Breville BPM500 User Manual
Pasta Emporia
Fresh Pasta Emporia
Instructions
and Recipes
BPM500
Contents
Page
Breville recommends safety first 4
Know your Breville Pasta Emporia 6
Assembling and using your Breville Pasta Emporia 7
Disssembling your Breville Pasta Emporia 12
Care, cleaning and storage 13
Trouble shooting guide 14
Recipes R1
2
Congratulations
on the purchase of your new Breville Pasta Emporia
3
Breville recommends safety first
We at Breville are very safety conscious. We design and manufacture consumer products with the
safety of you, our valued customer, foremost in mind. In addition we ask that you exercise a degree of
care when using any electrical appliance and adhere to the following precautions:
IMPORTANT SAFEGUARDS FOR YOUR BREVILLE PASTA EMPORIA
Carefully read all instructions before operating
•
the Pasta Emporia and save for future
reference.
Remove and safely discard any packaging
•
material and promotional labels before using
the Pasta Emporia for the first time.
To eliminate a choking hazard for young
•
children, remove and safely discard the
protective cover fitted over the pins of the
power plug when unpacking this Pasta
Emporia for the first time.
Do not place the Pasta Emporia near the
•
edge of a bench top, counter or table during
operation. Ensure the surface is level, clean
and free of water, flour and other substances.
Do not place this Pasta Emporia on or near a
•
hot gas or electric burner, or where it could
touch a heated oven.
Do not place any part of the Pasta Emporia in
•
a gas, electric or microwave oven or on a hot
gas or electric burner.
The Pasta Emporia is not intended to be
•
operated by means of an external timer or
separate remote control system.
Do not use the Pasta Emporia on a sink drain
•
board
Do not leave the Pasta Emporia unattended
•
when in use.
Do not attempt to operate the Pasta Emporia
•
by any method other than those described in
this booklet.
Always ensure the Pasta Emporia is
•
completely assembled before operating. The
Pasta Emporia will not operate unless properly
assembled.
Do not use attachments other than those
•
provided with the Pasta Emporia.
Ensure the on/off switch has been pressed
•
to the off position, and the Pasta Emporia
is switched off at the power outlet and
unplugged before assembling.
Vibration during operation may cause the
•
Pasta Emporia to move.
Do not push food into the extrusion chamber
•
with your fingers or other utensils.
Do not place hands, fingers or utensils in the
•
mixing bin of the Pasta Emporia unless the
motor and mixing paddle have come to a
complete stop. Ensure the ON/OFF switch has
been pressed to off and the Pasta Emporia
is switched off at the power outlet and
unplugged before removing the mixing bin lid
from the mixing bin.
Ensure the motor and the mixing paddle have
•
completely stopped before disassembling.
Ensure the ON/OFF switch has been pressed
•
to off and the appliance is switched off at the
power outlet and unplugged when not in use,
if left unattended and before disassembling,
cleaning or storing.
Do not move the Pasta Emporia whilst in
•
operation.
Do not remove the mixing chamber from the
•
motor base whilst in operation.
Ensure care is taken when emptying the
•
mixing chamber and cleaning the mixing
chamber.
Do not use harsh abrasive or caustic cleaners
•
when cleaning this Pasta Emporia.
Keep the appliance clean. Follow the cleaning
•
instructions provided in this book (page 13).
4
Breville recommends safety first continued
IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES
Fully unwind the power cord before use.
•
Do not let the power cord hang over the edge
•
of a table counter, touch hot surfaces or
become knotted.
To protect against electric shock do not
•
immerse power cord, power plug or motor
base in water or any other liquid
This appliance is not intended for use by
•
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance by
a person responsible for their safety.
Children should be supervised to ensure they
•
do not play with the appliance.
It is recommended to regularly inspect the
•
appliance. Do not use the appliance if power
cord, power plug or appliance becomes
damaged in any way. Return the entire
appliance to the nearest authorised Breville
Service Centre for examination and/or repair.
Any maintenance other than cleaning should
•
be performed at an authorised Breville Service
Centre.
This appliance is for household use only. Do
•
not use this appliance for anything other than
its intended use. Do not use in moving
vehicles or boats. Do not use outdoors. Misuse
may cause injury.
The installation of a residual current device
•
(safety switch) is recommended to provide
additional safety protection when using
electrical appliances. It is advisable that a
safety switch with a rated residual operating
current not exceeding 30mA be installed in
the electrical circuit supplying the appliance.
See your electrician for professional advice.
During the mixing process, ingredients may stick
to the sides of the mixing chamber. To free sticky
ingredients from sticking, press the ON/OFF
switch to the ‘OFF’ position and switch the
power ‘OFF’ at the power outlet. Unplug the
power cord. Remove mixing chamber lid and
use a plastic spatula to scrape down the sides
of the mixing chamber. Replace lid before
recommencing mixing.
If the mixing paddle become stuck, immediately
press the ON/OFF switch to the ‘OFF’ position
and switch the power ‘OFF’ at the power outlet
and unplug the power cord. Remove the lid and
use a plastic spatula to dislodge the food from
mixing paddle. Replace lid before
recommencing mixing.
Note
Note
CAUTION: ENSURE THAT PASTA EMPORIA IS SWITCHED OFF BEFORE REMOVING IT FROM THE
MOTOR BASE.
CAUTION: SWITCH OFF THE PASTA EMPORIA AND DISCONNECT FROM POWER SUPPLY BEFORE
CHANGING ACCESSORIES OR APPROACHING PARTS THAT MOVE IN USE.
5
Know your Breville Pasta Emporia
Built-in removable measuring spoon
Transparent viewing window
8 pasta discs plus biscotti disc
Cord storage
Non-slip feet for stability
Pasta cutting knife
Pasta disc cleaning accessory
6
Pasta disc
varieties
Know your Breville Pasta Emporia continued
Mixing paddle - effectively
mixes the dough to the correct
consistency
Mixing chamber lid with removable
measuring spoon
Mixing chamber - removable, large
clear chamber which sits inside the
motor base
Extrusion chamber - dough enters
this chamber once it has reached
the correct consistency and the
slider has been pulled
Spiral extruding rod - pushes dough
through the extrusion chamber
Disc holder - holds the pasta disc in
place. Turn clockwise to tighten and
counter clockwise to remove
Steel rod - inserted into the mixing
paddle
Slider - keeps dough in the mixing
chamber until ready to extrude
7
Assembling and using your Breville Pasta Emporia
Making homemade pasta is easy with the Pasta
Emporio but requires a bit of patience on your
first few batches.
Many gourmet recipes can be created using
the recipes in this booklet. However, it is
recommended to begin by using a basic
pasta recipe first to master the pasta making
techniques.
It is important to note, that due to the variations
of moisture content in different brands of flour,
it may be necessary to either add or subtract
water from the quantity indicated in the recipe.
Making fresh pasta will not only become easy, it
will also become fun and enjoyable.
Buon Appetito!
Before first use
Before using your Breville Pasta Emporia,
become familiar with all the parts. Remove
and safely discard all packaging materials and
promotional labels.
Wash the mixing chamber, chamber lid, pasta
discs, mixing paddle, spiral extruding rod, disc
holder, steel rod, cleaning tool, knife, measuring
spoon and slider in warm, soapy water.
Rinse and dry thoroughly (refer to cleaning, care
and storage, page 13).
Push the opposite end onto the back opening of
the mixing chamber so that it sits into place.
Insert the thin end of the steel rod into the
opening of the mixing paddle. Push the steel rod
through until it is fully inserted. You may need
to rotate the steel rod slightly in order for it to fit
into place.
Step 3
Guide the mixing chamber into the motor base.
Align the steel rod and the clear arrow to the
hole at the rear of the motor base.
Step 1
Place the Pasta Emporia on a dry, level work
surface.
Step 2 - The mixing chamber
Insert the indented end of the mixing paddle into
the front end of the mixing chamber.
8
Twist and slightly lift the mixing paddle until
it fits comfortably into the slot. Once correctly
inserted, it will “click” into place.
Assembling and using your Breville Pasta Emporia
continued
Step 4 - The spiral extruding rod
Fully insert the steel end of the spiral extruding
rod into the opening of the extruding chamber
and twist it into place.
When inserted correctly, the spiral extruding
rod should not be sticking out of the extruding
chamber.
Note
Step 5 - The pasta disc
Select your desired pasta disc and position the
disc on the opening of the extrusion chamber so
that the grooves of the disc fit comfortably on
the three tabs of the extrusion chamber.
Step 6 – The slider
Insert the slider (rectangular opening side first)
into the slot on the side of the motor base.
Fully push the slider all the way into the motor
base. The slider is now in the ‘mixing position’
as labelled on the slider.
Step 7 – Adding ingredients
Insert the power plug into a 230/240 volt power
outlet and switch the power outlet on.
Ensure the switch on the motor body is in the
‘OFF’ position before turning the power on at the
outlet.
Note
Add flour, egg, oil and/or flavourings (with the
exception of water) (using Basic recipe steps 1
and 2). Ensure slider is fully inserted and in the
‘MIXING’ position.
Pasta disc will sit firmly in position on the
opening of the extrusion chamber when inserted
correctly.
Note
Secure the disc holder over the opening of
the extrusion chamber by tightening it in a
clockwise direction.
Be careful not to over tighten the disc holder.
Note
Water should not be added until the mixing
process has started and the egg and oil are well
combined.
Note
Step 8 - The mixing chamber lid
Ensure the removable measuring spoon is in
position.
Insert the chamber lid by tilting it into the slots
on the chamber lock. Lock the lid by pushing it
down. The lid will ‘click’ into place.
9
Assembling and using your Breville Pasta Emporia
continued
Measuring spoon can be inserted into the lid at
any stage of the assembly process.
Note
When adding water to the flour mixture, pour
water along the entire length of the opening in
the lid. This ensures that the water is distributed
evenly.
Be sure to replace the removable measuring
The Pasta Emporia has a safety feature so that
the appliance will not work unless the mixing
chamber and lid have been securely locked into
position.
Note
spoon when you are finished adding ingredients
to the mixing chamber. This will prevent
ingredients from escaping.
Tip: To prevent ingredients from escaping
the mixing chamber while adding water,
partially cover the opening with the
measuring spoon.
Step 9 - Adding water
Ensure the mixing chamber lid is locked in
position and the power outlet is switched on.
Switch the power ‘ON’ using the ON/OFF
switch to start the mixing process. Mix for
approximately 1 minute.
WARNING: THE MIXING PADDLES TURN
EXTREMELY FAST. DO NOT PLACE YOUR HANDS
INTO THE MIXING CHAMBER UNTIL THE MIXING
PADDLE HAS COMPLETELY STOPPED MOVING.
Remove the measuring spoon and add water
in a slow steady stream using the quantity
required in your recipe (see recipe section of
this booklet).
Do not add all of the water. Hold about 20% of
the water in reserve.
10
Not all water may need to be added due to
varying moisture contents in different flours. Be
careful not to add too much water.
Note
Allow the Pasta Emporia to mix and knead the
dough for approximately 3 minutes or until the
dough resembles small “pea sized” pieces.
It is important to add extra water to the mixing
bin slowly so that the correct dough consistency
can be achieved. If too much water is added, the
dough will begin to stick into a large mass. If
this occurs turn the Pasta Emporia to the ‘OFF’
position and push the slider into the closed
position so flour cannot enter the chamber. Break
the dough up into small pieces, sprinkle it with a
little flour and allow the Pasta Emporio to re-mix
and knead until it resembles the required “pea
sized” pieces of dough (see trouble shooting
page 14).
Note
Loading...