Breville BMO650 User Manual

BMO650 Rating - Artwork, Positional, French Translation Sticker

SHEET 1

DWG NUMBER

BMO650-GRT-2019-V1

BMO650-GRT-2019-V2 14.06.19 Added serial sticker BMO650-GRT-2019-V3 TBA 19 Updated French sticker

DATE PAGES

1-4 (all) 1 (all) 1 (all)

1 (all)S

11.06.19

MODIFICATION DESCRIPTION

First Issue

1 (all)

GLOBAL ARTWORK: COLOUR KEY TO SECTIONS

MAGENTA: ARTWORK GREEN: POSITIONAL

ALTHOUGH ALL CARE IS TAKEN IN THE PREPARATION OF THIS ARTWORK,

FINAL RESPONSIBILITY RESTS WITH YOU THE CLIENT.

CHECKING NOTE FOR BREVILLE GROUP

Please be sure to check the entire artwork carefully, including:

• Graphics that relate to engineering issues, such as calibration and functionality of (but not limited to) switches, LED lights, dials, jugs and vessels, etc.

• Naming and descriptor text, such as wattage graphics, appropriate description, etc.

• Colour specification that relate to engineering issues, such as identifying materials to confirm if parts can be sprayed or moulded to match our swatch, and whether shared tooling will restrict individual parts being moulded to match our swatch, etc.

GRAPHICS NOTE FOR FACTORY

Factory must use our film, and must not recreate artwork. Factory samples will not be approved if graphics do not match our artwork. Fonts must be the same as our artwork, and can not be substituted for other fonts. We will supply film page in digital copy, in EPS and PDF format. If factory requires film in another format, please advise. If factory can not use digital film, please advise and we will forward hard copy via courier.

RED: STICKER

SIGNED OFF BY ENGINEERINGSIGNED OFF BY MARKETING

All graphics specified in this artwork must pass the following adhesion tests:

1. With the graphics in place on the product, scratch firmly with a finger nail with an inward action. There should be no sign of damage to the markings.

2. After test 1, a length of scotch brand tape is to be firmly stuck over the graphics, and rubbed down to ensure maximum adhesion of the tape. Pull away from the surface at 90o at a constant rate. There should not be any evidence of the graphic stuck to the tape.

3. After test 2, rub for 15 seconds by hand with a piece of cloth soaked in water, and again for 15 seconds with a piece of cloth soaked in petroleum spirit (hexane). After this test, check that markings are easily legible, and that the graphics cannot be easily removed and show no signs of becoming detached from the surface to which they are applied.

4. If used for frying/cooking, ink used on this product must be able to withstand the operating temperature and not dissolved by oil.

RESTRICTED & CONFIDENTIAL

This drawing and all information shown hereon are the exclusive property of HWI Electrical, and are submitted only on a confidential basis. The recipient agrees not to reproduce the drawing, to return it upon request, and that no disclosure of the drawing or the information shown hereon will be made to a third party without prior written consent from HWI Electrical.

PRODUCT GRAPHICS ARTWORK

ISSUE

DATE

BMO650-GRT-2019-V3 115-01-0195JOB TBA 19

NOT TO SCALE

RETURN TO BREVILLE PTY LTD

HEAD OFFICE Breville Building, Sydney Corporate Park Suite 2, 170-180 Bourke Road

NSW, 2016 SYDNEY, AUSTRALIA

BMO650 - Artwork for Film

PN: XXXXXXXXXXXX

FILM 1

CAUTION MICROWAVES.

ATTENTION MICRO-ONDES.

REFERENCE LINE ONLY

Graphic is actual size when this line measures 120 mm

USC - BSS Print to Match PMS485 - Print First

NOTE: These graphics must pass all the adhesion tests outlined on Sheet 1 of this artwork.

RESTRICTED & CONFIDENTIAL

PRODUCT GRAPHICS ARTWORK

ISSUE

DATE

BMO650-GRT-2019-V3 115-01-0195JOB TBA 19

NOT TO SCALE

RETURN TO BREVILLE PTY LTD

HEAD OFFICE Breville Building, Sydney Corporate Park Suite 2, 170-180 Bourke Road

NSW, 2016 SYDNEY, AUSTRALIA

BMO650 - Artwork for Film

FILM 2

THIS ISM APPARATUS MEETS ALL REQUIREMENTS OF THE

CANADIAN INTERFERENCE CAUSING EQUIPMENT REGULATIONS.

CE GÈNÈRATEUR DE FRÈQUENCE RADIO ISM RÈSPECTE TOUTES

CAUTION MICROWAVES.

LISTED

ATTENTION MICRO-ONDES.

BREVILLE CANADA L.P.

3595 Boulevard Côte-Vertu, Saint-Laurent, QC H4R 1R2. Canada.

NMB-1

BREVILLE USA INC.

Manufactured Date/Date de

LES EXIGENCES DU RÈGLEMENT SUR LE MATERIEL BROUILLEUR

CANADA.

CAN ICES-1

E364805

ATTENTION:

19400 S. Western Ave, Torrance, CA 90501-1119.

United States of America.

Made in Shunde, China.

Fabriqué in Shunde, China.

FCC ID: 2AAODBMO650

Fabrication: July 2019

AVERTISSEMENT:

Les réparations de cet appareil doivent être effectuées exclusivement par un technicien dûment qualifié.

Consultez le livret d’instructions pour connaître les procédures d’entretien adéquates, vous assurer

qu’elles sont conformes aux normes fédérales de performance pour les fours à micro-ondes et prendre

les précautions contre le risque d'exposition à l’énergie excessive des micro-ondes.

Débrancher l'appareil avant de le faire réparer. Le retrait du boîtier d'un appareil sous tension peut exposer

(B) LA PORTE NE FERME PAS BIEN

le réparateur à un danger potentiel de haute tension.

Pour assurer une protection continue contre les chocs électriques, brancher l'appareil uniquement dans

une prise de courant correctement reliée à la terre.

Certaines pièces internes sont délibérément non reliées à la terre et peuvent présenter un risque de chocs

électriques durant les réparations qui doivent être effecctuées par un technicien qualifié seulement. Ne pas

toucher les pièces suivantes pendant que l’appareil est sous tension : le moteur du ventilateur et le moteur

du plateau tournant.

Cet appareil ne doit pas être encastré.

Risque de chocs électriques. Les attaches fixes sont fournies en raison de la tension interne élevée. Ne pas

(A) UN OBJECT BLOQUE L’OUVERTURE DE LA PORTE

NE PAS UTILISER CE FOUR SI:

retirer ces attaches.

Non destine a l’usage commercial.

REFERENCE LINE ONLY

Graphic is actual size when this line measures 120 mm

www.Breville.com

Standards 21 CFR Subchapter J.

Power Input 120V 60Hz 1350W

This device complies with DHHS Radiation Performance

Single phase with grounding Output Frequency 2450MHz

Microwave Oven (Household) Model BMO650 SIL

Pour toute assistance, visitez

Designed and Engineered in Australia by Breville.

Customer Service USA 1-866-273-8455 CAN 1-855-683-3535

Made in China. Fabriqué en Chine. For assistance, visit www.Breville.com.

CAUTION:

www.Breville.com

This device is to be serviced only by properly qualified service personnel. Consult the service manual for

proper service procedures to assure continued compliance with the federal performance standard for

microwave ovens and for precautions to be taken to avoid possible exposure to excessive microwave energy.

WARNING:

only during service, service personnel. Do not contact the internal electrical parts while the

Certain internal parts are intentionally not grounded and may present a risk of electrical shock

serviceman to hazardous high-voltage potentials.

To ensure continued protection against shock hazard, connect to properly grounded outlets only.

Disconnect appliance before servicing. Removal of enclosure with product energized may expose

Not for build-in installation.

Risk of electric shock. Non-removable fasteners are provided because of internal high voltages.

Do not remove fasteners.

appliance is energized: Fan Motor and Turntable Motor.

USC - BSS Print to Match Black - Print Second

NOTE: These graphics must pass all the adhesion tests outlined on Sheet 1 of this artwork.

RESTRICTED & CONFIDENTIAL

PRODUCT GRAPHICS ARTWORK

ISSUE

DATE

BMO650-GRT-2019-V3 115-01-0195JOB TBA 19

NOT TO SCALE

Not for commercial use.

DO NOT ATTEMPT TO OPERATE THIS MICROWAVE OVEN WITH:

(A) OBJECT CAUGHT IN DOOR

(B) DOOR THAT DOES NOT CLOSE PROPERLY

RETURN TO BREVILLE PTY LTD

HEAD OFFICE Breville Building, Sydney Corporate Park Suite 2, 170-180 Bourke Road NSW, 2016 SYDNEY, AUSTRALIA

+ 5 hidden pages