE: Play/Pause song .

13.STOP: Stop the song .

11.RESET: Reset sound settings to default.

12.MOVIE: M ovie Mode .

Selection

15.VOL+: Volume Upward Adjustment Button.

16.BASS+ : Bass Upward Adjustment Button.

17.TREBLE+: Treble Upward Adjustment Button.

10.MUTE: Mute Function Button .

/Bluetooth Esc.

REMOTE CONTROL

7

FRONT PANEL - CON TROLS AND FUN CTIONS

4

2

345

2. : Power Standby STANDBY Button.

3.INPUT:Input Selection Button.

4.VOL-: Volume Downward Adjustment Button.

5.VOL+: Volume Upward Adjustment Button.

6

6. STANDBY:Subwoofer Standby Input Indicator.

11
12

13

2
3

4

5
6

7

8

9
10

1

14
15

16

17

1

1.USB Jack.

REAR PANE L - CONTRO LS AND F UNCTIONS

65

1. AUX Stereo Audio Input.Right

2. AUX Stereo Audio Input.Left

REAR PANE L - CONTRO LS AND F UNCTIONS

2

3

4

1

4. TV Stereo Left Audio Input.

3. TV Stereo Right Audio Input.

5. AC Power Cord.( )SOUND BAR

6. Power On/Off Switch.(SUBWOOFER)

7. AC Power Cord.(SUBWOOFER)

5

6

7

Made In China

BAS95 0BT

2.4GHz DIGI TAL WIREL ESS SOU NDBAR S YSTEM

Max Total Powe r Consu mptio n:160 W

Output Pow er: Sou nd bar: 40W x 2

Subwoofer : 80W x 1

Power Supp ly: AC 230 V~50H z
Speaker Un it

: Sound bar : 3

Subwoofer : 6 .5 x 1

Impedanc e

: Sound bar : 8( )

Subwoofer : 4 ( )

x 4

Ω
Ω

BUSH WARRAN TY 1300 05 5 518