Brady BDCI5100 Users Manual

_______________________________________________________________________________

Brady BDCi5100 RFID Assembly

MANUFACTURER HEADQUARTERS:

Brady Worldwide, Inc.
6555 W Good Hope Road
Milwaukee, WI 53223 USA

_______________________________________________________________________________

Table of Content

1. Introduction ................................................................................................................................ 8

1.1 Description ......................................................................................................................... 8

1.2 Specification ....................................................................................................................... 9

2. Installation ............................................................................................................................... 10

2.1 Connections ..................................................................................................................... 11

3. Operation ................................................................................................................................. 12

List of Figures

Figure 1. Block Diagram of Brady BDCi5100 RFID Assembly and its Connection to a Host ........... 8

Figure 2. Photo of the Brady BDCi5100 RFID Assembly ............................................................... 10

List of Tables

Table 1. Specification of Brady BDCi5100 RFID Assembly ..................................................... 9

Table 2. CN1, CN2, CN3 .............................................................................................................. 11

Table 3. JST B10BPHDSS 10-Position Dual Row ................................................................... 11

_______________________________________________________________________________

Copyright

This manual is copyrighted with all rights reserved. No portion of this manual may be copied or
reproduced by any means without the prior written consent of BRADY Worldwide, Inc.

While every precaution has been taken in the preparation of this document, BRADY assumes no
liability to any party for any loss or damage caused by errors or omissions or by statements
resulting from negligence, accident, or any other cause. BRADY further assumes no liability
arising out of the application or use of any product or system described, herein; nor any liability
for incidental or consequential damages arising from the use of this document. BRADY
disclaims all warranties or merchantability of fitness for a particular purpose.

Trademarks

Brady BDCi5100 RFID Assembly is a trademark of BRADY Worldwide, Inc.
BRADY reserves the right to make changes without further notice to any product or system

described herein to improve reliability, function, or design.
© 2017 BRADY Worldwide, Inc. All Rights Reserved

Brady Worldwide Inc.
6555 West Good Hope Road
Milwaukee, WI 53223 U.S.A.
Telephone: [phone] USA Domestic
Facsimile: 414-438-6958

_______________________________________________________________________________

Agency Compliance and Approvals

For Users in the United States
FCC Notice-US Only

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:

(1) this device may not cause harmful interference,
(2) this device must accept any interference received, including interference that

may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit dif ferent from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV tech ni cian for help.

Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

Canada
ICES-003 Class A Notice, Class A

Industry Canada ICES-003: CAN ICES-3 (A)/NMB-3(A)

This device complies with Industry Canada license-exempt RSSs. Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the
device.