Broan MP200 Specifications

SPECIFICATION SHEET

MODELS MP100, MP140, MP200 & MP280 MULTI-PORT REMOTE IN-LINE VENTILATORS

Improves overall indoor air quality throughout all levels of the house.

FEATURES

BLOWER:

• High pressure, centrifugal blowers accommodate many ducting configurations

• Motors designed for continuous operation

• Permanently-lubricated motors assure worry-free operation

• Permanent Split Capacitor (PSC) motors are used for quiet operation and low power consumption

• Plug-in motor rated at 120 VAC, 60 HZ operation

• HVI certified to assure consistent operating performance

HOUSING:

• Rugged 20 gage steel housing finished with electricallybonded epoxy paint

• May be installed in virtually any orientation - ceiling, wall or floor

• In-line installation assures quiet operation

• Easily removable panel permits quick access to blower for cleaning and servicing without disturbing ductwork

• (4) 4" round inlets and 6" round outlet for easy duct connections

• All wiring and ductwork can be connected from the outside of the housing - no need to remove access panel or blower.

TYPICAL SPECIFICATION

The in-line ventilator shall be Broan Model MP100 (Broan Model MP140) (Broan Model MP200) (Broan Model MP280).

Ventilator to have steel housing with cover that permits quick access to blower for cleaning or service, without removing ductwork. All wiring to be done from outside of housing. Unit will allow connection of up to (4) 4" round inlet ducts and a 6" round outlet duct.

Blower shall be designed for continuous operation using a permanently lubricated, PSC (Permanent Split Capacitor) motor and a centrifugal blower wheel.

Unit to be U.L. listed, CSA certified, and HVI certified.

MODELS MP100 MP140 MP200

Broan-NuTone LLC, 926 West State Street, Hartford, WI 53027 (1-800-637-1453)

REFERENCE QTY. REMARKS Project

Location

Architect

Engineer

Contractor

Submitted by Date

MODEL MP280

10D 99041954E

PERFORMANCE RATINGS - MODELS MP100, MP140, MP200 & MP280

AMCA LICENSED PERFORMANCE

Model CFM @ Static Pressure (Ps - Inches of H20) Nominal Duct

No. 0.0 0.2 0.25 0.4 0.6 0.8 Volts Amps RPM Size MP100 120 110 107 97 81 - 120 .5 2750 6" RD MP140 164 150 145 133 115 103 120 .8 2950 6" RD MP200 224 210 208 200 189 174 120 1.3 2950 6" RD MP280 304 290 284 265 230 190 120 2.5 1650 6" RD

The performances shown are with inlet grille, backdraft damper and outlet duct. RPM shown is nominal and the performance is based on actual speed of test.

"Broan-NuTone LLC certifies that the models shown herein are licensed to bear the AMCA Seal. The ratings shown are based on tests and procedures performed in accordance with AMCA Publication 211 and comply with the requirements of the AMCA Certified Ratings Program."

HVI PERFORMANCE

MODEL CFM

NUMBER .2" Ps .4"Ps

MP100 110 98 MP140 150 141 MP200 210 200 MP280 290 265

HVI-2100 CERTIFIED RATINGS comply with new testing technologies and procedures prescribed by the Home Ventilating Institute, for offthe-shelf products, as they are available to consumers. Product performance is rated at 0.1 in. static pressure, based on tests conducted in AMCA’s state-of-the-art test laboratory. Sones are a measure of humanly-perceived loudness, based on laboratory measurements.

MP100

WEIGHT

MODEL SHIPPING

NO. WT.

MP100 15.8 lbs. MP140 16.2 lbs. MP200 16.3 lbs. MP280 30.5 lbs.

SELECTION GUIDE

DWELLING SIZE RANGE (Sq. Ftg.)

(include finished basement area)

MODEL

MP100 MP140 MP200 MP280

*AC/HR = Air Changes per Hour Based on 8' ceilings, CFM @ .25Ps

SQ. FT. X 10.764= M

.50 AC/HR* .35 AC/HR* .30 AC/HR*

1590 2271 2650 2235 3192 3725 3120 4457 5200

4260 6085 7100

MP140

STATIC PRESSURE (IN. WG.)

AIR FLOW RATE (CFM)

MP200

STATIC PRESSURE (IN. WG.)

AIR FLOW RATE (CFM)

MP280

STATIC PRESSURE (IN. WG.)

AIR FLOW RATE (CFM)

Broan-NuTone LLC, 926 West State Street, Hartford, Wisconsin 53027 (1-800-637-1453)