Breville BFP400 User Manual

Breville Customer Service Centre
Australian Customers Mail: PO Box 22
Phone: 1300 139 798 Fax: (02) 9384 9601 Email:
Customer Service:
askus@breville.com.au
www.breville.com.au
Breville is a registered trademark of Breville Pty. Ltd. A.B.N. 98 000 092 928.
Due to continued product improvement, the products illustrated/photographed
in this brochure may vary slightly from the actual product.
Copyright Breville Pty. Ltd. 2010.
New Zealand Customers Mail: Private Bag 94411
Greenmount, Auckland NEW ZEALAND
Phone:
0800 273 845
Fax: 0800 288 513 Email:
Customer Service:
askus@breville.com.au
Model BFP400 Issue - A10
the Kitchen Wizz™
Instruction Booklet
BFP400
CONGRATULATIONS
on the purchase of your new Breville
Kitchen Wizz™
CONTENTS
4 Breville recommends safety first
7 Know your Breville Kitchen Wizz™
12 Before first use
14 Operating your Breville
Kitchen Wizz™
16 Basic food processing techniques
22 Food Processing Tips
24 Care & cleaning
26 Recipes
3
BREVILLE RECOMMENDS SAFETY FIRST
At Breville we are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind. In addition we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions.
IMPORTANT SAFEGUARDS
READ ALL INSTRUCTIONS BEFORE USE AND SAVE FOR FUTURE REFERENCE
• Carefully read all instructions before
operating the Breville Food Processor for the first time and save for future reference.
• Remove and safely discard any
packaging material and promotional labels before using the food processor for the first time.
• To eliminate a choking hazard for
young children, remove and safely discard the protective cover fitted to the power plug of this appliance.
• Do not place the food processor
near the edge of a bench or table during operation. Ensure the surface is level, clean and free of water and other substances.
• Do not use the food processor on a sink
drain board.
• Do not place the food processor on or
near a hot gas or electric burner, or where it could touch a heated oven.
• Handle the food processor and
attachments with care – remember the blades and discs are razor-sharp and should be kept out of the reach of children.
• Use the blade protector when storing
the processing blade.
• Always ensure the food processor is
completely assembled before operating. The appliance will not operate unless properly assembled.
• Ensure the Speed Selection dial is in
the Off position and the food processor is switched off at the power outlet and
the power cord is unplugged before attaching the processing blade, discs or processing lid.
• Always secure the processing bowl onto
the motor base before attaching the processing blade or discs.
• Always operate the food processor with
the processing lid in position.
• Do not push food into the food chute
with your fingers or other utensils. Always use the food pusher provided.
• Keep fingers, hands, knives and
other utensils away from moving blades and discs.
• Do not place hands or fingers into the
processing bowl of the food processor unless the motor, processing blade and discs have come to a complete stop. Ensure the Speed Selection dial is in the Off position and the appliance is switched off at the power outlet and the power cord is unplugged before removing the lid from the food processor bowl.
• Ensure the motor and blade or
discs have completely stopped fore disassembling. Ensure the Speed Selection Dial is in the Off position and the appliance is switched off at the power outlet and the power cord is unplugged from the power outlet before attempting to move the appliance, when not in use, if left unattended and before disassembling, cleaning or storing.
• Do not use attachments other than
those provided with the food processor.
• Do not attempt to operate the food
processor by any method other than those described in this booklet.
4
BREVILLE RECOMMENDS SAFETY FIRST
• Care should be taken when removing
the food from the processing bowl by ensuring the motor and the processing blade or disc, have completely stopped before disassembling. Ensure the Speed Selection Dial is turned to the Off position, the appliance is switched off at the power outlet and unplugged, before removing the lid from the bowl. The processing bowl should then be unlocked from the motor body and the processing blade or disc holder carefully removed before attempting to remove the processed food.
• Do not operate the food processor
continuously for periods longer than 3 minutes on any setting or if processing a heavy load. None of the recipes in this book should require processing for longer than 3 minutes and none are considered a heavy load. If the food processor is operated continuously for too long, it should be allowed to rest for 25-30 minutes before recommencing.
• Some stiff mixtures, such as dough, may
cause the dough blade to rotate more slowly than normal. In this unlikely event of an excessive load, do not operate the appliance continuously with excessive load for more than 1 minute.
• Do not process hot or boiling liquids –
allow liquids to cool before placing into the processing bowl.
• Do not move the food processor whilst
in operation.
• Do not leave the food processor
unattended when in use.
• Do not place any part of the food
processor in the dishwasher or microwave oven.
• Do not process thin fluids such as
water, milk, stock, juice, etc. above the 500ml level in the processing bowl as this could result in overflow. To reduce the risk of overflow, always add drier or thicker ingredients to the processing bowl prior to adding fluids.
• Do not place anything on top of the
food processor when the lid is on, when in use and when stored.
• Keep the food processor clean. Follow
the cleaning instructions provided in this book.
5
5
BREVILLE RECOMMENDS SAFETY FIRST
IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES
• Fully unwind the power cord before use.
• Do not let the power cord hand over
the edge of a bench or table, touch hot surfaces or become knotted.
• To protect against electric shock do not
immerse the power cord, power plug or motor base in water or any other liquid.
• The appliance is not intended for use
by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to
ensure that they do not play with the appliance.
• It is recommended to regularly inspect
the appliance. To avoid a hazard do not use the appliance if power cord, power plug or appliance becomes damaged in any way. Return the entire appliance to the nearest authorised Breville Service Centre for examination and/or repair.
• Any maintenance other than cleaning
should be performed at an authorised Breville Service Centre.
• This appliance is for household use
only. Do not use this appliance for anything other than its intended use. Do not use in moving vehicles or boats. Do not use outdoors. Misuse may cause injury.
• The installation of a residual current
device (safety switch is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice.
CAUTION
The processing blade and discs are extremely sharp, handle with care at all times. Do not place hands, knives, or other utensils into the food chute. Always use the food pusher to push the food down the food chute.
6
SAVE THESE INSTRUCTIONS
KNOW
your Breville Kitchen Wizz™
KNOW YOUR BREVILLE KITCHEN WIZZ™
F
G
C
B
A
E
D
A. Automatic Safety Locking System
- prevents food processor from operating unless the bowl and lid are correctly engaged on the motor base
B. 2.0L Processing bowl C. Processing Bowl Lid
8
D. Direct Drive Motor Base E. Speed Selection Dial F. Inner Measuring Cup G. Food Pusher
KNOW YOUR BREVILLE KITCHEN WIZZ™
H
L
I J K
M
O P
N
H. Slicing Disc I. Chipping Disc J. Shredding Disc K. Disc Holder L. Stainless Steel processing blade M. Processing blade protective
storage cover
N. Dough blade O. Whisk P. Spindle – supports processing blade,
dough hook and disc holder
Q. Spatula (not shown)
9
BEFORE FIRST USE
of your Breville Kitchen Wizz™
BEFORE FIRST USE
PREPARING THE FOOD PROCESSOR FOR USE
Remove and safely discard all packaging materials and promotional labels from your Breville Kitchen Wizz™. Wash the food processor bowl, lid and other attachments in warm soapy water using a mild detergent. Rinse and dry thoroughly. (Refer to Care & Cleaning section of this booklet.)
ATTACHING THE FOOD PROCESSOR BOWL
The food processor bowl and lid must be correctly assembled for the food processor to operate.
1. Place the motor base on a flat, dry surface
such as a bench top. Make sure that the motor base is turned off at the power outlet and the power cord is unplugged.
2. Place the processing bowl (with the
lid off) over the drive shaft and onto the motor base with the handle facing forward. Turn the processing bowl counter-clockwise to lock into position.
3. Insert the spindle into the food
processor bowl by placing it over the shaft in the centre of the bowl and rotating until it falls into place.
ASSEMBLING THE STAINLESS STEEL PROCESSING BLADE
1. Carefully remove the protective storage
cover from the processing blade.
2. Carefully Place the processing blade
over the centre of the spindle.
3. Release the processing blade so that it
drops to the bottom of the spindle and falls into place.
4. Place the food to be processed into the
processing bowl as indicated in the recipe.
11
BEFORE FIRST USE
ASSEMBLING THE STAINLESS STEEL SLICING/ SHREDDING/ CHIPPING DISCS
1. Carefully select the desired disc to be
used (slicing, shredding or chipping).
2. Slide the blade (sharp side facing up)
into the side grooves of disc holder. Continue to push the disc into place until it covers the 2 small black tabs in the centre of the disc holder.
3. Hold the disc by sliding your thumb and
index fingers into the holes of the disc holder. Place the assembled disc holder onto the spindle and release so that it falls into place.
ASSEMBLING THE DOUGH BLADE
1. Place the dough blade over the centre of
the spindle.
2. Release the dough blade so that it drops
to the bottom of the spindle and falls into place.
3. Place the food to be processed into the
processing bowl as indicated in the recipe.
ASSEMBLING THE WHISK
1. Place the whisk over the centre of
the spindle.
WARNING
The processing blade and the discs are extremely sharp. Use caution when handling and storing these parts.
12
2. Release the whisk so that it drops to the
bottom of the spindle and falls into place.
3. Place the food to be processed into the
processing bowl as indicated in the recipe.
BEFORE FIRST USE
ATTACHING THE LID
Attach the lid by placing it on the processing bowl ensuring the on the lid is aligned with the the bowl.
To lock the lid in place, hold the feed chute and turn the lid counter clockwise so the symbol on the lid aligns with the on the handle.
Ensure the lid is positioned securely. Insert the food pusher and measuring cup into position in the food chute.
NOTE
Ensure the spindle, blade, disc and disc holder are clean and free of food residue before attaching the lid.
symbol
symbol on
ALIGN
LOCK
symbol
OVERLOAD PROTECTION SYSTEM
The motor is protected from burning out by an automatic cut-out switch. If the Food Processor is overloaded or operated continuously for too long, the motor may overheat and stop. To operate the food processor again, you must switch off, unplug and allow to cool for approximately 30 minutes. Once the motor has fully cooled, it is ready for use again.
Some stiff mixtures, such as dough, may cause the dough blade to rotate more slowly than normal. In this unlikely event of an excessive load, do not operate the appliance continuously with excessive load for more than 1 minute.
If this occurs again, the processing bowl may be overloaded, so remove some of the food and process in smaller batches.
NOTE
The Food Processor is designed so the motor will not operate without the processing bowl and lid correctly locked into position. In the event that the food processor starts without the lid correctly locked into position, immediately disconnect at the power outlet and return to your local Breville Service Centre for examination.
NOTE
The food processor will not operate unless the processing bowl and lid are positioned correctly and locked into position.
13
OPERATING
your Breville Kitchen Wizz™
Loading...
+ 35 hidden pages