Breville BEM200 User Manual

Wizz™

Electronic Mixer

Instructions and Recipes

to suit all BEM200 models

Contents

Page

Introduction 3

Breville recommends safety first 4

Know your Breville Wizz™ Electronic Mixer 6

Assembly and operation of your Breville Wizz™ Electronic Mixer 7

Care, cleaning and storing 10

Measuring and weighing 12

Mixing guide 13

Recipes R1

Notes IBC

Congratulations

on the purchase of your new Breville Wizz™ Electronic Mixer

Breville recommends safety first

We at Breville are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer foremost in mind. In addition we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions:

IMPORTANT SAFEGUARDS FOR YOUR BREVILLE WIZZ™ ELECTRONIC MIXER

• Carefully read all instructions before operating

the appliance and save for future reference.

• Remove and safely discard any packaging

material and promotional labels before using the appliance for the first time.

• To eliminate a choking hazard for young children,

remove and safely discard the protective cover fitted to the power plug of this appliance.

• Do not place the mixer near the edge of a bench

or table during operation. Do not use the mixer on a sink drain board. Ensure the surface is level, clean and free of water and other substances. Vibration during operation may cause the appliance to move.

• Do not place this appliance on or near a hot

gas or electric burner, or where it could touch a heated oven.

• Always ensure the mixer is completely

assembled before operating. The appliance will not operate unless properly assembled.

• Ensure the Speed Control Dial is in the Off

position and the mixer is switched off at the power outlet and the power cord is unplugged before attaching the beaters or dough hooks.

• Do not use attachments other than those

provided with the mixer. Use only the beaters and dough hooks supplied with the mixer.

• In the unlikely event of an excessive load, do

not operate the appliance continuously with excessive load for more than 30 seconds. Please note that none of the recipes in this instruction book are considered a heavy load.

• Do not double the ingredients of the recipes as it

can damage the appliance.

• Handle the mixer and attachments with care.

Never place your fingers inside the mixing bowl or near the beaters or dough hooks during operation.

• Keep hands, hair, clothing, as well as, spatulas

and other utensils away from moving beaters or dough hooks during operation.

• Should an object such as a spoon or spatula fall

into the bowl while mixing, immediately ensure the Speed Control Dial is in the ‘Off’ position, turn the mixer off, unplug at the power outlet and remove the object.

• Do not place hands in the mixing bowl unless

the mixer is disconnected from the power outlet. Ensure the Speed Control Dial is in the ‘Off’ position, the mixer is switched off and unplugged from the power outlet before removing the beaters or dough hooks.

• Ensure the motor and beaters or dough hooks

have completely stopped before disassembling.

• Always remove the beaters or dough hooks from

the mixer before cleaning.

• Care should be taken when removing the food

from the mixer bowl by ensuring the motor and the beaters or dough hooks have completely stopped before disassembling. Ensure the Speed Control Dial is in the ‘OFF’ position, the appliance is switched off at the power outlet and unplugged before unlocking the Mixer Motor Head and moving into the upright position. The beaters and dough hooks should be released from the Mixer Motor Head before attempted to remove the processed food from the mixer bowl and the beaters or dough hooks.

Breville recommends safety first

• Ensure the Mixer Motor Head is locked into the

horizontal (closed) position when not in use and before storing.

• Always ensure the Speed Control Dial is in the

‘Off ’ position, the power is switched off at the power outlet and the power cord is unplugged from the power outlet before attempting to move the appliance, before assembling or disassembling the mixer, when the mixer is not in use and before cleaning or storing.

• Do not move the mixer whilst in operation.

• Do not leave the mixer unattended when in use.

• Do not place any part of the mixer in the

dishwasher or microwave oven.

• Keep the appliance clean. Follow the cleaning

instructions provided in this book.

IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES

• Unwind the power cord fully before use.

• Do not let the cord hang over the edge of a

bench or table, touch hot surfaces or become knotted.

• To protect against electric shock do not immerse

cord, plug or mixer in water or any other liquid.

• The appliance is not intended for use by persons

(including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that

they do not play with the appliance.

• Any maintenance other than cleaning should

be performed at an authorised Breville Service Centre.

• This appliance is for household use only. Do not

use this appliance for anything other than its intended use. Do not use in moving vehicles or boats. Do not use outdoors. Misuse may cause injury.

• The installation of a residual current device

(safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice.

• It is recommended to regularly inspect the

appliance. Do not use the appliance if power cord, power plug or appliance becomes damaged in any way. Return the entire appliance to the nearest authorised Breville Service Centre for examination and/or repair.

ENSURE THE SPEED CONTROL DIAL CONTROL IS IN THE ‘OFF’ POSITION, THE MIXER IS SWITCHED OFF AT THE POWER OUTLET AND UNPLUGGED FROM THE POWER OUTLET BEFORE ATTACHING THE BEATERS OR DOUGH HOOKS.

Know your Breville Wizz™ Electronic Mixer

Turbo button for extra burst of power

Mixer head

Eject button for release of beaters/dough hooks

Mixing beaters

Revolving turntable

Speed control

dial with 12

speed settings

Mixer

release

lever

Tilt back

locking

button

Mixer stand

Large 4.0L stainless steel mixing bowl

Small 1.8L

stainless steel

mixing bowl

Dough hooks

Assembly and operation of your Breville Wizz™ Electronic Mixer

Before first use

Before assembling your Breville Wizz™ Electronic Mixer, remove and safely discard any packaging material and promotional labels.

Ensure the Speed Control Dial is in the ‘OFF’ position and the appliance is switched off at the power outlet and the power cord is unplugged.

Wash the mixing bowls, beaters and dough hooks in warm, soapy water with a soft cloth. Rinse and dry thoroughly.

Mixing bowls may also be washed in the dishwasher.

When ﬁrst using your Breville Wizz™ Electronic Mixer, you may notice and odour coming from the motor. This is normal and will dissipate with use.

Assembling the mixer

1. Place the mixer stand on a level, dry surface

such as a bench top. Ensure the mixer stand is in the horizontal position.

Once the motor head is securely locked onto the mixer stand it can be tilted away from the bowl by pressing the tilt back locking button and lifting it back to a 45 degree angle.

Make sure the motor head is securely attached to the mixer stand before using. The mixer should not be used as a hand mixer. It must always be used on the stand.

Attach the revolving turntable

1. Attach the revolving turntable to the mixer

stand by fitting the revolving turntable into the socket corresponding to the size of the bowl selected (Fig 2). The turntable should spin around freely.

2. Attach the motor head to the mixer stand by

pressing and holding down the mixer release lever at the back of the mixer stand. Position the metal pin on the underside of the motor head to fit into the groove made when pressing down the mixer release lever [Fig 1). When the motor head is in position, release the lever.

Fig 1

Fig 2

Assembly and operation of your Breville Wizz™ Electronic Mixer

continued

Attaching the beaters

1. Attach the beaters by pressing the tilt back

locking button and lifting the motor head up until it stops (Fig 3).

Fig 3

2. Insert the beaters into the correct socket as

shown on the underside of the mixer head. The beaters should be inserted with a slight twisting action until they click firmly into place (Fig 4).

LEFT RIGHT

Attaching the dough hooks

1. Attach the dough hooks by pressing the tilt

back locking button and lifting the motor head up until is stops (Fig 5).

Fig 5

2. Insert the dough hooks into the correct socket

as shown on the underside of the mixer head. The dough hooks should be inserted with a slight twisting action until they click firmly into place.

It is important that the two dough hooks are fully inserted into their appropriate sockets or your Breville Wizz™ Electronic Mixer will not operate correctly.

Fig 4

It is important that the two beaters are fully inserted into their appropriate sockets or your Breville Wizz™ Electronic Mix will not operate correctly.

INSERT CORRECT BEATER

THE BEATERS / DOUGH HOOKS MUST BE INSERTED INTO THE CORRECT SOCKET AS THEY ARE NOT INTERCHANGEABLE AND INCORRECT INSERTION WILL RESULT IN DAMAGE.

Assembly and operation of your Breville Wizz™ Electronic Mixer

continued

Operating the mixer

1. Ensure that the speed control dial is set to the

‘OFF’ position and that the motor head is securely attached to the mixer stand before using.

2. Add ingredients to the mixing bowl supplied as

listed in the recipe.

3. Insert the power cord into a 230/240V power

outlet and switch the power ‘ON’. Commence mixing by turning the speed control dial clockwise. Always begin mixing at a lower speed setting to prevent splattering. Increase to the speed suited to the mixing task. The speed setting can be adjusted during operation by turning the dial forwards and back. Use the mixing guide as a reference, align the speed setting with the indicator arrow on the mixer, or between numbered settings.

4. Occasionally stop the mixer during operation

and scrape any food mixture down the sides of the mixing bowl with a spatula.

5. When mixing is complete, turn the speed

control dial to the ‘OFF’ position. Switch the appliance off at the power outlet and unplug the power cord.

Turbo boost function

Pressing the ‘Turbo’ button while mixing provides an extra burst of power, overriding the speed setting being used. Press the ‘Turbo’ button and hold it down for no more than 30 seconds to avoid overheating.

Always turn the Wizz™ Electronic Mixer ‘OFF’ if you need to scrape the bowl during use. Then continue mixing.

6. Press the ‘Tilt Back Locking’ button and tilt

motor head back on the mixer stand.

7. Remove the beaters/dough hooks by pressing

the eject button while grasping the shafts. The beaters/dough hooks will be released automatically. DO NOT try to pull the beaters/ dough hooks out of the sockets. Use a spatula to remove mixture from the beaters/dough hooks.

AVOID CONTACT WITH BEATERS/DOUGH HOOKS DURING OPERATION. KEEP HANDS, HAIR, CLOTHING, SPATULAS AND OTHER UTENSILS AWAY FROM BEATERS/DOUGH HOOKS TO PREVENT INJURY OR DAMAGE TO THE MIXER.

Care, cleaning and storing your Breville Wizz™ Electronic Mixer

Cleaning after use

1. Always ensure that the Speed Control Dial

is in the ‘OFF’ position and that the power is switched off at the power outlet. Then remove the power cord from the power outlet.

2. Eject the beaters/dough hooks from the mixer.

3. To remove the motor head for cleaning, press

the mixer release lever and lift the motor head from the mixer stand (Fig 6).

Fig 6

4. Wipe the motor head, mixer stand and

revolving turntable with a soft, damp cloth then dry thoroughly.

7. Do not allow the mixing bowls/beaters/dough

hooks to soak in water for an extended period of time, as this may damage the metal finish.

Do not use abrasive scouring pads or cleaners when cleaning the mixing bowls/ beaters/dough hooks as these may scratch the surface. Also ensure that the mixing bowls/beaters/dough hooks are not soaked in water for extended periods of time, i.e. for several hours or overnight, as this may damage the metal ﬁnish. Do not wash or soak the mixer stand in water or any other liquid. Clean with a damp soft cloth and dry thoroughly. Do not allow water or any liquid to

enter the gear system as damage may result.

5. Wipe any excess food particles from the

power cord.

6. Wash the mixing bowls, beaters and dough

hooks in warm soapy water with a soft clean cloth. Rinse and dry thoroughly. Mixing bowls may also be washed in a dishwasher.

NEVER IMMERSE THE MIXER, POWER CORD OR PLUG IN WATER OR ANY OTHER LIQUID.

Care, cleaning and storing your Breville Wizz™ Electronic Mixer

Storage

Your Breville Wizz™ Electronic Mixer should be kept in a convenient position on your kitchen bench top or in an accessible cupboard.

Always unplug your Breville Wizz™ Electronic Mixer from the power outlet before storing. Place the revolving turntable in the small bowl position. Store the mixing bowls on the turntable with the small bowl sitting in the large mixing bowl. Place the beaters and dough hooks inside the small bowl and lower the motor head into the horizontal position.

continued

+ 25 hidden pages